Desiccation Cracking Behavior of Clayey Soils Treated with Biocement and Bottom Ash Admixture during Wetting–Drying Cycles

Author(s):  
Mark Vail ◽  
Cheng Zhu ◽  
Chao-Sheng Tang ◽  
Nate Maute ◽  
Melissa Tababa Montalbo-Lomboy

Desiccation cracking considerably impairs the hydraulic and mechanical properties of clayey soils that are critical to the long-term performance of infrastructure foundations and earth structures. Typical crack remediation methods are associated with high labor and maintenance costs or the use of environmentally unfriendly chemicals. Recycling waste materials and developing biomediated techniques have emerged as green, sustainable soil stabilization solutions. The objective of this study was to investigate the feasibility of soil crack remediation through use of bottom ash admixtures and microbial-induced calcite precipitation (MICP). We carried out cyclic wetting–drying tests to characterize the effects of bottom ash and MICP on the desiccation cracking behaviors of bentonite soils. Two groups of soil samples that contained different percentages of bottom ash (0%, 20%, 40% by weight) were prepared for cyclic water and MICP treatments, respectively. The desiccation cracking patterns captured by a high-resolution camera were quantified using image processing. We also employed scanning electron microscopy for microstructural characterizations. Experimental results revealed that cyclic water treatment resulted in more cracking, whereas cyclic MICP treatment improved soil strength owing to the precipitation of calcite crystals on the soil particle surface and inside the interparticle pores. Adding bottom ash to bentonite reduced the plasticity of the mixture, promoted the flocculation of clay particles by cation exchange, and also provided soluble calcium to enhance calcite precipitation. This study demonstrates the potential of bottom ash and MICP for crack remediation and brings new insights into the design and assessment of sustainable infrastructures under climate changes.

Geosciences ◽  
2019 ◽  
Vol 9 (9) ◽  
pp. 385 ◽  
Author(s):  
Vail ◽  
Zhu ◽  
Tang ◽  
Anderson ◽  
Moroski ◽  
...  

This study aims to characterize the effect of microbial-induced calcite precipitation (MICP) on the desiccation cracking behaviors of compacted calcium bentonite soils. We prepare six groups of samples by mixing bentonites with deionized water, pure bacteria solution, pure cementation solution, and mixed bacteria and cementation solutions at three different percentages. We use an image processing tool to characterize the soil desiccation cracking patterns. Experimental results reveal the influences of fluid type and mixture percentage on the crack evolution and volumetric deformation of bentonite soils. MICP reactions effectively delay the crack initiation and remediate desiccation cracking, as reflected by the decreased geometrical descriptors of the crack pattern such as surface crack ratio. The mixture containing 50% bacteria and 50% cementation solutions maximizes the MICP treatment and works most effectively in lowering the soil cracking potential. This study provides new insights into the desiccation cracking of expansive clayey soils and shows the potential of MICP applications in the crack remediation.


2010 ◽  
Vol 114 (3-4) ◽  
pp. 261-266 ◽  
Author(s):  
Chao-Sheng Tang ◽  
Yu-Jun Cui ◽  
Anh-Minh Tang ◽  
Bin Shi

2016 ◽  
Vol 879 ◽  
pp. 838-842
Author(s):  
Han Yong Jeon

In this study, key properties of polyethylene resin and HDPE GM were tested for comparing their stress crack behaviors. Stress cracking time was differed from each type of resins and products. The failure times of ESCR test were too long compared to SP-NCTL's. The SP-NCTL results of RWOA was failed earlier than RWA‘s, GM1’s and GM2’s. But there was no difference between each sample of the results of ESCR test within short term testing duration. The ESCR test was influenced by stress relaxation during the test. The SP-NCTL test is reasonable for verifying stress cracking behavior and construction quality control. According to this study, ESCR test is not appropriate for determining the stress crack behavior, but SP-NCTL test is better test method for predicting the stress crack behaviors of HDPE GM.


2020 ◽  
Vol 264 ◽  
pp. 105389 ◽  
Author(s):  
Bo Liu ◽  
Cheng Zhu ◽  
Chao-Sheng Tang ◽  
Yue-Han Xie ◽  
Li-Yang Yin ◽  
...  

Polymers ◽  
2020 ◽  
Vol 12 (10) ◽  
pp. 2398
Author(s):  
Changqing Qi ◽  
Yuxia Bai ◽  
Jin Liu ◽  
Fan Bu ◽  
Debi Prasanna Kanungo ◽  
...  

There has been a growing interest in polymer applied for soil reinforcement in recent years. However, there little attention has been paid to the effects of polymer on soil cracking behavior, and cracks significantly change soil strength and hydraulic properties and alter reinforcement effectiveness. This study investigated the desiccation cracking behavior of polyurethane (PU) and polyacrylamide (PAM) admixed clayey soils with different polymer concentrations by performing desiccation cracking tests. Scanning electron microscope (SEM) observation was also carried out to obtain the internal structure of these soils. The results show that PU and PAM addition both prolonged the initial evaporation stage, accelerated later evaporation processes, and the effects were related to polymer concentration. Final cracks morphology analyses show that PAM addition slightly reduced the cracking and crushing degree and kept the soil relatively intact, while PU addition slightly enhanced the cracking and crushing degree of soil. In addition, PU and PAM addition both increased the width and length of cracks. The scanning electron microscopy (SEM) analyses show that the effects of polymer on soil evaporation and cracking could be concluded as: (1) storing water in voids, (2) influencing water immigration channel, (3) providing space for soil shrinkage, and (4) enhancing the connection between aggregates, which did not fully come into play because of the existence of hydrogel form. These achievements provide a certain basis for the research of desiccation cracking behavior of polymer treated soil and make significant sense for the safe and effective running of related projects.


Author(s):  
Jin-Jian Xu ◽  
Chao-Sheng Tang ◽  
Qing Cheng ◽  
Qi-liang Xu ◽  
Hilary I. Inyang ◽  
...  

One of the factors that affect the long term performance of a structure is the strength of the underlying soil strata. Presence of weak soil strata beneath the structure will affect the structural integrity. So, enhancing the engineering properties of the weak soil results in the betterment of bearing capacity of the soil. Nowadays, for improving the stability of the weak soil, various soil stabilization techniques are adopted. This paper presents an investigation of using alccofine as a soil stabilizing agent. Variation in shear strength parameters and compaction parameters of the soil is studied by adding different percentages of alccofine 1101 such as 1%, 2%, 3%, 4%, and 5%. Test results revealed that at the optimal rate of alccofine 1101, the shear strength characteristic is increased by 53.71% after a curing period of 3 days.


Author(s):  
Carl Malings ◽  
Rebecca Tanzer ◽  
Aliaksei Hauryliuk ◽  
Provat K. Saha ◽  
Allen L. Robinson ◽  
...  

2008 ◽  
Vol 56 (S 1) ◽  
Author(s):  
CC Badiu ◽  
W Eichinger ◽  
D Ruzicka ◽  
I Hettich ◽  
S Bleiziffer ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document