Time Required for Transmission of Time-Critical Air Traffic Control Messages in an En Route Environment

1993 ◽  
Vol 3 (4) ◽  
pp. 303-313 ◽  
Author(s):  
Kim M. Cardosi
1978 ◽  
Vol 31 (2) ◽  
pp. 259-267
Author(s):  
R. L. Ford

A recently completed preliminary long-term study of air traffic control systems in Europe1 suggests that traffic density is likely at least to double before the end of the century. The study also concludes that, apart from the problem of airport capacity, which was not considered, the existing ATC systems in Europe will not be able to cope with such an increase in traffic. There is therefore a need to consider methods of increasing the capacity of the European ATC system or providing a new system and, in view of the time required to effect significant changes to such systems, the task is becoming urgent.Assumingthere is to be no deterioration insafety, theprime requirements for any proposed changes are economy and flexibility. Apart from its obvious intrinsic value, economy is necessary because there is an increasing trend towards recovering the total cost of ATC from the user. Higher charges are therefore likely to stultify the growth in air transport and an underlying assumption is that this would be undesirable. Flexibility is required because traffic forecasts so far into the future are likely to be in error and the system design must allow for this because there is likely to be some economic penalty if the forecast proves to be either too high or too low.


1962 ◽  
Vol 15 (4) ◽  
pp. 387-396
Author(s):  
J. C. Cluley

A number of air traffic control authorities are now introducing electronic digital computers into air traffic control systems in order to speed operations and reduce the burden on controllers. These machines will initially be used for the routine clerical and data storage operations, but their full capabilities can only be used if they are given a much greater share of the control task and allowed to make logical decisions and intervene in the handling of the traffic. In such cases the computer will be performing a task that cannot be handed over to a human operator at a moment's notice in the event of a machine failure, and extreme reliability becomes probably the most important single attribute of a computer used in such a system.Although computers of adequate speed and capacity are being produced for commercial and scientific uses, with reliabilities sufficient for these purposes, the frequency of faults and the time required for routine maintenance are both far too large to permit their full-time use in an air traffic control system. The reliabilities of typical components and systems are discussed in the following section.1. The reliability of typical components and systems. The reports of a number of computer users suggest that ‘availabilities’ of 97–99 percent are readily attained, so that only 1–3 percent of the available working time is lost due to unscheduled maintenance.


2019 ◽  
Vol 9 (1) ◽  
pp. 2-11
Author(s):  
Marina Efthymiou ◽  
Frank Fichert ◽  
Olaf Lantzsch

Abstract. The paper examines the workload perceived by air traffic control officers (ATCOs) and pilots during continuous descent operations (CDOs), applying closed- and open-path procedures. CDOs reduce fuel consumption and noise emissions. Therefore, they are supported by airports as well as airlines. However, their use often depends on pilots asking for CDOs and controllers giving approval and directions. An adapted NASA Total Load Index (TLX) was used to measure the workload perception of ATCOs and pilots when applying CDOs at selected European airports. The main finding is that ATCOs’ workload increased when giving both closed- and open-path CDOs, which may have a negative impact on their willingness to apply CDOs. The main problem reported by pilots was insufficient distance-to-go information provided by ATCOs. The workload change is important when considering the use of CDOs.


2018 ◽  
Vol 8 (2) ◽  
pp. 100-111 ◽  
Author(s):  
Maik Friedrich ◽  
Christoph Möhlenbrink

Abstract. Owing to the different approaches for remote tower operation, a standardized set of indicators is needed to evaluate the technical implementations at a task performance level. One of the most influential factors for air traffic control is weather. This article describes the influence of weather metrics on remote tower operations and how to validate them against each other. Weather metrics are essential to the evaluation of different remote controller working positions. Therefore, weather metrics were identified as part of a validation at the Erfurt-Weimar Airport. Air traffic control officers observed weather events at the tower control working position and the remote control working position. The eight participating air traffic control officers answered time-synchronized questionnaires at both workplaces. The questionnaires addressed operationally relevant weather events in the aerodrome. The validation experiment targeted the air traffic control officer’s ability to categorize and judge the same weather event at different workplaces. The results show the potential of standardized indicators for the evaluation of performance and the importance of weather metrics in relation to other evaluation metrics.


Sign in / Sign up

Export Citation Format

Share Document