scholarly journals ELECTRONIC SWITCHING IN PYRANTHRONE THIN FILM

1975 ◽  
Vol 4 (5) ◽  
pp. 455-458
Author(s):  
Yoshiro Sakai ◽  
Yoshihiko Sadaoka
Keyword(s):  
Thin Film ◽  
Electronic Switching

scholarly journals Electrical read-out of light-induced spin transition in thin film spin crossover/graphene heterostructures

2021 ◽  
Author(s):  
Nikita Konstantinov ◽  
Arthur Tauzin ◽  
Ulrich Nguetchuissi Noumbé ◽  
Diana Dragoe ◽  
Bohdan Kundys ◽  
...  
Keyword(s):  
Thin Film ◽  
Spin Crossover ◽  
Spin Transition ◽  
Switching Device ◽  
Electronic Switching ◽  
Spin Transitions

An opto-electronic switching device made from an evaporated spin crossover thin film over a graphene sensor is presented. The electrical transduction of both temperature and light-induced reversible spin transitions are demonstrated.

Intrinsic electronic switching time in ultrathin epitaxial vanadium dioxide thin film

2013 ◽  
Vol 102 (7) ◽  
pp. 072106 ◽  
Author(s):  
Ayan Kar ◽  
Nikhil Shukla ◽  
Eugene Freeman ◽  
Hanjong Paik ◽  
Huichu Liu ◽  
...  
Keyword(s):  
Thin Film ◽  
Vanadium Dioxide ◽  
Switching Time ◽  
Electronic Switching

Publisher's Note: “Intrinsic electronic switching time in ultrathin epitaxial vanadium dioxide thin film” [Appl. Phys. Lett. 102, 072106 (2013)]

2013 ◽  
Vol 103 (12) ◽  
pp. 129904
Author(s):  
Ayan Kar ◽  
Nikhil Shukla ◽  
Eugene Freeman ◽  
Hanjong Paik ◽  
Huichu Liu ◽  
...  
Keyword(s):  
Thin Film ◽  
Vanadium Dioxide ◽  
Switching Time ◽  
Electronic Switching

ELECTRONIC SWITCHING IN DIBENZO-18-CROWN-6 THIN FILM

1975 ◽  
Vol 4 (4) ◽  
pp. 315-316
Author(s):  
Yoshiro Sakai ◽  
Yoshihiko Sadaoka
Keyword(s):  
Thin Film ◽  
Electronic Switching

Clean Electron Microscope Substrate Films Used for Micrometeorite Collection and Study

1967 ◽  
Vol 25 ◽  
pp. 366-367
Author(s):  
D. M. Davies ◽  
R. Kemner ◽  
E. F. Fullam
Keyword(s):  
Thin Film ◽  
Electron Microscope ◽  
High Altitude ◽  
Amyl Acetate ◽  
Temperature Variations ◽  
Film Forming ◽  
Film Specimen ◽  
Particulate Contaminants

All serious electron microscopists at one time or another have been concerned with the cleanliness and freedom from artifacts of thin film specimen support substrates. This is particularly important where there are relatively few particles of a sample to be found for study, as in the case of micrometeorite collections. For the deposition of such celestial garbage through the use of balloons, rockets, and aircraft, the thin film substrates must have not only all the attributes necessary for use in the electron microscope, but also be able to withstand rather wide temperature variations at high altitude, vibration and shock inherent in the collection vehicle's operation and occasionally an unscheduled violent landing.Nitrocellulose has been selected as a film forming material that meets these requirements yet lends itself to a relatively simple clean-up procedure to remove particulate contaminants. A 1% nitrocellulose solution is prepared by dissolving “Parlodion” in redistilled amyl acetate from which all moisture has been removed.

Microtomy of spherical Al2O3 powders

1983 ◽  
Vol 41 ◽  
pp. 74-75
Author(s):  
E.J. Jenkins ◽  
D.S. Tucker ◽  
J.J. Hren
Keyword(s):  
Thin Film ◽  
Size Range ◽  
Particle Aggregation ◽  
Ion Milling ◽  
Thin Sections ◽  
Α Phase ◽  
Convenient Means ◽  
Van Der Waals Attraction ◽  
Negative Feature ◽  
Film Substrate

The size range of mineral and ceramic particles of one to a few microns is awkward to prepare for examination by TEM. Electrons can be transmitted through smaller particles directly and larger particles can be thinned by crushing and dispersion onto a substrate or by embedding in a film followed by ion milling. Attempts at dispersion onto a thin film substrate often result in particle aggregation by van der Waals attraction. In the present work we studied 1-10 μm diameter Al2O3 spheres which were transformed from the amprphous state to the stable α phase.After the appropriate heat treatment, the spherical powders were embedded in as high a density as practicable in a hard EPON, and then microtomed into thin sections. There are several advantages to this method. Obviously, this is a rapid and convenient means to study the microstructure of serial slices. EDS, ELS, and diffraction studies are also considerably more informative. Furthermore, confidence in sampling reliability is considerably enhanced. The major negative feature is some distortion of the microstructure inherent to the microtoming operation; however, this appears to have been surprisingly small. The details of the method and some typical results follow.

Studies on Water in the Hydration Chamber of a Modified Electron Microscope

1970 ◽  
Vol 28 ◽  
pp. 544-545
Author(s):  
R. C. Moretz ◽  
G. G. Hausner ◽  
D. F. Parsons
Keyword(s):  
Thin Film ◽  
Thin Films ◽  
Electron Microscope ◽  
Steady State ◽  
Room Temperature ◽  
Small Mass ◽  
Equilibrium Pressure ◽  
Biological Objects ◽  
Mechanical Pump ◽  
Differential Pumping

Use of the electron microscope to examine wet objects is possible due to the small mass thickness of the equilibrium pressure of water vapor at room temperature. Previous attempts to examine hydrated biological objects and water itself used a chamber consisting of two small apertures sealed by two thin films. Extensive work in our laboratory showed that such films have an 80% failure rate when wet. Using the principle of differential pumping of the microscope column, we can use open apertures in place of thin film windows.Fig. 1 shows the modified Siemens la specimen chamber with the connections to the water supply and the auxiliary pumping station. A mechanical pump is connected to the vapor supply via a 100μ aperture to maintain steady-state conditions.

Imaging of platinum-shadowed macromolecular complexes in dark field

1984 ◽  
Vol 42 ◽  
pp. 146-147
Author(s):  
D.W. Andrews ◽  
F.P. Ottensmeyer
Keyword(s):  
Thin Film ◽  
Three Dimensional ◽  
Average Diameter ◽  
Dark Field ◽  
Bright Field ◽  
Field Mode ◽  
Macromolecular Complexes ◽  
Average Mass ◽  
Topological Features ◽  
Projection Images

Shadowing with heavy metals has been used for many years to enhance the topological features of biological macromolecular complexes. The three dimensional features present in directionaly shadowed specimens often simplifies interpretation of projection images provided by other techniques. One difficulty with the method is the relatively large amount of metal used to achieve sufficient contrast in bright field images. Thick shadow films are undesirable because they decrease resolution due to an increased tendency for microcrystalline aggregates to form, because decoration artefacts become more severe and increased cap thickness makes estimation of dimensions more uncertain.The large increase in contrast provided by the dark field mode of imaging allows the use of shadow replicas with a much lower average mass thickness. To form the images in Fig. 1, latex spheres of 0.087 μ average diameter were unidirectionally shadowed with platinum carbon (Pt-C) and a thin film of carbon was indirectly evaporated on the specimen as a support.

Reaction couples of ceramic thin films prepared by CVD

1988 ◽  
Vol 46 ◽  
pp. 798-799
Author(s):  
D.W. Susnitzky ◽  
S.R. Summerfelt ◽  
C.B. Carter
Keyword(s):  
Thin Film ◽  
Vapor Deposition ◽  
Chemical Vapor ◽  
Deposition Process ◽  
Solid State Reactions ◽  
Spatial Distributions ◽  
Diffusion Couples ◽  
Kinetics Studies ◽  
Ceramic Thin Films ◽  
Initial Stage

Solid-state reactions have traditionally been studied in the form of diffusion couples. This ‘bulk’ approach has been modified, for the specific case of the reaction between NiO and Al2O3, by growing NiAl2O4 (spinel) from electron-transparent Al2O3 TEM foils which had been exposed to NiO vapor at 1415°C. This latter ‘thin-film’ approach has been used to characterize the initial stage of spinel formation and to produce clean phase boundaries since further TEM preparation is not required after the reaction is completed. The present study demonstrates that chemical-vapor deposition (CVD) can be used to deposit NiO particles, with controlled size and spatial distributions, onto Al2O3 TEM specimens. Chemical reactions do not occur during the deposition process, since CVD is a relatively low-temperature technique, and thus the NiO-Al2O3 interface can be characterized. Moreover, a series of annealing treatments can be performed on the same sample which allows both Ni0-NiAl2O4 and NiAl2O4-Al2O3 interfaces to be characterized and which therefore makes this technique amenable to kinetics studies of thin-film reactions.

Sign in / Sign up

Export Citation Format

Share Document