High-Voltage Cable Sheath Induced Voltage and Circulation Current Analysis

2019 ◽  
Vol 08 (03) ◽  
pp. 94-101
Author(s):  
向东 朱
2018 ◽  
Vol 171 ◽  
pp. 02005
Author(s):  
M. Nassereddine ◽  
J. Rizk ◽  
M. Nagrial ◽  
A. Hellany ◽  
N. Moubayed ◽  
...  

High voltage (HV) infrastructures market is growing due to the corresponding growth in industries and population. To ensure continuous and reliable electrical power supply, existing substation and transmission lines are being upgraded to accommodate the additional load requirements. These upgrades involve up-rating the existing transmission lines or the installation of new lines. To save on easement cost and reduce the environmental impacts, transmission lines are occupied the same easement or path. This parallel option introduces the risk of induced voltage which could reach an unsafe condition and jeopardize the safety of works and people. This paper analysis and highlight the hidden risk associated with two parallel transmission lines that connected the same high voltage substation. The theoretical study which is supported by the case study shows the high risk potential tempering with the OHEW on the isolated circuit while the other one is still energized


Author(s):  
Ty Nguen

The results of modeling the effects of a high-voltage cable with cross-linked polyethylene insulation on adjacent power lines are presented. The calculations of the induced voltage on the adjacent voltage line were performed for five modes of operation of the 110 kV cable: symmetric and four unbalanced, caused by short circuits between the conductors, as well as between the conductors and the screen.


2015 ◽  
Vol 781 ◽  
pp. 418-421
Author(s):  
Chalermpol Reaungepattanawiwat ◽  
Yutthana Kanthaphayao

This paper presents a high voltage gain of a DC-DC converter. The proposed system consists of voltage multiplier circuits and a coupled inductor of a boost DC-DC converter. The input voltage of the voltage multiplier circuit is the induced voltage of inductor at a boost DC-DC converter. The field programmable gate array (FGPA) is used for generating the control signal of the proposed system. To verify the proposed circuit, an experiment was conducted from the prototype circuit. The proposed circuit can step-up the voltage with high voltage gain. Moreover, the voltage across the switch is very low.


2015 ◽  
Vol 16 (2) ◽  
pp. 131-139
Author(s):  
Mohamad Nassereddine ◽  
Jamal Rizk ◽  
Mahmood Nagrial ◽  
Ali Hellany

Abstract High-voltage infrastructure upgrade is expending due to the growth in populations. To save on easement cost and to reduce the environmental impact of these projects, HV transmission lines occupy the same easement as pipelines in many cases. This joint easement introduces the AC interference between transmission lines and pipelines. The induced voltage can reach a limit which will jeopardize the human safety. The cited research studies the induced voltage under the presence of the overhead earth wire (OHEW) using the shielding factor. The work in this paper studies the induced voltage using the OHEW section current along with the superposition theorem. The simulations are compared to the existing research methods. The case study along with the theoretical study discusses the advance accuracy of the proposed method over the existing shield factor used in the presence research. Furthermore, they introduce the effective length along with the effective shielding factor, which aids in computing the additional effect that the OHEW has on the induced voltage.


2015 ◽  
Vol 734 ◽  
pp. 109-112
Author(s):  
Jia Song ◽  
Xiao Dong Zhang ◽  
Yue Jia Sun

The traditional high-voltage electroscope is difficult to distinguish normal catenary voltage and induced voltage. In order to solve the problem, a method to measure high-voltage based on the effect of space electric field is proposed and a dedicated catenary voltage measuring device is made. The method follows divider effect of spatial capacitance and achieves quantitative voltage measurement without grounding by measuring and transforming the induced voltage difference of the capacitance which is placed between the catenary system and the earth and showing the actual catenary voltage value in LCD. The device can effectively distinguish catenary normal voltage and induced voltage, then reflects catenary real operation state. The field test results show the device meets the requirement of catenary voltage measurement.


Sign in / Sign up

Export Citation Format

Share Document