scholarly journals Reduction of seismic pounding effects of base-isolated RC highway bridges using MR damper

2012 ◽  
Vol 41 (6) ◽  
pp. 791-803 ◽  
Author(s):  
M.N. Sheikh ◽  
J. Xiong ◽  
W.H. Li
2013 ◽  
Vol 574 ◽  
pp. 53-65 ◽  
Author(s):  
Yong Li ◽  
Liang Zhao ◽  
Hang Sun ◽  
Jing Bo Liu

The main girder and the piers of bridges are generally linked with sliding bearings. Under seismic excitation, pounding effects between the main girder and the abutment, the adjacent girder and the blocking device caused by excessive relative displacements between piers, abutments and the girder are highly probable. The effects can not only damage the structure but also lead to collapsing. Based on a continuous viaduct, the paper studied the disciplines of the pounding response under uniform seismic excitation and the spatial seismic excitation, then put forward that the composite metal damper may reduce the effect of pounding. The research shows that under same seismic intensity, the results, including pounding force, the shear force of the fixed bearings and the plastic hinge on the piers, are amplified under multi-point excitation than under uniform excitation. And composite metal dampers can reduce the seismic responds under frequent earthquakes and prevent or largely reduce the pounding effect under severe earthquakes. Therefore the effect of pounding on the dynamic performance can be lessened. The seismic reduction is widely and well-adapted under both uniform excitation and multi-point excitation.


2016 ◽  
Vol 24 (7) ◽  
pp. 1300-1321 ◽  
Author(s):  
Mohsen Amjadian ◽  
Afshin Kalantari ◽  
Anil K Agrawal

It has been observed from failures of highway bridges during major earthquakes that skew bridges are among the most vulnerable to seismic loading. It has been shown that the coupling between the translational motions of the deck and the collision of the deck with the abutments are two major factors influencing the vulnerability of skew bridges. This paper studies the influence of deck–abutment collision (seismic pounding) on the coupled motions of decks of skew bridges during strong earthquakes using an analytical approach. A three-degree-of-freedom model is presented to study key dynamic features of skew bridges. It is assumed that the deck of the model is rigid and the columns remain elastic during the ground motion. Contact planes between the deck and the abutments are idealized by several contact points pairwise arrayed at the end-span expansion joints. The mechanism of energy absorption and dissipation during the contact duration is simulated through the implementation of a nonlinear contact element between the contact points. A parametric study has been carried out by varying different parameters, including the skew angle (β), the size of the gap between the deck and the abutments at the end-span expansion joints (gap), and the normalized stiffness eccentricity along the x-axis ( ex/ r). The results of this study show that the transverse displacements of acute corners of the deck and the rotation of the deck about the mass center noticeably increase with the increases of β and ex/ r, and with the decrease of the gap.


PCI Journal ◽  
1984 ◽  
Vol 29 (3) ◽  
pp. 44-73 ◽  
Author(s):  
Harold J. Jobse ◽  
Saad E. Moustafa

PCI Journal ◽  
2004 ◽  
Vol 49 (1) ◽  
pp. 92-104 ◽  
Author(s):  
Nabil F. Grace ◽  
S. B. Singh ◽  
Mina M. Shinouda ◽  
Sunup S. Mathew

Author(s):  
Arthur Mereles ◽  
Marcus Varanis ◽  
José Manoel Balthazar ◽  
Angelo Marcelo Tusset

2006 ◽  
Vol 92 (8) ◽  
pp. 26-33 ◽  
Author(s):  
Ichiro Okura ◽  
Syogo Osawa ◽  
Masakazu Takeno ◽  
Nobuyasu Hagisawa ◽  
Toshiyuki Ishikawa
Keyword(s):  

Author(s):  
Ralph Alan Dusseau

The results of a study funded by the U.S. Geological Survey as part of the National Earthquake Hazards Reduction Program are presented. The first objective of this study was the development of a database for all 211 highway bridges along I-55 in the New Madrid region of southeastern Missouri. Profiles for five key dimension parameters (which are stored in the database) were developed, and the results for concrete highway bridges are presented. The second objective was to perform field ambient vibration analyses on 25 typical highway bridge spans along the I-55 corridor to determine the fundamental vertical and lateral frequencies of the bridge spans measured. These 25 spans included six reinforced concrete slab spans and two reinforced concrete box-girder spans. The third objective was to use these bridge frequency results in conjunction with the dimension parameters stored in the database to develop empirical formulas for estimating bridge fundamental natural frequencies. These formulas were applied to all 211 Interstate highway bridges in southeastern Missouri. Profiles for both fundamental vertical and lateral frequencies were then developed, and the results for concrete highway bridges are presented.


Sign in / Sign up

Export Citation Format

Share Document