Study for Magnetically Controlled Heat Transport Device with Axial Rotation.

We experimentally measured the heat-transport characteristics of a bubble-driven heat-transport device. The device consisted of a non-looped copper tube containing water. The tube was either meandered or spiraled to form tube bundles. The inner surface of the tube was smooth and its diameter small enough to enable the formation of vapor and liquid plugs in it. Two copper blocks were attached to the tube bundles, one as a heating block and the other as a cooling block. In the experiment, most of the wall temperatures measured on the tube fluctuated periodically at a quasi-steady state. Time-averaged temperature gradients between the heating and cooling sections of the device were constant. By increasing heater input from 300W to 350W, the amplitude of the temperature fluctuations decreased and the temperature gradients increased significantly. This behavior was regarded as a transition to critical heat transport condition. The effective thermal conductivity of the device was proportional to the heat-transport rate but did not depend on the formation of the tube bundle and the gravity effect. The temperature fluctuations had specific peak frequencies and a positive correlation was found between the frequency and effective thermal conductivity. These experimental results strongly suggest that the main heat-transport mechanism of the investigated device is based on the oscillation-induced transport of sensible heat.

Download Full-text

Micro-Scale Two-Phase Flow Heat Transport Device Driven by Electrohydrodynamic Conduction Pumping

Volume 2: Heat Transfer Enhancement for Practical Applications; Heat and Mass Transfer in Fire and Combustion; Heat Transfer in Multiphase Systems; Heat and Mass Transfer in Biotechnology ◽

10.1115/ht2013-17196 ◽

2013 ◽

Author(s):

Viral K. Patel ◽

Jamal Seyed-Yagoobi

Keyword(s):

Heat Transport ◽

Two Phase Flow ◽

Operating Conditions ◽

Electrode Spacing ◽

Working Fluid ◽

Phase Flow ◽

Two Phase ◽

Micro Scale ◽

Flow Heat ◽

Transport Device

Micro-scale two-phase flow heat transport involves specialized devices that are used to remove large amounts of heat from small surface areas. They operate by circulating a working fluid through a heated space which causes phase change from liquid to vapor. During this process, a significant amount of heat is transported away from the heat source. Micro-scale heat transport devices are compact in size and the heat transfer coefficient can be orders of magnitude higher than in macro-scale for similar operating conditions. Thus, it is of interest to develop such devices for cooling of next-generation electronics and other applications with extremely large heat fluxes. The heat transport device presented in this paper is driven by electrohydrodynamic (EHD) conduction pumping. In EHD conduction pumping, when an electric field is applied to a dielectric liquid, flow is induced. The pump is installed in a two-phase flow loop and has a circular 1 mm diameter cross section with electrode spacing on the order of 120 μm. It acts to circulate the fluid in the loop and has a simple yet robust, non-mechanical design. Results from two-phase flow experiments show that it is easily controlled and such electrically driven pumps can effectively be used in heat transport systems.

Download Full-text