scholarly journals Comparison Between Conventional Design and Cathode Gas Recirculation Design of a Direct-Syngas Solid Oxide Fuel Cell–Gas Turbine Hybrid Systems Part I: Design Performance

2017 ◽  
Vol 6 (2) ◽  
pp. 127 ◽  
Author(s):  
Vahid Azami ◽  
Mortaza Yari
Keyword(s):  
Fuel Cell ◽  
Solid Oxide Fuel Cell ◽  
Gas Turbine ◽  
Hybrid System ◽  
Solid Oxide ◽  
Inlet Temperature ◽  
Oxide Fuel ◽  
Air Preheater ◽  
Energy And Exergy ◽  
Gas Recirculation

In this paper, a conventional SOFC–GT hybrid system and an SOFC–GT hybrid system with cathode gas recirculation system fuelled with syngas as the main source of energy were analyzed and their performances were compared. In the conventional SOFC–GT hybrid system the incoming air to the cathode is heated at the air recuperator and air preheater to meet the required cathode inlet temperature while in the SOFC–GT hybrid system with cathode gas recirculation, in addition to the air recuperator and air preheater, also the recirculation of the cathode exhaust gas is used to meet the required cathode inlet temperature. The system performances have been analyzed by means of models developed with the computer program Cycle–Tempo. A complete model of the SOFC–GT hybrid system with these two configurations evaluated in terms of energy and exergy efficiencies and their performance characteristics were compared. Simulation results show that the electrical energy and exergy efficiencies achieved in the cathode gas recirculation plant (64.76% and 66.28%, respectively) are significantly higher than those obtained in the conventional plant (54.53% and 55.8%).Keywords: Solid oxide fuel cell, Gas turbine, Cathode gas recirculation, Exergy.Article History: Received Feb 23rd 2017; Received in revised form May 26th 2017; Accepted June 1st 2017; Available onlineHow to Cite This Article: Azami, V, and Yari, M. (2017) Comparison between conventional design and cathode gas recirculation design of a direct-syngas solid oxide fuel cell–gas turbine hybrid systems part I: Design performance. International Journal of Renewable Energy Develeopment, 6(2), 127-136.https://doi.org/10.14710/ijred.6.2.127-136

Thermodynamic Performance of a Gas Turbine Plant Combined With a Solid Oxide Fuel Cell

2008 ◽  
Author(s):  
Yousef Haseli ◽  
Ibrahim Dincer ◽  
Greg F. Naterer
Keyword(s):  
Fuel Cell ◽  
Solid Oxide Fuel Cell ◽  
Gas Turbine ◽  
Compression Ratio ◽  
Solid Oxide ◽  
Specific Power ◽  
Inlet Temperature ◽  
Oxide Fuel ◽  
Turbine Inlet Temperature ◽  
Energy And Exergy

This paper undertakes a thermodynamic analysis of a high-temperature solid oxide fuel cell, combined with a conventional recuperative gas turbine. In the analysis the balance equations for mass, energy and exergy for the system as a whole and its components are written, and both energy and exergy efficiencies are studied for comparison purposes. These results are also verified with data available in the literature for typical operating conditions, the predictive model of the system is validated. The energy efficiency of the integrated cycle is obtained to be as high as 60.55% at the optimum compression ratio. These model findings indicate the influence of different parameters on the performance of the cycle and irreversibilities therein, with respect to the exergy destruction rate and/or entropy generation rate. The results show that a higher ambient temperature would lead to lower energy and exergy efficiencies, and lower net specific power. Furthermore, the results indicate that increasing the turbine inlet temperature results in decreasing both the energy and exergy efficiencies of the cycle, whereas it improves the total specific power output. However, an increase in either the turbine inlet temperature or compression ratio leads to a higher rate of irreversibility within the plant. It is shown that the combustor and SOFC contribute predominantly to the total irreversibility of the system; about 60 percent of which takes place in these components at a typical operating condition, with 31.4% for the combustor and 27.9% for the SOFC.

Safety Analysis of a Solid Oxide Fuel Cell/Gas Turbine Hybrid System Fueled With Gasified Biomass

2015 ◽  
Vol 12 (1) ◽  
Author(s):  
Xiaojing Lv ◽  
Chaohao Lu ◽  
Xinjian Zhu ◽  
Yiwu Weng
Keyword(s):  
Fuel Cell ◽  
Solid Oxide Fuel Cell ◽  
Gas Turbine ◽  
Hybrid System ◽  
Safety Performance ◽  
Solid Oxide ◽  
The Other ◽  
Inlet Temperature ◽  
Oxide Fuel ◽  
Compressor Surge

The effect of biomass gas on the safety performance of a solid oxide fuel cell (SOFC)/micro gas turbine (GT) hybrid system was studied with consideration of the fuel cell working temperature, fuel cell temperature gradient requirement, compressor surge zone, and turbine inlet temperature (TIT). The safety performance of the hybrid system on the design condition and off-design condition was also analyzed. Results show that the hybrid system is good adaptability to low concentrations of biomass gas. The electrical efficiency could reach 50% with different biomass gases and is higher than the other combined power systems that used biomass gas. The wood chip gas (WCG) would make the fuel cell or GT easier overheat than the other three gases. The cotton wood gas (CWG) and corn stalk gas (CSG) are easy to cause the TIT too low or the compressor surge. In the safety zone, considering the hybrid system load adjustment range, the effecting order (from large to small, following is same) is WCG, grape seed gas (GSG), CSG, and CWG. Considering the hybrid system electric efficiency, the effecting order is WCG, GSG, CWG, and CSG.

Design and Performance Study of a Solid Oxide Fuel Cell and Gas Turbine Hybrid System Applied in Combined Cooling, Heating, and Power System

2012 ◽  
Vol 138 (4) ◽  
pp. 205-214 ◽  
Author(s):  
Hsiao-Wei D. Chiang ◽  
Chih-Neng Hsu ◽  
Wu-Bin Huang ◽  
Chien-Hsiung Lee ◽  
Wei-Ping Huang ◽  
...  
Keyword(s):  
Fuel Cell ◽  
Power System ◽  
Solid Oxide Fuel Cell ◽  
Gas Turbine ◽  
Hybrid System ◽  
Solid Oxide ◽  
Oxide Fuel ◽  
Performance Study ◽  
And Performance ◽  
Combined Cooling

System Configuration and Performance Studies of Solid Oxide Fuel Cell -Gas Turbine Hybrid Cycle

2007 ◽  
Author(s):  
Wei Jiang ◽  
Ruxian Fang ◽  
Jamil A. Khan ◽  
Roger A. Dougal
Keyword(s):  
Fuel Cell ◽  
Power Plant ◽  
Solid Oxide Fuel Cell ◽  
Gas Turbine ◽  
Finite Volume ◽  
Hybrid System ◽  
High Energy ◽  
Solid Oxide ◽  
Oxide Fuel ◽  
Hybrid Cycle

Fuel Cell is widely regarded as a potential alternative in the electric utility due to its distinct advantages of high energy conversion efficiency, low environmental impact and flexible uses of fuel types. In this paper we demonstrate the enhancement of thermal efficiency and power density of the power plant system by incorporating a hybrid cycle of Solid Oxide Fuel Cell (SOFC) and gas turbine with appropriate configurations. In this paper, a hybrid system composed of SOFC, gas turbine, compressor and high temperature heat exchanger is developed and simulated in the Virtual Test Bed (VTB) computational environment. The one-dimensional tubular SOFC model is based on the electrochemical and thermal modeling, accounting for the voltage losses and temperature dynamics. The single cell is discretized using a finite volume method where all the governing equations are solved for each finite volume. Simulation results show that the SOFC-GT hybrid system could achieve a 70% total electrical efficiency (LHV) and an electrical power output of 853KW, around 30% of which is produced by the power turbine. Two conventional power plant systems, i.e. gas turbine recuperative cycle and pure Fuel Cell power cycle, are also simulated for the performance comparison to validate the improved performance of Fuel Cell/Gas Turbine hybrid system. Finally, the dynamic behavior of the hybrid system is presented and analyzed based on the system simulation.

Sign in / Sign up

Export Citation Format

Share Document