Influence of Aggregate Source and Warm-Mix Technologies on the Mechanical Properties of Asphalt Mixtures

2013 ◽  
Vol 2 (1) ◽  
pp. 20130072 ◽  
Author(s):  
Taha A. Ahmed ◽  
Elie Y. Hajj ◽  
Peter E. Sebaaly ◽  
Nate Majerus
Keyword(s):  
Mechanical Properties ◽  
Asphalt Mixtures

scholarly journals The Effect of Ageing on Chemical and Mechanical Properties of Asphalt Mortar

2018 ◽  
Vol 8 (11) ◽  
pp. 2231 ◽  
Author(s):  
Ruxin Jing ◽  
Xueyan Liu ◽  
Aikaterini Varveri ◽  
Athanasios Scarpas ◽  
Sandra Erkens
Keyword(s):  
Mechanical Properties ◽  
Asphalt Mixtures ◽  
Pavement Performance ◽  
Frequency Sweep ◽  
Carbonyl Index ◽  
Mineral Particles ◽  
Tension Tests ◽  
Ftir Spectrometry ◽  
Diffusion Paths ◽  
Asphalt Mortar

Asphalt mortar is a mixture of bitumen, filler, and sand. Mortar plays an important role in asphalt mixtures as it serves as the adhesive between the coarser aggregates. Due to the effect of bitumen ageing, the chemical and mechanical properties of asphalt mortar evolve with time. The mortar becomes more brittle and prone to cracking, thus leading to inferior pavement performance. In this study, Fourier transform infrared (FTIR) spectrometry was used to quantify changes in the chemical functional groups related to ageing and to calculate the carbonyl and sulfoxide indices. In addition, frequency sweep tests and uniaxial tension tests were performed by means of dynamic shear rheometer (DSR) tests to determine evolution of the stiffness and strength due to ageing. Two different oven ageing protocols were used to evaluate the effect of fine mineral particles on bitumen ageing. The protocols differed with respect to the order of ageing and mixing of the constituents. The results showed that both the chemical and mechanical properties of mortars significantly changed with ageing. Specifically, the carbonyl index, stiffness, and strength of the mortar increased. Under the same ageing conditions, a higher ageing level was observed for mortars produced by first mixing and then ageing compared to the mortars produced by mixing aged bitumen with filler and sand. This could be due to the presence of sand and filler particles, which resulted in an increased length of diffusion paths and consequently a slower ageing process.

scholarly journals Evaluation of Short-Term Aging Protocol for Asphalt Mixtures

2019 ◽  
Vol 9 (14) ◽  
pp. 2783 ◽  
Author(s):  
Sirin ◽  
Paul ◽  
Kassem ◽  
Ohiduzzaman
Keyword(s):  
Mechanical Properties ◽  
Asphalt Pavement ◽  
Road Construction ◽  
Asphalt Mixtures ◽  
Pavement Performance ◽  
Design Stage ◽  
Construction Site ◽  
Short Term ◽  
Compaction Processes

Asphalt mixtures are subjected to short-term aging during the production, placement, and compaction processes. Proper evaluation of asphalt pavement performance relies on the accurate characterization of asphalt mixtures during the design stage. In this study, three different loose asphalt mixtures often used in Qatar were evaluated to develop a laboratory short-term aging procedure. Sample mixtures 1 and 3 were collected from a construction site, while mixture 2 was obtained from an asphalt plant. Virgin aggregates and binders were also collected to reproduce the mixtures in the laboratory. Laboratory-produced mixtures were conditioned at 135 °C using various time durations. The mechanical properties of laboratory-produced mixtures were compared to those of mixtures produced on site. The results of the mechanical and binder testing demonstrated that the proper short-term aging protocol for asphalt mixtures often used in road construction in the State of Qatar would involve heating asphalt mixtures for 4 h at 135 °C before laboratory compaction.

scholarly journals Impact of Preheating Temperatures and RAP Characteristics on the Activation of RAP Binder

2020 ◽  
Vol 10 (23) ◽  
pp. 8378
Author(s):  
Yifu Meng ◽  
Liping Liu
Keyword(s):  
Mechanical Properties ◽  
Asphalt Pavement ◽  
Asphalt Mixtures ◽  
Reclaimed Asphalt Pavement ◽  
Reclaimed Asphalt ◽  
Central Plant ◽  
Preheating Temperature

Reclaimed asphalt pavement (RAP) is preheated to 120 °C or lower in hot central plant recycling due to specification and equipment limitations. However, the insufficient activation of reclaimed asphalt (RA) caused by low preheating temperature may affect the final properties of reclaimed asphalt mixtures (RAM) and lead to insufficient utilization of RA binder. This study evaluated the influence of preheating temperature and aging of RA binder on binder activation by producing specimens with 100% RAP. The volumetric and mechanical properties of specimens were analyzed to reflect the effect of activation. The results indicate that preheating temperature has a significant impact on the activation of RA binder. Regardless of the source of RAP, RA binder can be highly activated at 180 °C, while the degree of activation decreases significantly at 120 °C. By using an artificial RAP with different degrees of aging, the aging of RA binder is found to be harmful to activation only when the preheating temperature is low (such as 120 °C). Hence, if the equipment is capable of doing so, it is better to raise the preheating temperature of RAP to improve the activation of RA binder, especially for binder with a higher degree of aging.

Fracture and mechanical properties of asphalt mixtures containing granular polyethylene terephthalate (PET)

2020 ◽  
Vol 259 ◽  
pp. 120410 ◽  
Author(s):  
Amin Shams Esfandabad ◽  
Seyed Mohsen Motevalizadeh ◽  
Reza Sedghi ◽  
Pooyan Ayar ◽  
Seyed Mohammad Asgharzadeh
Keyword(s):  
Mechanical Properties ◽  
Polyethylene Terephthalate ◽  
Asphalt Mixtures

Influence of Air Voids on Mechanical Properties of Asphalt Mixtures

2011 ◽  
Vol 12 (3) ◽  
pp. 493-524 ◽  
Author(s):  
Emad Kassem ◽  
Eyad Masad ◽  
Robert Lytton ◽  
Arif Chowdhury
Keyword(s):  
Mechanical Properties ◽  
Asphalt Mixtures ◽  
Air Voids

scholarly journals MINERALINIŲ MEDŽIAGŲ MECHANINIŲ SAVYBIŲ TYRIMAI, ANALIZĖ IR VERTINIMAS / RESEARCH, ANALYSIS, AND EVALUATION OF MECHANICAL PROPERTIES OF AGGREGATES

2018 ◽  
Vol 10 (0) ◽  
pp. 1-9 ◽  
Author(s):  
Lina Šneideraitienė ◽  
Daiva Žilionienė
Keyword(s):  
Mechanical Properties ◽  
Asphalt Pavement ◽  
Road Construction ◽  
Test Methods ◽  
Asphalt Mixtures ◽  
Test Results ◽  
Analysis And Evaluation ◽  
Baltic Countries ◽  
Research Analysis ◽  
Mineral Aggregates

The two Baltic countries, Lithuania and Latvia, use asphalt mixtures with granite slag that is imported from other countries to install the top layer of asphalt pavement, which is quite expensive. One of the requirements for aggregates used in road construction is mechanical properties. There are some differences between these countries based on national requirements. The article presents test methods for determining the mechanical properties of aggregates. According to them, the mechanical properties of aggregates were tested: resistance to fragmentation, wear, polishing and to wear by abrasion from studded tyre. Tested aggregates were Lithuanian dolomite quarry stone, which was made based on the developed and common technologies as well as imported granite from Ukraine. The analysis and evaluation of the test results have been carried out by the requirements for mineral aggregates of Lithuania and Latvia. Santrauka Dvi Baltijos šalys, Lietuva ir Latvija, asfalto dangos viršutiniam sluoksniui įrengti naudoja asfalto mišinius su granito skalda, kuri importuojama iš kitų šalių, o tai gana brangu. Vienas iš reikalavimų mineralinėms medžiagoms, naudojamoms kelių tiesyboje, yra mechaninės savybės. Jos minėtose šalyse pagal nacionalinius normatyvinius reikalavimus šiek tiek skiriasi. Straipsnyje pateikti mineralinių medžiagų mechaninių savybių nustatymo bandymo metodų aprašai. Pagal juos atlikti skaldų mechaninių savybių bandymai: atsparumas smūgiams, trupinimui, dėvėjimuisi, poliruojamumui (LST EN 1097-8:2009. Bandymai užpildų mechaninėms ir fizikinėms savybėms nustatyti. 8 dalis. Akmens poliruojamumo nustatymas) bei dygliuotoms padangoms. Ištirtos skaldos yra Lietuvos dolomito karjero skalda, pagaminta pagal patobulintą ir įprastą technologijas, bei granito skalda iš Ukrainos. Atlikta gautų bandymų rezultatų analizė bei vertinimas pagal Lietuvos ir Latvijos reikalavimus mineralinėms medžiagoms.

Sign in / Sign up

Export Citation Format

Share Document