scholarly journals An eco-friendly micellar HPLC method for the simultaneous determination of triamterene and xipamide in active pharmaceutical ingredients and marketed tablet dosage form

2020 ◽  
pp. 1-6
Author(s):  
Magda M. Ayad ◽  
Mervat M. Hosny ◽  
Adel Ehab Ibrahim ◽  
Omar M. El-Abassy ◽  
Fathalla F. Belal
Keyword(s):  
Stationary Phase ◽  
Simultaneous Determination ◽  
Mobile Phase ◽  
Ecological Impact ◽  
Reversed Phase ◽  
Hplc Method ◽  
Alcohol Ethoxylates ◽  
Ionic Surfactant ◽  
Brij 35

Abstract In the last few years, the use of surfactants as mobile phase additives in reversed phase liquid chromatography (RPLC) has been steadily developing and improving. Surfactants modify the polarity of the stationary phase which in turn decreases the amount of organic solvent required for elution of the analytes rendering the methodologies linked to them greener and more eco-friendly. Brij-35 is a fatty alcohol ethoxylates non ionic surfactant, which is less widely used as mobile phase additive. Brij-35 can decrease stationary phase polarity while remaining neutral. In this research, Brij-35 was studied in the separation and determination of marketed antihypertensive combination therapy composed of triamterene (TRM) and xipamide (XIP). TRM and XIP are diuretics used for treatment of essential hypertension and associated edema conditions. Chromatographic separation was achieved on RP-C18 column (Kinetix®, 5 µm, 15 cm × 4.6 mm) at flow rate 1  mL  min−1 and UV-detection at 254 nm. Isocratic elution was performed using mobile phase composed of 0.1 M Brij-35: methanol (MeOH) (60:40, v/v). The analytes were well separated and quantified within linearity ranges of 5–50 µg mL−1 for both drugs in short retention time (2.6 and 5.3 min. for TRM and XIP, respectively). Since claiming greenness is not enough, Green Analytical Procedure Index (GAPI) was used to demonstrate the superiority of the proposed method over the previously reported methods. GAPI is a new metric for evaluation of the ecological impact of analytical procedures. The proposed method was validated according to ICH guidelines and applied successfully for simultaneous determination of the drugs in their co-formulated tablets.

scholarly journals Simultaneous Determination of Preservatives (Methyl Paraben and Propyl Paraben) in Sucralfate Suspension Using High Performance Liquid Chromatography

2011 ◽  
Vol 8 (1) ◽  
pp. 340-346 ◽  
Author(s):  
Rajesh M. Kashid ◽  
Santosh G. Singh ◽  
Shrawan Singh
Keyword(s):  
High Performance Liquid Chromatography ◽  
Simultaneous Determination ◽  
Mobile Phase ◽  
High Performance ◽  
Reversed Phase ◽  
Hplc Method ◽  
Reversed Phase Hplc ◽  
Methyl Paraben ◽  
Propyl Paraben

A reversed phase HPLC method that allows the separation and simultaneous determination of the preservatives methyl paraben (M.P.) and propyl paraben (P.P.) is described. The separations were effected by using an initial mobile phase of water: acetonitrile (50:50) on Inertsil C18 to elute P.P. and M.P. The detector wavelength was set at 205 nm. Under these conditions, separation of the two components was achieved in less than 10 min. Analytical characteristics of the separation such as precision, specificity, linear range and reproducibility were evaluated. The developed method was applied for the determination of preservative M.P. and P.P. at concentration of 0.01 mg/mL and 0.1 mg/mL respectively. The method was successfully used for determining both compounds in sucralfate suspension.

scholarly journals Simultaneous determination of clobutinol hydrochloride and doxylamine succinate from syrups by RP HPLC using a new stationary phase containing embedded urea polar groups

2012 ◽  
Vol 48 (2) ◽  
pp. 315-323 ◽  
Author(s):  
Paulo Cesar Pires Rosa ◽  
Isabel Cristina Sales Fontes Jardim
Keyword(s):  
Stationary Phase ◽  
Simultaneous Determination ◽  
Reversed Phase ◽  
Hplc Method ◽  
Array Detector ◽  
Polar Groups ◽  
Ich Guidelines ◽  
Relative Standard ◽  
New Stationary Phase

A new, simple, fast, reproducible and sensitive reversed phase HPLC method, using a new stationary phase containing embedded urea polar groups, has been developed and validated for the simultaneous determination of clobutinol hydrochloride (CLO) and doxylamine succinate (DOX) in syrups. The determination was carried out on a C8 urea column (125 mm x 3.9 mm i.d., 5 µm particle size) synthetized at the Liquid Chomatography Laboratory (LabCrom) of the Chemistry Institute of Unicamp. The mobile phase consisted of a mixture of acetonitrile:methanol:phosphate buffer (pH 2.5) in the gradient mode. The diode array detector (DAD) was operated at 230 nm for CLO and 262 nm for DOX. The method showed adequate precision, with relative standard deviations (RSD) less than 1%. The presence of the excipients did not interfere in the results of the analysis. Accuracy was determined by adding standards of the drugs to a placebo and good recovery values were obtained. The analytical curves were linear (r² 0.9999 for CLO and 0.9998 for DOX) over a wide concentration range (2.4-336 µg mL-1 for CLO and 2.3-63 µg mL-1 for DOX). The solutions were stable for at least 72 hours at room temperature. The criteria for validation using the ICH guidelines were fulfilled.

VALIDATED RP-HPLC METHOD FOR DETERMINATION OF ENZALUTAMIDE IN BULK DRUG AND PHARMACEUTICAL DOSAGE FORM

INDIAN DRUGS ◽  
2016 ◽  
Vol 53 (11) ◽  
pp. 46-50
Author(s):  
Z. G Khan ◽  
◽  
S. S. Patil ◽  
P. K. Deshmukh ◽  
P. O. Patil
Keyword(s):  
Retention Time ◽  
Mobile Phase ◽  
High Performance ◽  
Reversed Phase ◽  
Hplc Method ◽  
Uv Detector ◽  
Chromatography Method ◽  
Pharmaceutical Dosage Form ◽  
Bulk Drug

Novel, isocratic reversed phase high performance liquid chromatography method was developed and validated for the determination of enzalutamide (EZA) in bulk drug and pharmaceutical formulation. Efficient separation was achieved on PrincetonSPHER C18 100A, 5μ (250×4.6 mm) under the isocratic mode of elution using acetonitrile: water (80:20) % V/V as a mobile phase pumped in to the column at flow rate 1.0 mL/min. The effluent was monitored at 237.0 nm using UV detector. EZA was eluted in the given mobile phase at retention time (tR) of 3.2 minutes. The standard calibration curve was linear over the concentration range 10 - 60 μg/mL with correlation coefficient 0.997. The method was validated for accuracy, precision, sensitivity, robustness, ruggedness and all the resulting data treated statistically. The system suitability parameters like retention time, theoretical plates, tailing factor, capacity factor were found within the limit.

scholarly journals Development and validation of a reversed-phase HPLC method for determination of assay content of Teriflunomide by the aid of BOMD simulations

2021 ◽  
pp. 281-294 ◽  
Author(s):  
Abolghasem Beheshti ◽  
Zahra Kamalzadeha ◽  
Monireh Haj-Maleka ◽  
Meghdad Payaba ◽  
Mohammad Amin Rezvanfar ◽  
...  
Keyword(s):  
Mobile Phase ◽  
Potassium Dihydrogen Phosphate ◽  
Active Pharmaceutical Ingredient ◽  
Reversed Phase ◽  
Hplc Method ◽  
Dihydrogen Phosphate ◽  
Td Dft ◽  
High Level ◽  
Development And Validation

Due to the new hopes for treatment of multiple sclerosis (MS) diseases by Teriflunomide (TFN), in this project, a cheap, robust, and fully validated method has been developed both for determination of assay content in API (active pharmaceutical ingredient), and for related impurities analysis (RIA). To operate the method, a common C18, end-capped (250 × 4.6) mm, 5µm liquid chromatography column, was applied. The mobile phase A was prepared by dissolving 2.74 g (20mM) of PDP (potassium dihydrogen phosphate) and 3.72 g (50mM) of PC (potassium chloride) in water (1000 mL). Then, pH was adjusted to 3.0 by adding OPA (ortho-phosphoric acid) 85%; while, the mobile phase B was acetonitrile (ACN) (100%). In order to confirm the experimental data about the λmax of TFN, we have used the Born-Oppenheimer molecular dynamics (BOMD) simulations, quantum mechanics (QM), and TD-DFT calculations. According to the results, the method showed a high level of suitability, specificity, linearity, accuracy, precision, repeatability, robustness, and reliable detection limit.

scholarly journals Stability-Indicating Validated HPLC Method for Simultaneous Determination of Oral Antidiabetic Drugs from Thiazolidinedione and Sulfonylurea Groups in Combined Dosage Forms

2010 ◽  
Vol 93 (4) ◽  
pp. 1086-1092 ◽  
Author(s):  
Anna Gumieniczek ◽  
Anna Berecka ◽  
ukasz Komsta
Keyword(s):  
Simultaneous Determination ◽  
Mobile Phase ◽  
Uv Light ◽  
Degradation Products ◽  
Dosage Forms ◽  
Hplc Method ◽  
Base Temperature ◽  
Stability Indicating ◽  
Acid And Base

Abstract For type 2 diabetes treatment, combinations of drugs from the thiazolidinedione and sulfonylurea groups are now available in the same tablet or capsule. Therefore, a stability-indicating and validated HPLC method was developed for simultaneous determination of pioglitazone, rosiglitazone, and glipizide in combined dosage forms. The examined drugs were subjected to different conditions such as acid and base, temperature, and UV light, and degradation of pioglitazone and glipizide was observed under thermal and acidic stress. However, selectivity of the presented method for pioglitazone, rosiglitazone, and glipizide assay against their degradation products was confirmed. It was also demonstrated to be robust, resisting small deliberate changes in pH of the buffer, flow rate, and percentage of acetonitrile in the mobile phase. The presented method utilizes a LiChrospher RP18 column (125 4.0 mm), acetonitrile in phosphate buffer at pH 4.3 (40 + 60, v/v) as the mobile phase, and UV detection at 225 nm for pioglitazone/glipizide or 245 nm for rosiglitazone/glipizide. The method was validated with respect to linearity, precision, and accuracy. Finally, the elaborated procedure was applied for the QC of pioglitazone/glipizide and rosiglitazone/glipizide mixtures.

scholarly journals Simultaneous Determination of Eight Synthetic Permitted and Five Commonly Encountered Nonpermitted Food Colors in Various Food Matrixes by High-Performance Liquid Chromatography

2010 ◽  
Vol 93 (5) ◽  
pp. 1503-1514 ◽  
Author(s):  
Sumita Dixit ◽  
Subhash K Khanna ◽  
Mukul Das
Keyword(s):  
Simultaneous Determination ◽  
High Performance ◽  
High Sensitivity ◽  
Gradient Elution ◽  
Reversed Phase ◽  
Hplc Method ◽  
Food Category ◽  
Food Commodities ◽  
Food Colors

Abstract A simple and sensitive HPLC method has been developed for the simultaneous determination of eight permitted food colors and five commonly encountered nonpermitted colors in various food commodities, including sugar-, fat-, and starch-based food matrixes. The method uses a specific food category-based cleanup/treatment procedure before color extraction to avoid the interference of food matrixes, and to obtain the optimal color extraction. Analysis was performed on a reversed-phase C18 -Bondapak column with ammonium acetate and acetonitrile gradient elution as the mobile phase; a programmable max-specific visible detection was used to monitor colors to obtain the higher sensitivity and expanded scope needed for multicolor blends having diverse absorption maxima. All colors showed good linearity, with regression coefficients of 0.99740.9999. The LOD and LOQ values ranged from 0.01 to 0.12 mg/L, and from 0.04 to 0.83 mg/L or mg/kg, respectively. The intraday and interday precision tests produced good RSD values, and the recoveries from different food matrixes ranged from 82 to 104%. The method offers high sensitivity for analysis of a wide variety of food matrixes containing a broad scope of multicolor blends. Two nonpermitted colors, orange II and metanil yellow, were found. Also, a number of samples contained permitted colors at levels two-to seven-fold higher than those prescribed.

Sign in / Sign up

Export Citation Format

Share Document