Characterization of spray-pyrolized superconducting YBaCuO thin films on single-crystal MgO by transmission electron microscopy

1990 ◽  
Vol 5 (8) ◽  
pp. 1605-1611 ◽  
Author(s):  
S. J. Golden ◽  
H. Isotalo ◽  
M. Lanham ◽  
J. Mayer ◽  
F. F. Lange ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Thin Films ◽  
Transmission Electron Microscopy ◽  
Film Thickness ◽  
Single Crystal ◽  
Processing Parameters ◽  
Transmission Electron ◽  
Film Substrate ◽  
Mgo Substrate

Superconducting YBaCuO thin films have been fabricated on single-crystal MgO by the spray-pyrolysis of nitrate precursors. The effects on the superconductive behavior of processing parameters such as time and temperature of heat treatment and film thickness were investigated. The superconductive behavior was found to be strongly dependent on film thickness. Films of thickness 1 μm were found to have a Tc of 67 K while thinner films showed appreciably degraded properties. Transmission electron microscopy studies have shown that the heat treatments necessary for the formation of the superconductive phase (for example, 950 °C for 30 min) also cause a substantial degree of film-substrate interdiffusion. Diffusion distances for Cu in the MgO substrate and Mg in the film were found to be sufficient to explain the degradation of the superconductive behavior in films of thickness 0.5 μm and 0.2 μm. From the concentration profiles obtained by EDS analysis diffusion coefficients at 950 °C for Mg into the YBaCuO thin film and for Cu into the MgO substrate were evaluated as 3 × 10−19 m2/s and 1 × 10−17 m2/s, respectively.

Piezoresponse Force Microscopy Characterization of PTO Thin Films

2009 ◽  
Vol 1186 ◽  
Author(s):  
Alessio Morelli ◽  
Sriram Venkatesan ◽  
George Palasantzas ◽  
Bart J. Kooi ◽  
Jeff De Hosson
Keyword(s):  
Electron Microscopy ◽  
Thin Films ◽  
Transmission Electron Microscopy ◽  
Piezoelectric Properties ◽  
Piezoresponse Force Microscopy ◽  
Force Microscopy ◽  
Transmission Electron ◽  
Film Substrate ◽  
Microscopy Characterization

AbstractThe piezoelectric properties of PTO thin films grown by pulsed laser deposition are investigated with piezoresponse force microscopy and transmission electron microscopy. The as-grown films exhibit upward polarization, and inhomogeneous distribution of piezoelectric characteristics. The data obtained reveal imprint during piezoresponse force microscopy measurements, nonlinearity in the piezoelectric deformation, and limited retention loss. Moreover, transmission electron microscopy shows the presence of defects near the film/substrate interface, which can be associated with the variations of piezoelectric properties.

Microstructure of SrTiO3 Thin Films as Single Layer and Incorporated in Yba2Cu3O7-x/SrTiO3 Multilayers

1995 ◽  
Vol 401 ◽  
Author(s):  
L. Ryen ◽  
E. Olssoni ◽  
L. D. Madsen ◽  
C. N. L. Johnson ◽  
X. Wang ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Thin Films ◽  
Transmission Electron Microscopy ◽  
Lattice Mismatch ◽  
Single Layer ◽  
Transmission Electron ◽  
Tilt Boundaries ◽  
Interfacial Dislocations ◽  
The Individual ◽  
Film Substrate

AbstractEpitaxial single layer (001) SrTiO3 films and an epitaxial Yba2Cu3O7-x/SrTiO3 multilayer were dc and rf sputtered on (110)rhombohedral LaAIO3 substrates. The microstructure of the films was characterised using transmission electron microscopy. The single layer SrTiO3 films exhibited different columnar morphologies. The column boundaries were due to the lattice mismatch between film and substrate. The boundaries were associated with interfacial dislocations at the film/substrate interface, where the dislocations relaxed the strain in the a, b plane. The columns consisted of individual subgrains. These subgrains were misoriented with respect to each other, with different in-plane orientations and different tilts of the (001) planes. The subgrain boundaries were antiphase or tilt boundaries.The individual layers of the Yba2Cu3O7-x/SrTiO3 multilayer were relatively uniform. A distortion of the SrTiO3 unit cell of 0.9% in the ‘001’ direction and a Sr/Ti ratio of 0.62±0.04 was observed, both in correspondence with the single layer SrTiO3 films. Areas with different tilt of the (001)-planes were also present, within each individual SrTiO3 layer.

Interfacial Structure of BaRuO3 Thin Films Grown On (111) SrTiO3

2000 ◽  
Vol 654 ◽  
Author(s):  
W. Tian ◽  
M. K. Lee ◽  
C. B. Eom ◽  
X. Q. Pan
Keyword(s):  
Electron Microscopy ◽  
Thin Films ◽  
Transmission Electron Microscopy ◽  
Intermediate Layer ◽  
Interfacial Structure ◽  
Initial Growth ◽  
Growth Modes ◽  
Transmission Electron ◽  
Quantitative Image ◽  
Film Substrate

AbstractBaRuO3 thin films were grown on (111) SrTiO3substrate by 90° off-axis rf-sputtering. Transmission electron microscopy studies revealed that the films consist of the metastable 4H hexagonal polymorph of BaRuO3 along with few defects. The films are c-axis oriented, single crystalline with the in-plane orientation relationship with respect to the SrTiO3substrate of [112 0] BaRuO3 // [110] SrTiO3. High-resolution transmission electron microscopy (HRTEM) studies of the film-substrate interface revealed the existence of a thin intermediate layer of the 9R hexagonal polymorph of BaRuO3 between the (111) SrTiO3 substrate and the 4H film. The formation mechanism for the intermediate layer is not fully understood though. Through the combination of HRTEM and quantitative image simulations, the atomic structure of the interface between the 9R intermediate layer and the underneath (111) SrTiO3 was constructed. Three initial growth modes were observed, each of them adopting the local continuity of the oxygen octahedral sublattice across the interface.

Epitaxy of Nb3 Sn Films on Sapphire

1984 ◽  
Vol 37 ◽  
Author(s):  
A. F. Marshall ◽  
F. Hellman ◽  
B. Oh
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Film Thickness ◽  
Single Crystal ◽  
Domain Structure ◽  
High Temperatures ◽  
Defect Structure ◽  
Epitaxial Relationship ◽  
Crystal Matrix ◽  
Transmission Electron

AbstractFilms of Nb3Sn vapor deposited at low rates and high temperatures on (1102) sapphire form an epitaxial <100> single crystal matrix with a domain structure of misoriented regions bounded by low-angle dislocation boundaries. Nucleation of other orientations at the interface result in a highly oriented but polycrystalline film through approximately the first thousand Angstroms of film thickness. After this point random orientations become overgrown by epitaxial <100> regions. At slightly lower temperatures many small <100> grains with a second epitaxial relationship also nucleate at the interface. These rotated grains persist through greater thicknesses than random orientations. The misorientation defect structure of the single crystal matrix is analyzed by transmission electron microscopy.

scholarly journals Characterization of Fe-N nanocrystals and nitrogen–containing inclusions in (Ga,Fe)N thin films using transmission electron microscopy

2013 ◽  
Vol 114 (3) ◽  
pp. 033530 ◽  
Author(s):  
A. Kovács ◽  
B. Schaffer ◽  
M. S. Moreno ◽  
J. R. Jinschek ◽  
A. J. Craven ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Thin Films ◽  
Transmission Electron Microscopy ◽  
Transmission Electron
Sign in / Sign up

Export Citation Format

Share Document