EXPERIMENTAL INVESTIGATION ON FLOW PATTERNS AND PRESSURE DROP OF R134A FLOW BOILING IN A HORIZONTAL HELICALLY COILED PIPE

2013 ◽  
Vol 20 (3) ◽  
pp. 225-233
Author(s):  
L. Shao ◽  
Jitian Han ◽  
M. X. Wang ◽  
C. N. Chen ◽  
T. C. Jen
Keyword(s):  
Experimental Investigation ◽  
Pressure Drop ◽  
Flow Boiling ◽  
Flow Patterns

Heat Transfer and Pressure Drop for Flow Boiling of Water in Narrow Vertical Rectangular Channels

2003 ◽  
Author(s):  
Jianyun Shuai ◽  
Rudi Kulenovic ◽  
Manfred Groll
Keyword(s):  
Heat Transfer ◽  
Pressure Drop ◽  
Flow Boiling ◽  
Bubbly Flow ◽  
High Heat ◽  
Flow Patterns ◽  
Industrial Applications ◽  
Heat Fluxes ◽  
Experimental Conditions ◽  
Rectangular Channels

Flow boiling in small-sized channels attracted extensive investigations in the past two decades due to special requirements for transfer of high heat fluxes from narrow spaces in various industrial applications. Experiments on various aspects of flow boiling in narrow channels were carried out and theoretical attempts were undertaken. But these investigations showed large differences, e.g. up till now the knowledge on the development of flow patterns in small non-circular flow passages is very limited. This paper deals with investigations on flow boiling of water in two rectangular channels with dimensions (width×depth) 2.0×4.0 mm2 and 0.5×2.0 mm2 (corresponding hydraulic diameters are 2.67 mm and 0.8 mm). The pressure at the test section exit is atmospheric. For steady-state experimental conditions the effects of heat flux, mass flux and inlet subcooling on the boiling heat transfer coefficient and the pressure drop are investigated. Flow patterns and the transition of flow patterns along the channel axis are visualized and documented with a video-camera. Bubbly flow, slug flow and annular flow are distinguished in both channels. Preliminary flow pattern maps are generated.

Flow Boiling Heat Transfer, Pressure Drop, and Flow Pattern for CO2 in a 3.5mm Horizontal Smooth Tube

2009 ◽  
Vol 131 (9) ◽  
Author(s):  
Chang Yong Park ◽  
Pega Hrnjak
Keyword(s):  
Heat Transfer ◽  
Pressure Drop ◽  
Flow Pattern ◽  
Mass Flux ◽  
Boiling Heat Transfer ◽  
Flow Boiling ◽  
Flow Patterns ◽  
Transfer Coefficients ◽  
Heat Transfer Coefficients ◽  
Flow Boiling Heat Transfer

Abstract C O 2 flow boiling heat transfer coefficients and pressure drop in a 3.5mm horizontal smooth tube are presented. Also, flow patterns were visualized and studied at adiabatic conditions in a 3mm glass tube located immediately after a heat transfer section. Heat was applied by a secondary fluid through two brass half cylinders to the test section tubes. This research was performed at evaporation temperatures of −15°C and −30°C, mass fluxes of 200kg∕m2s and 400kg∕m2s, and heat flux from 5kW∕m2 to 15kW∕m2 for vapor qualities ranging from 0.1 to 0.8. The CO2 heat transfer coefficients indicated the nucleate boiling dominant heat transfer characteristics such as the strong dependence on heat fluxes at a mass flux of 200kg∕m2s. However, enhanced convective boiling contribution was observed at 400kg∕m2s. Surface conditions for two different tubes were investigated with a profilometer, atomic force microscope, and scanning electron microscope images, and their possible effects on heat transfer are discussed. Pressure drop, measured at adiabatic conditions, increased with the increase of mass flux and quality, and with the decrease of evaporation temperature. The measured heat transfer coefficients and pressure drop were compared with general correlations. Some of these correlations showed relatively good agreements with measured values. Visualized flow patterns were compared with two flow pattern maps and the comparison showed that the flow pattern maps need improvement in the transition regions from intermittent to annular flow.

Experimental Study of Flow Patterns, Pressure Drop and Flow Instabilities in Parallel Rectangular Minichannels

2004 ◽  
Author(s):  
Prabhu Balasubramanian ◽  
Satish G. Kandlikar
Keyword(s):  
Pressure Drop ◽  
High Speed ◽  
Flow Instability ◽  
Flow Boiling ◽  
Pressure Fluctuations ◽  
Flow Patterns ◽  
Flow Instabilities ◽  
Stable Operation ◽  
Phase System ◽  
High Heat Flux

The use of phase change heat transfer in parallel minichannels and microchannels is one of the solutions proposed for cooling high heat flux systems. The increase in pressure drop in a two phase system is one of the problems, that need to be studied in detail before proceeding to any design phase. The pressure drop fluctuations in a network of parallel channels connected by a common head need to be addressed for stable operation of flow boiling systems. The current work focuses on studying the pressure-drop fluctuations and flow instabilities in a set of six parallel rectangular minichannels, each with 333 μm hydraulic diameter. Demonized and degassed water was used for all the experiments. Pressure fluctuations are recorded and signal analysis is performed to find the dominant frequencies and their amplitudes. These pressure fluctuations are then mapped to their corresponding flow patterns observed using a high speed camera. The results help us to relate pressure fluctuations to different flow characteristics, and their effect on flow instability.

Two-Phase Flow and Heat Transfer in Rectangular Micro-Channels

2004 ◽  
Vol 126 (3) ◽  
pp. 288-300 ◽  
Author(s):  
Weilin Qu ◽  
Seok-Mann Yoon ◽  
Issam Mudawar
Keyword(s):  
Heat Transfer ◽  
Pressure Drop ◽  
Flow Pattern ◽  
Two Phase Flow ◽  
Flow Boiling ◽  
Flow Patterns ◽  
Heat Sinks ◽  
Phase Flow ◽  
Micro Channel ◽  
Two Phase

Knowledge of flow pattern and flow pattern transitions is essential to the development of reliable predictive tools for pressure drop and heat transfer in two-phase micro-channel heat sinks. In the present study, experiments were conducted with adiabatic nitrogen-water two-phase flow in a rectangular micro-channel having a 0.406×2.032mm2 cross-section. Superficial velocities of nitrogen and water ranged from 0.08 to 81.92 m/s and 0.04 to 10.24 m/s, respectively. Flow patterns were first identified using high-speed video imaging, and still photos were then taken for representative patterns. Results reveal the dominant flow patterns are slug and annular, with bubbly flow occurring only occasionally; stratified and churn flow were never observed. A flow pattern map was constructed and compared with previous maps and predictions of flow pattern transition models. Features unique to two-phase micro-channel flow were identified and employed to validate key assumptions of an annular flow boiling model that was previously developed to predict pressure drop and heat transfer in two-phase micro-channel heat sinks. This earlier model was modified based on new findings from the adiabatic two-phase flow study. The modified model shows good agreement with experimental data for water-cooled heat sinks.

Flow Boiling of Carbon Dioxide in Horizontal Mini-Channel and Pattern Dynamics Approach to Study Flow Pattern

2009 ◽  
Author(s):  
Mamoru Ozawa
Keyword(s):  
Carbon Dioxide ◽  
High Pressure ◽  
Pressure Drop ◽  
Flow Pattern ◽  
Flow Instability ◽  
Flow Boiling ◽  
Flow Patterns ◽  
Bond Number ◽  
Pattern Dynamics ◽  
Mini Channels

This paper provides a brief review on experimental and numerical investigations of flow patterns, pressure drop, and heat transfer including critical heat flux (CHF) of flow boiling carbon-dioxide (CO2) at high pressure in mini-channels ranging 0.5mm to 3.0mm in diameter. The flow patterns of CO2 at high pressure with small density difference between vapor and liquid and low surface tension show a slightly different structure from so far observed in mini-channels with air and water. The phase mal-distribution, similar to conventional tubes, in the cross-section becomes rather significant beyond the critical Bond number, which leads to the intermittent dryout at the upper wall of the tube. So far proposed flow pattern transition criteria are ineffective there, and newly developed discrete bubble model demonstrates its high potential in predicting flow patterns. Conventional homogeneous flow model is still available in predicting pressure drop. Based on this fact, flow instability problems, which significantly affect CHF, is discussed focusing on high-pressure CO2 flow.

Sign in / Sign up

Export Citation Format

Share Document