Using Infrared and High-Speed Ground-Penetrating Radar for Uniformity Measurements on New HMA Layers

2012 ◽  
Author(s):  
Stephen Sebesta ◽  
Timo Saarenketo ◽  
Tom Scullion ◽  
◽  
◽  
...  
2021 ◽  
Vol 13 (10) ◽  
pp. 1899
Author(s):  
Wouter van Verre ◽  
Frank J. W. Podd ◽  
Xianyang Gao ◽  
David J. Daniels ◽  
Anthony J. Peyton

Microwave ultra-wideband technology has been widely adopted in instrumentation and measurement systems, including ground-penetrating radar (GPR) sensors. Baluns are essential components in these systems to feed balanced antennas from unbalanced feed cables. Baluns are typically introduced to avoid issues with return signals, asymmetrical radiation patterns and radiation from cables. In GPR systems, these issues can cause poor sensitivity due to a reduction in radiated power, blind spots due to changes in the radiation pattern and additional clutter from common mode radiation. The different balun technologies currently available exhibit a wide variation in performance characteristics such as insertion loss, reflection coefficient and phase balance, as well as physical properties such as size and manufacturability. In this study, the performance of two magnetic transformer baluns, two tapered microstrip baluns and an active balun based on high-speed amplifiers were investigated, all up to frequencies of 6 GHz. A radio frequency current probe was used to measure the common mode currents on the feed cables that occur with poor performing baluns. It was found that commercially available magnetic transformer baluns have the best phase linearity, while also having the highest insertion losses. The active balun design has the best reflection coefficient at low frequencies, while, at high frequencies, its performance is similar to the other baluns tested. It was found that the active balun had the lowest common mode current on the feed cables.


Sensors ◽  
2020 ◽  
Vol 20 (10) ◽  
pp. 2938
Author(s):  
Neil Linford ◽  
Russell MacKechnie-Guire ◽  
May Cassar

The aim of this trial project was to identify whether buried archaeological remains may have an influence on equine locomotion, through comparison with a non-invasive Ground Penetrating Radar (GPR) survey. This study was conducted at the world-renowned Burghley Horse Trials site, near Stamford, City of Peterborough, U.K. that has a diverse range of heritage assets throughout the wider park land centred on the Grade 1 listed Elizabethan Burghley House. The initial aim of the research was to first use geophysical survey to identify and characterise archaeological remains, and then to determine a suitable location to conduct an equine locomotion study. This trial was conducted with five event type horses with their gaits recorded through the use of three axis, wireless, Inertial Measurement Units, and high speed video capture. It was hoped that this study might indicate an association between the presence of well preserved archaeological remains and changes in the gait of the horses, similar to those shown by studies of dressage horses over different riding surfaces. The results from the equine locomotion study did demonstrate a correlation between the presence of surviving archaeological remains and the alteration in the horses’ gait and, although this is only a preliminary study, the results may well be of interest during the design and construction of equine event facilities. Geophysical survey could, for example, be considered during the design of new or alteration to existing equine courses to allow some mitigation in the location of the course with respect to any archaeological remains, or through the appropriate use of a protective artificial surface.


2013 ◽  
Vol 139 (3) ◽  
pp. 272-285 ◽  
Author(s):  
Xianlei Xu ◽  
Tian Xia ◽  
Anbu Venkatachalam ◽  
Dryver Huston

Author(s):  
M. S. Sudakova ◽  
M. L. Vladov ◽  
M. R. Sadurtdinov

Within the ground penetrating radar bandwidth the medium is considered to be an ideal dielectric, which is not always true. Electromagnetic waves reflection coefficient conductivity dependence showed a significant role of the difference in conductivity in reflection strength. It was confirmed by physical modeling. Conductivity of geological media should be taken into account when solving direct and inverse problems, survey design planning, etc. Ground penetrating radar can be used to solve the problem of mapping of halocline or determine water contamination.


2017 ◽  
Vol 3 (1) ◽  
pp. 73-83
Author(s):  
Rahmayati Alindra ◽  
Heroe Wijanto ◽  
Koredianto Usman

Ground Penetrating Radar (GPR) adalah salah satu jenis radar yang digunakan untuk menyelidiki kondisi di bawah permukaan tanah tanpa harus menggali dan merusak tanah. Sistem GPR terdiri atas pengirim (transmitter), yaitu antena yang terhubung ke generator sinyal dan bagian penerima (receiver), yaitu antena yang terhubung ke LNA dan ADC yang kemudian terhubung ke unit pengolahan data hasil survey serta display sebagai tampilan output-nya dan post  processing untuk alat bantu mendapatkan informasi mengenai suatu objek. GPR bekerja dengan cara memancarkan gelombang elektromagnetik ke dalam tanah dan menerima sinyal yang dipantulkan oleh objek-objek di bawah permukaan tanah. Sinyal yang diterima kemudian diolah pada bagian signal processing dengan tujuan untuk menghasilkan gambaran kondisi di bawah permukaan tanah yang dapat dengan mudah dibaca dan diinterpretasikan oleh user. Signal processing sendiri terdiri dari beberapa tahap yaitu A-Scan yang meliputi perbaikan sinyal dan pendektesian objek satu dimensi, B-Scan untuk pemrosesan data dua dimensi  dan C-Scan untuk pemrosesan data tiga dimensi. Metode yang digunakan pada pemrosesan B-Scan salah satunya adalah dengan  teknik pemrosesan citra. Dengan pemrosesan citra, data survey B-scan diolah untuk didapatkan informasi mengenai objek. Pada penelitian ini, diterapkan teori gradien garis pada pemrosesan citra B-scan untuk menentukan bentuk dua dimensi dari objek bawah tanah yaitu persegi, segitiga atau lingkaran. 


Sign in / Sign up

Export Citation Format

Share Document