scholarly journals Thermodynamic Analysis of Hydrogen Production by a Thermochemical Cycle Based on Magnesium-Chlorine

2021 ◽  
Vol 39 (2) ◽  
pp. 521-530
Author(s):  
Ahmed Bensenouci ◽  
Mohamed Teggar ◽  
Ahmed Medjelled ◽  
Ahmed Benchatti

Most thermochemical cycles require complex thermal processes at very high temperatures, which restrict the production and the use of hydrogen on a large scale. Recently, thermochemical cycles producing hydrogen at relatively low temperatures have been developed in order to be competitive with other kinds of energies, especially those of fossil origin. The low temperatures required by those cycles allow them to work with heats recovered by thermal, nuclear and solar power plants. In this work, a new thermochemical cycle is proposed. This cycle uses the chemical elements Magnesium-Chlorine (Mg-Cl) to dissociate the water molecule. The configuration consists of three chemical reactions or three physical steps and uses mainly thermal energy to achieve its objectives. The highest temperature of the process is that of the production of hydrochloric acid, HCl, estimated between 350-450℃. A thermodynamic analysis was performed according to the first and second laws by using Engineering Equation Solver (EES) software and the efficiency of the proposed cycle was found to be 12.7%. In order to improve the efficiency of this cycle and make it more competitive, an electro-thermochemical version should be studied.

The main objective of this research is analysed and compared the performance of two solar power plants to identify the possible operational problems in the tropical region. The grid connected PV power plants considered in the present study, Ten Merina and Senergy, were installed in the region of Thies (Senegal). Solar power plants have the same installed capacity 29.491 MWp. A period of one operation year of the solar power plants is considered, starting from January 2018 to December 2018. The performance parameters developed by the International Energy Agency (IEA) are used to analyse the performances of solar power plants. The results show that the plane of array irradiance at the sites is identical with an annual average of 6.2 kWh/m2/d. The annual average performance ratio and final yield of solar power plants are respectively 74.3 %; 4.61 kWh/kWp to Ten Merina and 75.9 %; 4.66 kWh/kWp to Senergy. These results are compared to other solar power plants installed in different locations around the world.


2012 ◽  
Vol 1 (4) ◽  
pp. 56-69
Author(s):  
Farzin Shama ◽  
Gholam Hossein Roshani ◽  
Sobhan Roshani ◽  
Arash Ahmadi ◽  
Saber Karami

Producing non-polluting renewable energy in large scale is essential for sustainability of future developments in industry and human society. Among renewable energy resources, solar energy takes a special place because of its free accessibility and affordability. However, the optimization of its production and consumption processes poses important concerns, essentially in the affordability issue. This paper investigates several optimization and performance issues regarding solar panel converters using two-axis controlled solar tracer that has been practically implemented in comparison with fixed converter panels. Results shown in tables and graphs demonstrate clearly the advantages and disadvantages of the methods. Based on these results, large scale solar power plants are being suggested to be equipped with similar devices.


2020 ◽  
Vol 12 (15) ◽  
pp. 6223
Author(s):  
Emmanuel Wendsongre Ramde ◽  
Eric Tutu Tchao ◽  
Yesuenyeagbe Atsu Kwabla Fiagbe ◽  
Jerry John Kponyo ◽  
Asakipaam Simon Atuah

Electricity is one of the most crucial resources that drives any given nation’s growth and development. The latest Sustainable Development Goals report indicates Africa still has a high deficit in electricity generation. Concentrating solar power seems to be a potential option to fill the deficit. That is because most of the components of concentrating solar power plants are readily available on the African market at affordable prices, and there are qualified local persons to build the plants. Pilot micro-concentrating solar power plants have been implemented in Sub-Saharan Africa and have shown promising results that could be expanded and leveraged for large-scale electricity generation. An assessment of a pilot concentrating solar power plant in the sub-region noticed one noteworthy obstacle that is the failure of the tracking system to reduce the operating energy cost of running the tracking control system and improve the multifaceted heliostat focusing behavior. This paper highlights the energy situation and the current development in concentrating solar power technology research in Africa. The paper also presents a comprehensive review of the state-of-the-art solar tracking systems for central receiver systems to illustrate the current direction of research regarding the design of low-cost tracking systems in terms of computational complexity, energy consumption, and heliostat alignment accuracy.


1994 ◽  
Vol 116 (3) ◽  
pp. 137-141 ◽  
Author(s):  
D. C. Smith ◽  
E. E. Rush ◽  
C. W. Matthews ◽  
J. M. Chavez ◽  
P. A. Bator

The molten salt pump and valve (P&V) test loops at Sandia National Laboratories (SNL) National Solar Thermal Test Facility (NSTTF) operated between Jan. 1988 and Oct. 1990. The purpose of the P&V test was to demonstrate the performance, reliability, and service life of full-scale hot and cold salt pumps and valves for use in commercial central receiver solar power plants. The P&V test hardware consists of two pumped loops; the “Hot Loop” to simulate the hot (565°C) side of the receiver and the “Cold Loop” to simulate the receiver’s cold (285°C) side. Each loop contains a pump and five valves sized to be representative of a conceptual 60-MWe commercial solar power plant design. The hot loop accumulated over 6700 hours of operation and the cold loop over 2500 hours of operation. This project has demonstrated that standard commercial scale pump and valve designs will work in molten salt. The test also exposed some pitfalls that must be avoided in specifying such equipment. Although certainly not all of the pitfalls were discovered, careful design and specification should result in reliable or at least workable equipment.


Author(s):  
Henry Price ◽  
David Kearney

Parabolic trough solar technology is the most proven and lowest cost large-scale solar power technology available today, primarily because of the nine large commercial-scale solar power plants that are operating in the California Mojave Desert. However, no new plants have been built during the past ten years because the cost of power from these plants is more expensive than power from conventional fossil fuel power plants. This paper reviews the current cost of energy and the potential for reducing the cost of energy from parabolic trough solar power plant technology based on the latest technological advancements and projected improvements from industry and sponsored R&D. The paper also looks at the impact of project financing and incentives on the cost of energy.


2013 ◽  
pp. 335-347
Author(s):  
Farzin Shama ◽  
Gholam Hossein Roshani ◽  
Sobhan Roshani ◽  
Arash Ahmadi ◽  
Saber Karami

Producing non-polluting renewable energy in large scale is essential for sustainability of future developments in industry and human society. Among renewable energy resources, solar energy takes a special place because of its free accessibility and affordability. However, the optimization of its production and consumption processes poses important concerns, essentially in the affordability issue. This paper investigates several optimization and performance issues regarding solar panel converters using two-axis controlled solar tracer that has been practically implemented in comparison with fixed converter panels. Results shown in tables and graphs demonstrate clearly the advantages and disadvantages of the methods. Based on these results, large scale solar power plants are being suggested to be equipped with similar devices.


Sign in / Sign up

Export Citation Format

Share Document