Effect of Fracture Characteristics on Behavior of Fractured Shale-Oil Reservoirs by Cyclic Gas Injection

2016 ◽  
Vol 19 (02) ◽  
pp. 350-355 ◽  
Author(s):  
T.. Wan ◽  
J. J. Sheng ◽  
M. Y. Soliman ◽  
Y.. Zhang
Keyword(s):  
Oil Recovery ◽  
Gas Injection ◽  
Fracture Network ◽  
Production Performance ◽  
Oil Reservoirs ◽  
Shale Oil ◽  
Well Production ◽  
The Matrix ◽  
Stress Dependent ◽  
Shale Oil Reservoirs

Summary The current technique to produce shale oil is to use horizontal wells with multistage stimulation. However, the primary oil-recovery factor is only a few percent. The low oil recovery and abundance of shale reservoirs provide a huge potential for enhanced oil-recovery (EOR) process. Well productivity in shale oil-and-gas reservoirs primarily depends on the size of fracture network and the stimulated reservoir volume (SRV) that provides highly conductive conduits to communicate the matrix with the wellbore. The fracture complexity is critical to the well-production performance, and it also provides an avenue for injected fluids to displace the trapped oil. However, the disadvantage of gasflooding in fractured reservoirs is that injected fluids may break through to production wells by means of the fracture network. Therefore, a preferred method is to use cyclic gas injection to overcome this problem. In this paper, we use a numerical-simulation approach to evaluate the EOR potential in fractured shale-oil reservoirs by cyclic gas injection. Simulation results indicate that the stimulated fracture network contributes significantly to the well productivity by means of its large contact area with the matrix, which prominently enhances the macroscopic sweep efficiency in secondary cyclic gas injection. In our previous simulation work, the EOR potential was evaluated in hydraulic planar-traverse fractures without considering the propagation of a natural-fracture network. In this paper, we examine the effect of fracture networks on shale oilwell secondary-production performance. The impact of fracture spacing and stress-dependent fracture conductivity on the ultimate oil recovery is investigated. The results presented in this paper demonstrate that cyclic gas injection has EOR potential in shale-oil reservoirs. This paper focuses on evaluating the effect of fracture spacing, the size of the fracture network, fracture connectivity (uniform and nonuniform), and stress-dependent fracture-network conductivity on well-production performance of shale-oil reservoirs by secondary cyclic gas injection.

scholarly journals Simulation Study of Allied In-Situ Injection and Production for Enhancing Shale Oil Recovery and CO2 Emission Control

Energies ◽  
2019 ◽  
Vol 12 (20) ◽  
pp. 3961
Author(s):  
Haiyang Yu ◽  
Songchao Qi ◽  
Zhewei Chen ◽  
Shiqing Cheng ◽  
Qichao Xie ◽  
...  
Keyword(s):  
Oil Recovery ◽  
Co2 Emission ◽  
Gas Injection ◽  
Water Injection ◽  
Oil Production ◽  
Injection Rate ◽  
Oil Reservoirs ◽  
Shale Oil ◽  
Shale Oil Reservoirs

The global greenhouse effect makes carbon dioxide (CO2) emission reduction an important task for the world, however, CO2 can be used as injected fluid to develop shale oil reservoirs. Conventional water injection and gas injection methods cannot achieve desired development results for shale oil reservoirs. Poor injection capacity exists in water injection development, while the time of gas breakthrough is early and gas channeling is serious for gas injection development. These problems will lead to insufficient formation energy supplement, rapid energy depletion, and low ultimate recovery. Gas injection huff and puff (huff-n-puff), as another improved method, is applied to develop shale oil reservoirs. However, the shortcomings of huff-n-puff are the low sweep efficiency and poor performance for the late development of oilfields. Therefore, this paper adopts firstly the method of Allied In-Situ Injection and Production (AIIP) combined with CO2 huff-n-puff to develop shale oil reservoirs. Based on the data of Shengli Oilfield, a dual-porosity and dual-permeability model in reservoir-scale is established. Compared with traditional CO2 huff-n-puff and depletion method, the cumulative oil production of AIIP combined with CO2 huff-n-puff increases by 13,077 and 17,450 m3 respectively, indicating that this method has a good application prospect. Sensitivity analyses are further conducted, including injection volume, injection rate, soaking time, fracture half-length, and fracture spacing. The results indicate that injection volume, not injection rate, is the important factor affecting the performance. With the increment of fracture half-length and the decrement of fracture spacing, the cumulative oil production of the single well increases, but the incremental rate slows down gradually. With the increment of soaking time, cumulative oil production increases first and then decreases. These parameters have a relatively suitable value, which makes the performance better. This new method can not only enhance shale oil recovery, but also can be used for CO2 emission control.

scholarly journals Evaluation of the Effectiveness of Continuous Gas Displacement for EOR in Hydraulically Fractured Shale Reservoirs

SPE Journal ◽  
2021 ◽  
pp. 1-24
Author(s):  
George Moridis ◽  
Matthew Reagan
Keyword(s):  
Oil Recovery ◽  
Gas Production ◽  
Oil Reservoirs ◽  
Natural Fracture ◽  
Temperature Phase ◽  
Shale Oil ◽  
Early Arrival ◽  
Wide Range ◽  
The Matrix ◽  
Shale Oil Reservoirs

Summary The main objective of this study is to analyze and describe quantitatively the effectiveness of continuous gas displacement as an enhanced oil recovery (EOR) process to increase production from multifractured shale oil reservoirs. The study uses CH4 continuously injected through horizontal wells parallel to the production wells as the displacement agent and investigates the effects of various attributes of the matrix and of the induced and natural fracture systems. This numerical simulation study focuses on the analysis of the 3D minimum repeatable element (stencil/domain) that can describe a hydraulically fractured shale reservoir under production. The stencil is discretized using a very fine (millimeter-scale) grid. We compare the solutions to a reference case that involves simple depressurization-induced production (i.e., without a gas drive). We monitor continuously (a) the rate and composition of the production stream and (b) the spatial distributions of pressure, temperature, phase saturations, and relative permeabilities. The results of the study indicate that a continuous CH4-based displacement that begins at the onset of production does not appear to be an effective EOR method for hydraulically fractured shale oil reservoirs over a 5-year period in reservoirs in which natural or induced fractures in the undisturbed reservoir and/or in the stimulated reservoir volume (SRV) can be adequately described by a single-medium porosity and permeability. Under these conditions in a system with typical Bakken or Eagle Ford matrix and fracture attributes, continuous CH4 injection by means of a horizontal well parallel to the production well causes a reduction in water production and an (expected) increase in gas production but does not lead to any significant increase in oil production. This is attributed to (a) the limited penetration of the injected gas into the ultralow-k formation, (b) the dissolution of the injected gas into the oil, and (c) its early arrival at the hydraulic fracture (HF; thus, short circuiting the EOR process by bypassing the bulk of the matrix), in addition to (d) the increase in the pressure of the HF and the consequent reduction in the driving force of production and the resulting flow. Under the conditions of this study, these observations hold true for domains with and without an SRV over a wide range of matrix permeabilities and for different lengths and positions (relative to the HF) of the gas injection wells.

scholarly journals Compositional Simulation of Geological and Engineering Controls on Gas Huff-n-Puff in Duvernay Shale Volatile Oil Reservoirs, Canada

Energies ◽  
2021 ◽  
Vol 14 (8) ◽  
pp. 2070
Author(s):  
Xiangwen Kong ◽  
Hongjun Wang ◽  
Wei Yu ◽  
Ping Wang ◽  
Jijun Miao ◽  
...  
Keyword(s):  
Oil Recovery ◽  
Gas Injection ◽  
Volatile Oil ◽  
Oil Reservoirs ◽  
Natural Fracture ◽  
Shale Oil ◽  
Fracture Conductivity ◽  
Engineering Controls ◽  
Short Period ◽  
Shale Oil Reservoirs

Duvernay shale is a world class shale deposit with a total resource of 440 billion barrels oil equivalent in the Western Canada Sedimentary Basin (WCSB). The volatile oil recovery factors achieved from primary production are much lower than those from the gas-condensate window, typically 5–10% of original oil in place (OOIP). The previous study has indicated that huff-n-puff gas injection is one of the most promising enhanced oil recovery (EOR) methods in shale oil reservoirs. In this paper, we built a comprehensive numerical compositional model in combination with the embedded discrete fracture model (EDFM) method to evaluate geological and engineering controls on gas huff-n-puff in Duvernay shale volatile oil reservoirs. Multiple scenarios of compositional simulations of huff-n-puff gas injection for the proposed twelve parameters have been conducted and effects of reservoir, completion and depletion development parameters on huff-n-puff are evaluated. We concluded that fracture conductivity, natural fracture density, period of primary depletion, and natural fracture permeability are the most sensitive parameters for incremental oil recovery from gas huff-n-puff. Low fracture conductivity and a short period of primary depletion could significantly increase the gas usage ratio and result in poor economical efficiency of the gas huff-n-puff process. Sensitivity analysis indicates that due to the increase of the matrix-surface area during gas huff-n-puff process, natural fractures associated with hydraulic fractures are the key controlling factors for gas huff-n-puff in Duvernay shale oil reservoirs. The range for the oil recovery increase over the primary recovery for one gas huff-n-puff cycle (nearly 2300 days of production) in Duvernay shale volatile oil reservoir is between 0.23 and 0.87%. Finally, we proposed screening criteria for gas huff-n-puff potential areas in volatile oil reservoirs from Duvernay shale. This study is highly meaningful and can give valuable reference to practical works conducting the huff-n-puff gas injection in both Duvernay and other shale oil reservoirs.

scholarly journals Study on mechanism of spontaneous imbibition and pressurized imbibition in shale oil reservoirs

2020 ◽  
Author(s):  
Lanlan Yao ◽  
Zhengming Yang ◽  
Haibo Li ◽  
Bo Cai ◽  
Chunming He ◽  
...  
Keyword(s):  
Oil Recovery ◽  
Spontaneous Imbibition ◽  
Oil Reservoirs ◽  
Recovery Ratio ◽  
Shale Oil ◽  
Fracture System ◽  
Matrix System ◽  
Jianghan Basin ◽  
Shale Oil Reservoirs ◽  
Shale Permeability

AbstractImbibition is one of the important methods of oil recovery in shale oil reservoirs. At present, more in-depth studies have been carried out on the fracture system and matrix system, and there are few studies on the effect of energy enhancement on imbibition in shale oil reservoirs. Therefore, based on the study of pressurized imbibition and spontaneous imbibition of shale oil reservoirs in Qianjiang Sag, Jianghan Basin, nuclear magnetic resonance technology was used to quantitatively characterize the production degree of shale and pore recovery contribution under different imbibition modes, and analyze the imbibition mechanism of shale oil reservoirs under the condition of energy enhancement. The experimental results showed that with the increase in shale permeability, the recovery ratio of pressurized imbibition also increased. The rate of pressurized imbibition was higher than spontaneous imbibition, and pressurized imbibition can increase the recovery ratio of fractured shale. Spontaneous imbibition can improve the ultimate recovery ratio of matrix shale. Pressurized imbibition can increase the recovery contribution of macroporous and mesoporous.

scholarly journals The effects of ion diffusion on imbibition oil recovery in salt-rich shale oil reservoirs

2019 ◽  
Vol 16 (3) ◽  
pp. 525-540 ◽  
Author(s):  
Liu Yang ◽  
Xuhui Zhang ◽  
Tong Zhou ◽  
Xiaobing Lu ◽  
Chuanqing Zhang ◽  
...  
Keyword(s):  
Oil Recovery ◽  
Oil Reservoirs ◽  
Shale Oil ◽  
Ion Diffusion ◽  
Shale Oil Reservoirs
Sign in / Sign up

Export Citation Format

Share Document