Casing Integrity Evaluation in Complex Subsurface Intervention Abandonment Wells Using Magnetic Ranging

2021 ◽  
Author(s):  
Georgy Rassadkin ◽  
Douglas Ridgway ◽  
Jamie Dorey
Keyword(s):  
Complete Separation ◽  
Commercial Application ◽  
Reference Field ◽  
Magnetic Signal ◽  
Standard Methods ◽  
Casing Damage ◽  
Magnetic Signature ◽  
Application Data ◽  
Passive Interference ◽  
Field Planning

Abstract This paper describes how active and passive magnetic ranging logging used while drilling subsurface intervention wells shows characteristics of the target well casing integrity and damage. Over the course of the development of a novel active magnetic ranging system and through several years of commercial application, data has been collected and analyzed to understand the characteristics of casing damage. This paper explains the methods used in field operations to collect this data. Using the gathered information, various stages of casing damage and poor integrity are shown. Results obtained from active and passive magnetic ranging are presented in the context of identifying casing damage. This is a departure from the standard methods of interpreting the data as it is not focused on locating a wellbore but determining the integrity of the casing. Casing integrity in idle wells is usually understood by conventional logging techniques until there is a restriction or damage on the well. Magnetic ranging logging performed during the intervention to abandon these wells can give an indication to operators of the casing integrity that otherwise would have been unknown without access to the damaged well. This can help optimize subsequent abandonment procedures as well as assist with field planning into the future to mitigate issues stemming from casing integrity and to identify the causes of previously unknown critical casing damage. The paper reports surface experimental data and compares it with two field examples. In the first field example, the passive magnetic interference from a hundred-year-old casing in the offset well caused more than 100000nT deviation from the reference field approximately 1ft away from the offset well, suggesting severe casing damage. The active magnetic signature measured simultaneously approaches zero, pointing to a lack of electrical continuity in the offset casing caused by a complete break. The second field example shows an offset well segment with passive interference of 7000nT in the presence of a stable active magnetic signal at approximately 2ft separation between wells due to possible casing damage without complete separation. The passive interference increases to 14000 nT at deeper depth while the active signal approaches zero due to a complete casing break. Novel application using the data collected by active and passive magnetic ranging techniques is being applied for the understanding of issues related to casing integrity.

3-D reconstruction of molecular shape from microcrystal thin sections

1983 ◽  
Vol 41 ◽  
pp. 748-749
Author(s):  
S. Cusack ◽  
J.-C. Jésior
Keyword(s):  
Three Dimensional ◽  
Molecular Shape ◽  
Biological Molecules ◽  
Fourier Space ◽  
Single Particles ◽  
Thin Sections ◽  
Standard Methods ◽  
X Ray ◽  
X Ray Crystallography ◽  
Dimensional Reconstruction

Three-dimensional reconstruction techniques using electron microscopy have been principally developed for application to 2-D arrays (i.e. monolayers) of biological molecules and symmetrical single particles (e.g. helical viruses). However many biological molecules that crystallise form multilayered microcrystals which are unsuitable for study by either the standard methods of 3-D reconstruction or, because of their size, by X-ray crystallography. The grid sectioning technique enables a number of different projections of such microcrystals to be obtained in well defined directions (e.g. parallel to crystal axes) and poses the problem of how best these projections can be used to reconstruct the packing and shape of the molecules forming the microcrystal.Given sufficient projections there may be enough information to do a crystallographic reconstruction in Fourier space. We however have considered the situation where only a limited number of projections are available, as for example in the case of catalase platelets where three orthogonal and two diagonal projections have been obtained (Fig. 1).

Ultrastructural Localization of Phycocyanin in the Acidophilic, Thermophilic Alga, Cyanidium Caldarium

1973 ◽  
Vol 31 ◽  
pp. 462-463
Author(s):  
M. R. Edwards ◽  
J. D. Mainwaring
Keyword(s):  
Yellowstone National Park ◽  
National Park ◽  
Ultrastructural Localization ◽  
Review Of Literature ◽  
Cyanidium Caldarium ◽  
Taxonomic Rank ◽  
Thin Sections ◽  
Standard Methods ◽  
Laboratory Cultures

Although the general ultrastructure of Cyanidium caldarium, an acidophilic, thermophilic alga of questionable taxonomic rank, has been extensively studied (see review of literature in reference 1), some peculiar ultrastructural features of the chloroplast of this alga have not been noted by other investigators.Cells were collected and prepared for thin sections at the Yellowstone National Park and were also grown in laboratory cultures (45-52°C; pH 2-5). Fixation (glutaraldehyde-osmium), dehydration (ethanol), and embedding (Epon 812) were accomplished by standard methods. Replicas of frozenfracture d- etched cells were obtained in a Balzers apparatus. In addition, cells were examined after disruption in a French Press.

A Device for Magnification Measurement

1972 ◽  
Vol 30 ◽  
pp. 622-623
Author(s):  
J.A. Eades ◽  
A. van Dun
Keyword(s):  
Electron Microscope ◽  
Small Displacement ◽  
Private Communication ◽  
Piezoelectric Crystal ◽  
Double Exposure ◽  
Standard Methods ◽  
Elegant Method ◽  
The Right ◽  
Piezo Electric

The measurement of magnification in the electron microscope is always troublesome especially when a goniometer stage is in use, since there can be wide variations from calibrated values. One elegant method (L.M.Brown, private communication) of avoiding the difficulties of standard methods would be to fit a device which displaces the specimen a small but known distance and recording the displacement by a double exposure. Such a device would obviate the need for changing the specimen and guarantee that the magnification was measured under precisely the conditions used.Such a small displacement could be produced by any suitable transducer mounted in one of the specimen translation mechanisms. In the present case a piezoelectric crystal was used. Modern synthetic piezo electric ceramics readily give reproducible displacements in the right range for quite modest voltages (for example: Joyce and Wilson, 1969).

The Repair and Healing of Two Traumatic Ilial Body Fractures Adjacent to Cemented Total Hip Acetabular Components

1992 ◽  
Vol 05 (02) ◽  
pp. 85-89
Author(s):  
P. K. Shires ◽  
T. L. Dew
Keyword(s):  
Internal Fixation ◽  
Cancellous Bone ◽  
Surgical Techniques ◽  
Autogenous Bone ◽  
Cancellous Bone Graft ◽  
Standard Methods ◽  
Intravenous Antibiotics ◽  
Prophylactic Use ◽  
Acetabular Components ◽  
Autogenous Bone Grafts

SummaryThis report has documented the repair and healing of two ilial fractures in dogs which were compounded by the presence of a cemented acetabular prosthesis. While specific recommendations can not be made from such a small number of cases, the information presented herein suggests that such fractures will heal without complication if aseptic surgical techniques and standard methods of internal fixation are employed. The authors strongly recommend the prophylactic use of intravenous antibiotics and the placement of cancellous bone graft when the repair of such fractures is attempted.Two traumatic ilial fractures involving the cement/bone interface of acetabular prostheses were repaired using lag screws, cerclage wires, and autogenous bone grafts. The fractures healed and ambulatory function was regained.

Kinetic Aspects of the Interaction of Blood Clotting Enzymes

1965 ◽  
Vol 13 (01) ◽  
pp. 155-175 ◽  
Author(s):  
H. C Hemker ◽  
P.W Hemker ◽  
E. A Loeliger
Keyword(s):  
Kinetic Analysis ◽  
Enzyme Kinetics ◽  
Blood Clotting ◽  
Enzyme System ◽  
Enzyme Kinetic ◽  
Clotting Time ◽  
Standard Methods

SummaryApplication of the methods of enzyme-kinetic analysis to the results of clotting tests is feasible and can yield useful results. However, the standard methods of enzyme kinetics are not applicable without modifications imposed by the peculiarities of the blood-clotting enzyme system. The influence of the following complicating circumstances is calculated :1. Substrate is not present in excess.2. Only relative measures exist for concentrations of substrate or enzymes.3. Enzymes and substrates are often added together.4. Reagents are not pure.5. Clotting-time is our only measure for clotting-velocity.Formulas are deduced, which makes it possible to recognize the effect of these complications.

A Novel Method for the Rapid Purification of Human and Rat Fibrin(OGEN) Degradation Products in High Yields

1979 ◽  
Author(s):  
W. Nieuwenhuizen ◽  
I. A. M. van Ruijven-Vermeer ◽  
F. Haverkate ◽  
G. Timan
Keyword(s):  
Degradation Products ◽  
Complete Separation ◽  
Purification Method ◽  
Amino Terminal ◽  
Novel Method ◽  
Rapid Purification ◽  
The One ◽  
High Yields ◽  
Size Heterogeneity ◽  
D Dimer

A novel method will be described for the preparation and purification of fibrin(ogen) degradation products in high yields. The high yields are due to two factors. on the one hand an improved preparation method in which the size heterogeneity of the degradation products D is strongly reduced by plasmin digestion at well-controlled calcium concentrations. At calcium concentrations of 2mM exclusively D fragments, M.W.= 93-000 (Dcate) were formed; in the presence of 1OmM EGTA only fragments M.W.= 80.000 (D EGTA) were formed as described. on the other hand a new purification method, which includes Sephadex G-200 filtration to purify the D:E complexes and separation of the D and E fragments by a 16 hrs. preparative isoelectric focussing. The latter step gives a complete separation of D (fragments) (pH = 6.5) and E fragments (at pH = 4.5) without any overlap, thus allowing a nearly 100% recovery in this step. The overall recoveries are around 75% of the theoretical values. These recoveries are superior to those of existing procedures. Moreover the conditions of this purification procedure are very mild and probably do not affect the native configuration of the products. Amino-terminal amino acids of human Dcate, D EGTA and D-dimer are identical i.e. val, asx and ser. in the ratgly, asx and ser were found. E 1% for rat Dcate=17-8 for rat D EGTA=16.2 and for rat D- dimer=l8.3. for the corresponding human fragments, these values were all 20.0 ± 0.2.

Non-standard methods for converting numbers from one number system to another

2020 ◽  
Vol 1 (9) ◽  
pp. 28-30
Author(s):  
D. M. Zlatopolski
Keyword(s):  
Binary System ◽  
Maximum Degree ◽  
Number System ◽  
Binary Form ◽  
Binary Number ◽  
Standard Methods ◽  
Optimal Variant ◽  
Decimal System ◽  
Large Numbers ◽  
Independent Work

The article describes a number of little-known methods for translating natural numbers from one number system to another. The first is a method for converting large numbers from the decimal system to the binary system, based on multiple divisions of a given number and all intermediate quotients by 64 (or another number equal to 2n ), followed by writing the last quotient and the resulting remainders in binary form. Then two methods of mutual translation of decimal and binary numbers are described, based on the so-called «Horner scheme». An optimal variant of converting numbers into the binary number system by the method of division by 2 is also given. In conclusion, a fragment of a manuscript from the beginning of the late 16th — early 17th centuries is published with translation into the binary system by the method of highlighting the maximum degree of number 2. Assignments for independent work of students are offered.

Economic and Legal Support for Commercialization of Intellectual Property in Russia

2003 ◽  
pp. 66-76
Author(s):  
I. Dezhina ◽  
I. Leonov
Keyword(s):  
Intellectual Property ◽  
The State ◽  
Commercial Application ◽  
The West ◽  
Role Of The State ◽  
Legal Context

The article is devoted to the analysis of the changes in economic and legal context for commercial application of intellectual property created under federal budgetary financing. Special attention is given to the role of the state and to comparison of key elements of mechanisms for commercial application of intellectual property that are currently under implementation in Russia and in the West. A number of practical suggestions are presented aimed at improving government stimuli to commercialization of intellectual property created at budgetary expense.

Sign in / Sign up

Export Citation Format

Share Document