Impact of levels of nitrogen fertilizer and types of irrigation water on yield and yield components of barley crop

2021 ◽  
Vol 3 (1) ◽  
pp. 72-84
Author(s):  
M.A. Ali ◽  
E.A. Abd El-Lattief ◽  
R. Khalaphallah ◽  
S.S. Mohamed
Author(s):  
Nasratullah Habibi ◽  
Friba Sikandari

An experiment was conducted to evaluate effect of urea fertilizer on yield and yield components of Zea mays L. Using Randomized Complete Block Design (RCBD) split plots in three replications in agricultural research farm of Balkh University by 2019. Doses of urea used in this experiment were 0, 80, 160 and 240 kg ha-1 , respectively. It has been found that amount of nitrogen fertilizer (urea) had significant effect on yield of maize at p<0.05. The higher level of nitrogen caused the higher grain yield, number of kernels per ear, the number of grains per ear row, ear diameter, cob length, grain per plant and plant height. As a result 7.76 ton ha-1 was recorded as high yield while 240 kg ha-1 urea was used, and 5.12 ton ha-1 was recorded as low yield in treatment one with 0 kg ha-1 of nitrogen fertilizer. Finally, as a result using 240 kg ha-1 nitrogen fertilizer is recommended.


2021 ◽  
Vol 2021 ◽  
pp. 1-7
Author(s):  
Zerihun Sinta ◽  
Gezahegn Garo

Ethiopia is endowed with diverse agroecologies suitable for the production of tropical, subtropical, and temperate vegetables. Agronomic practices such as plant density and fertilizer management are known to affect the crop environment, which influences the growth and ultimately the yield. So far limited research has been done on plant density determination and rate of nitrogen fertilizer in Ethiopia in general and the study area in particular. Thus, this experiment was carried out to evaluate the influence of plant density and nitrogen fertilizer rates on the yield and yield components of beetroot (Beta vulgaris L.). Four plant densities (133 333, 100 000, 80 000, and 66 666 plants per hectare) and four nitrogen (N) fertilizer rates (0, 46, 92, and 138 kg N ha−1) were arranged in a factorial combination in a randomized complete block design with three replications. The results revealed that the main and interaction effects of plant density and nitrogen fertilizer rates on total root yield, root length, root fresh weight, root diameter, and total soluble solute of beetroot were significant. The highest root yield of beetroot was achieved from the combination of 66 666, 80 000, and 10 0000 plant ha−1 with 92 kg N ha−1, whereas the lowest root yield of beet was obtained from the combination of 0 kg N ha−1 with a planting density of 133 333 plants ha−1. The economic analysis showed that higher net benefit and marginal rate of return were obtained from the application of 92 kg N ha−1 with plant densities of 66 666 plants ha−1. In order to prevent excessive production costs, the use of 66 666 plants ha−1 combined with the application of 92 kg N ha−1 is recommended.


2020 ◽  
Vol 66 (No. 2) ◽  
pp. 43-51
Author(s):  
Harby Mostafa

An experiment was conducted for two seasons on a farm in the Mit Kenana village, Qalyobia, Egypt. The aim was to study the influence of a magnetised water technology on the fertilisers during irrigation (fertigation) and its impact on the water, soil as well as the yield and yield components for potatoes. The experiment included: Normal water (NM), magnetic water (MW), adding fertiliser before (FMW) and after magnetism (MWF). The results indicated that irrigation with magnetised water and then adding fertiliser (MWF) had a positive significant effect on the water and soil properties, the tuber engineering parameters improved and the potato productivity increased by 40.5% higher than the NM method.<br />The fertigation unit has to be installed after the magnetic device because the direct magnetisation of the water with the fertilisers contributes to the cracking and increases the solubility of the fertilisers that may lead to the possibility of leaching some of them away from the roots, which implies losing some of them and, therefore, decreasing the effectiveness of the fertilisers


2017 ◽  
Vol 38 (4Supl1) ◽  
pp. 2409
Author(s):  
Mohammad Ali Aboutalebian ◽  
Masoumeh Malmir

In order to study interaction between mycorrhiza and bradyrhizobium on yield of soybean under different amounts of starter nitrogen fertilizer, a field experiment was conducted at the agricultural research station, Bu-Ali Sina University in 2015 growing season. A factorial experiment based on randomized complete block design was arranged with three replications. Experiment factors covering three levels of starter nitrogen of 0, 30 and 60 kg ha-1, bradyrhizobiumin two level of inoculated and non-inoculated and mycorrhiza including application and non-application levels. Results indicated that plant height, number of leaves per plant, yield and yield components and biological yield and mycorrhizal symbiosis percent affected by interaction of studied factors significantly. Maximum number of pod per plant achieved from combination of 30 kg Nitrogen and bradyrhizobium. Also both bio-fertilizer was able to increase number of pod per plant. Maximum 1000 seed weight obtained from inoculation of plants with bradyrhizobium and mycorrhiza simultaneously with no nitrogen utilization. Application of 60 kg ha-1 nitrogen caused to decreased mycorrhizal symbiosis about 20.22 percent in comparison with no use of starter fertilizer. Application bradyrhizobium and mycorrhiza under the application of 30 kg ha-1 nitrogen, produced the highest grain yield (511.67 g m-2) and biological yield (1223.16 g m-2).


Author(s):  
Tamirat Wato

Teff [Eragrostis tef (Zucc.) Trotter] is the main staple food of Ethiopia. It ranks the first among cereals in the country in area coverage and second in the production volume; however, its productivity is almost stagnant. The Quncho (Dz-Cr-387) teff variety was sown during the main cropping season of 2017 at the Limo District, Southern Ethiopia. The objective of this research was to study the effect of four nitrogen fertilizer rates (0, 32.5, 65 and 97.5 kg N/ha) and three inter-row spacings (15, 20 and 25 cm), to evaluate the effects on yield and yield components of teff and to identify the economically appropriate nitrogen rates and inter-row spacing that maximize the yield of teff. A factorial experiment was laid out in Randomized Complete Block Design (RCBD) with 12 treatment combinations and three replications. Phenological and yield-related parameters were measured. The main effects of N rate and inter-row spacing showed significant differences (P≤0.05) for all yield and yield components. The effects of N rate by inter-row spacing interaction were not significant for some traits except for the lodging index, biomass yield, grain yield, and straw yield and harvest index. Application of N rate at 97.5 kg/ha and inter-row spacing with 25 cm significantly (P≤0.01) increased grain yield of teff. Moreover, both N fertilizer rates and wider inter-row spacing increased the magnitudes of the important yield attributes including plant height, panicle length, number of effective tillers per plant, thousand seed weight, biomass yield and straw yield significantly (P≤0.01) and also inter-row spacing increased the magnitudes of important yield attributes significance (P≤0.05). From the results of the study, it is possible to conclude that increased application of nitrogen fertilizer rate and row spacing improves yield and yield components of teff. Therefore, the application of 97.5 kg N/ha and inter-row spacing of 25 cm gave maximum yield which can be recommended for the study area.


Author(s):  
Kaveh Sabokrow Foomani ◽  
Seyed Alireza Valad Abadi ◽  
Masood Kavoosi ◽  
Hamidreza Zakerin ◽  
Mohammadreza Yazdani

Sign in / Sign up

Export Citation Format

Share Document