Potential of activated sludge disintegration

2006 ◽  
Vol 53 (12) ◽  
pp. 207-216 ◽  
Author(s):  
M. Boehler ◽  
H. Siegrist
Keyword(s):  
Sewage Sludge ◽  
Cost Evaluation ◽  
Anoxic Zone ◽  
Excess Sludge ◽  
Solid Retention Time ◽  
Biological Sludge ◽  
Operating Stability ◽  
Agricultural Use ◽  
Sludge Ash ◽  
Sludge Production

The disposal of sewage sludge and the agricultural use of stabilised sludge are decreasing due to more stringent regulations in Europe. An increasing fraction of sewage sludge must therefore be dewatered, dried, incinerated and the ashes disposed of in landfills. These processes are cost-intensive and also lead to the loss of valuable phosphate resources incorporated in the sludge ash. The implementation of processes that could reduce excess sludge production and recycle phosphate is therefore recommended. Disintegration of biological sludge by mechanical, thermal and physical methods could significantly reduce excess sludge production, improve the settling properties of the sludge and reduce bulking and scumming. The solubilised COD could also improve denitrification if the treated sludge is recycled to the anoxic zone. However, disintegration partly inhibits and kills nitrifiers and could therefore shorten their effective solid retention time, thus reducing the safety of the nitrification. This paper discusses the potential of disintegration on sludge reduction, the operating stability of nitrification, the improvement of denitrification and also presents an energy and cost evaluation.

Potential of activated sludge ozonation

2007 ◽  
Vol 55 (12) ◽  
pp. 181-187 ◽  
Author(s):  
M. Boehler ◽  
H. Siegrist
Keyword(s):  
Sewage Sludge ◽  
Activated Sludge ◽  
Cost Evaluation ◽  
Anoxic Zone ◽  
Excess Sludge ◽  
Solid Retention Time ◽  
Operating Stability ◽  
Agricultural Use ◽  
Sludge Ash ◽  
Sludge Production

The disposal of sewage sludge and the agricultural use of stabilised sludge are decreasing due to more stringent regulations in Europe. An increasing fraction of sewage sludge must therefore be dewatered, dried, incinerated and the ashes disposed of in landfills. These processes are cost-intensive and also lead to the loss of the valuable phosphate resources incorporated in the sludge ash. The implementation of processes that could reduce excess sludge production and recycle phosphate is therefore recommended. Partial ozonation of the return sludge of an activated sludge system significantly reduces excess sludge production, improves the settling properties of the sludge and reduces bulking and scumming. The solubilised COD will also improve denitrification if the treated sludge is recycled to the anoxic zone. However, ozonation partly kills nitrifiers and could therefore lead to a decrease of the effective solid retention time of the nitrifier, thus reducing the safety of the nitrification. This paper discusses the effect of ozonation on sludge reduction, the operating stability of nitrification, the improvement of denitrification and also presents an energy and cost evaluation.

Partial ozonation of activated sludge to reduce excess sludge, improve denitrification and control scumming and bulking

2004 ◽  
Vol 49 (10) ◽  
pp. 41-49 ◽  
Author(s):  
M. Böhler ◽  
H. Siegrist
Keyword(s):  
Activated Sludge ◽  
Cost Evaluation ◽  
Anoxic Zone ◽  
Excess Sludge ◽  
Solid Retention Time ◽  
Operation Stability ◽  
Agricultural Use ◽  
Sludge Ash ◽  
And Control ◽  
Sludge Production

Disposal of sewage sludge is forbidden and agricultural use of stabilized sludge will be banned in 2005 in Switzerland. The sludge has to be dewatered, dried, incinerated and the ashes disposed in landfills. These processes are cost intensive and lead also to the loss of valuable phosphate resources incorporated in the sludge ash. The implementation of processes that could reduce excess sludge production and recycle phosphate is therefore recommended. Partial ozonation of the return sludge of an activated sludge system reduces significantly excess sludge production, improves settling properties of the sludge and reduces bulking and scumming. The solubilized COD will also improve denitrification if the treated sludge is recycled to the anoxic zone. But ozonation will partly inhibit and kill nitrifiers and might therefore lead to a decrease of the effective solid retention time of the nitrifier, which reduces the safety of the nitrification. This paper discusses the effect of ozonation on sludge reduction, the operation stability of nitrification, improvement of denitrification and gives also an energy and cost evaluation.

Biological sludge solubilisation for reduction of excess sludge production in wastewater treatment process

2006 ◽  
Vol 54 (5) ◽  
pp. 51-58 ◽  
Author(s):  
T. Yamaguchi ◽  
Y. Yao ◽  
Y. Kihara
Keyword(s):  
Wastewater Treatment ◽  
Biological Treatment ◽  
Wastewater Treatment Plants ◽  
Experimental Period ◽  
Excess Sludge ◽  
Wastewater Treatment Process ◽  
Biological Sludge ◽  
Scale Experiment ◽  
Sludge Production

A novel sludge disintegration system (JFE-SD system) was developed for the reduction of excess sludge production in wastewater treatment plants. Chemical and biological treatments were applied to disintegrate excess sludge. At the first step, to enhance biological disintegration, the sludge was pretreated with alkali. At the second step, the sludge was disintegrated by biological treatment. Many kinds of sludge degrading microorganisms integrated the sludge. The efficiency of the new sludge disintegration system was confirmed in a full-scale experiment. The JFE-SD system reduced excess sludge production by approximately 50% during the experimental period. The quality of effluent was kept at quite a good level. Economic analysis revealed that this system could significantly decrease the excess sludge treatment cost.

Effect of NaCl and MgCl2 on the hydration of lime-pozzolan blend by recycling sewage sludge ash

2021 ◽  
pp. 127759
Author(s):  
Yifan Zhou ◽  
Jianxin Lu ◽  
Jiangshan Li ◽  
Chris Cheeseman ◽  
Chi Sun Poon
Keyword(s):  
Sewage Sludge ◽  
Sewage Sludge Ash ◽  
Sludge Ash

scholarly journals Applying Mixture of Municipal Incinerator Bottom Ash and Sewage Sludge Ash for Ceramic Tile Manufacturing

Materials ◽  
2021 ◽  
Vol 14 (14) ◽  
pp. 3863
Author(s):  
Deng-Fong Lin ◽  
Wei-Jhu Wang ◽  
Chia-Wen Chen ◽  
Kuo-Liang Lin
Keyword(s):  
Wear Resistance ◽  
Sewage Sludge ◽  
Water Absorption ◽  
Ceramic Tile ◽  
Bending Strength ◽  
Bottom Ash ◽  
Waste Materials ◽  
Sewage Sludge Ash ◽  
Kiln Temperature ◽  
Sludge Ash

Municipal incinerator bottom ash (MIBA) and sewage sludge ash (SSA) are secondary wastes produced from municipal incinerators. Landfills, disposal at sea, and agricultural use have been the major outlets for these secondary wastes. As global emphasis on sustainability arises, many have called for an increasing reuse of waste materials as valuable resources. In this study, MIBA and SSA were mixed with clay for ceramic tile manufacturing in this study. Raw materials firstly went through TCLP (Toxicity Characteristic Leaching Procedure) to ensure their feasibility for reuse. From scanning electron microscopy (SEM), clay’s smooth surface was contrasted with the porous surface of MIBA and SSA, which led to a higher water requirement for the mixing. Specimens with five MIBA mix percentages of 0%, 5%, 10%, 15%, and 20% (wt) and three SSA mix percentages of 0%, 10%, and 20% (wt) were made to compare how the two waste materials affected the quality of the final product and to what extent. Shrinkage tests showed that MIBA and SSA contributed oppositely to tile shrinkage, as more MIBA reduced tile shrinkage, while more SSA encouraged tile shrinkage. However, as the kiln temperature reached 1150 °C, the SiO2-rich SSA adversely reduced the shrinkage due to the glass phase that formed to expand the tile instead. Both MIBA and SSA increased water tile absorption and reduced its bending strength and wear resistance. Increasing the kiln temperature could effectively improve the water absorption, bending strength, and wear resistance of high MIBA and SSA mixes, as SEM showed a more compact structure at higher temperatures. However, when the temperature reached 1100 °C, more pores appeared and seemingly exhausted the benefit brought by the higher temperature. Complex interactions between kiln temperature and MIBA/SSA mix percentage bring unpredictable performance of tile shrinkage, bending strength, and water absorption, which makes it very challenging to create a sample meeting all the specification requirements. We conclude that a mix with up to 20% of SSA and 5% of MIBA could result in quality tiles meeting the requirements for interior or exterior flooring applications when the kiln temperature is carefully controlled.

Determination of Phosphate Phases in Sewage Sludge Ash-Based Fertilizers by Raman Microspectroscopy

2013 ◽  
Vol 67 (9) ◽  
pp. 1101-1105 ◽  
Author(s):  
Christian Vogel ◽  
Christian Adam ◽  
Don McNaughton
Keyword(s):  
Sewage Sludge ◽  
Raman Microspectroscopy ◽  
Sewage Sludge Ash ◽  
Sludge Ash
Sign in / Sign up

Export Citation Format

Share Document