scholarly journals Potential hazards of compressed air energy storage in depleted natural gas reservoirs.

2011 ◽  
Author(s):  
Paul W. Cooper ◽  
Mark Charles Grubelich ◽  
Stephen J. Bauer
2019 ◽  
pp. 1-14 ◽  
Author(s):  
Amin Amirlatifi ◽  
Farshid Vahedifard ◽  
Maria Degtyareva ◽  
Richard N Turner ◽  
Brian Sullivan ◽  
...  

2019 ◽  
Vol 11 (4) ◽  
pp. 869-877
Author(s):  
Mahdi Naji Aghakhanloo ◽  
Mohsen Akef Ghalehni ◽  
Ali Naji Aghakhanloo

Author(s):  
Shreyas M. Patel ◽  
Paul T. Freeman ◽  
John R. Wagner

Non-renewable energy sources such as coal, oil, and natural gas are being consumed at a brisk pace while greenhouse gases contribute to atmospheric pollution. A global shift is underway toward the inclusion of renewable energy sources, such as solar and wind, for generating electrical and mechanical power. To meet this emerging demand, a solar based electrical microgrid study is underway at Clemson University. Solar energy is harvested from photovoltaic panels capable of producing 15 kW of DC power. Compressed air energy storage has been evaluated using the generated solar power to operate an electric motor driven piston compressor. The compressed air is then stored under pressure and supplied to a natural gas driven Capstone C30 MicroTurbine with attached electric power generator. The compressed air facilitates the turbine’s rotor-blade operated compression stage resulting in direct energy savings. A series of mathematical models have been developed. To evaluate the feasibility and energy efficiency improvements, the experimental and simulation results indicated that 127.8 watts of peak power was delivered at 17.5 Volts and 7.3 Amps from each solar panel. The average power generation over a 24-hour time period from 115 panels was 15 kW DC or 6 kW of AC power at 208/240 VAC and 25 Amps from the inverter. This electrical power could run a 5.2 kW reciprocating compressor for approximately 5 hours storing 1,108 kg of air at a 1.2 MPa pressure. A case study indicated that the microturbine, when operated without compressed air storage, consumed 11.2 kg of gaseous propane for 30 kW·hr of energy generation. In contrast, the microturbine operated in conjunction with solar supplied air storage could generate 50.8 kW·hr of electrical energy for a similar amount of fuel consumption. The study indicated an 8.1% efficiency improvement in energy generated by the system which utilized compressed air energy storage over the traditional approach.


Author(s):  
Mohd Suleman

In the present work, Hybrid fuel storage system of compressed air is an extensive technology that provides long duration energy storage. It is encouraged in balancing the large scale penetration of intermittent and dispersed sources of power. Such as wind and solar power into electric grids .The existing Compressed air energy storage (CAES) plants utilize natural gas as fuel. In this project we are replacing the natural gas with the composition of air (15 bar), copper oxide (5-20%), and water (50%). validated with the results obtained using Computational Fluid Dynamics (CFD) analysis. Modeling of energy storage tank is done in Computer Aided Three Dimensional Interactive Application (CATIA) software, mesh has been created using ANSYS workbench software and Analysis is done in Fluent Software. The composition is sent from the inlet of the energy storage tank and temperatures are varied like 298k, 373k, 423k, and 473k. Velocities are also varied like 15m/s, 25m/s, 35m/s, 45m/s. This hybrid fuel storage deals with phase change material by using water and copper by heating at different temperatures to get the energy and re-utilized. This device is applicable for renewable energy application to avoid the heat losses new technique of energy saving in suitable forms. This has the lead to the emergence of fuel storage as a management of energy and allowing it to various levels of energy storage. In many parts of the world this storage of energy plays an important role and a new technique of energy saving in suitable forms. This has the lead to the emergence of fuel storage as a management of energy and allowing it to various levels of energy storage.


Author(s):  
Jared B. Garrison ◽  
Mark Kapner ◽  
Michael E. Webber

Wind and solar technologies have experienced rapid market growth recently as a result of the growing interest for implementation of renewable energy. However, the intermittency of wind and solar power is a major obstacle to their broader use. The additional risks of unexpected interruptions and mismatch with demand have hindered the expansion of these two primary renewable resources. The goal of this research is to analyze an integrated energy system that includes a novel configuration of wind and solar coupled with two storage methods to make both wind and solar sources dispatchable during peak demand, thereby enabling their broader use. The proposed system utilizes compressed air energy storage (CAES) that is driven from wind energy and thermal storage supplied by concentrated solar thermal power in order to achieve this desired dispatchability. While current CAES facilities use off peak electricity to power their compressors, this system uses power from wind turbines to compress air to high pressure for storage. Also, rather than using natural gas for heating of the compressed air before its expansion through a turbine, which it typical for conventional systems, the system described in this paper replaces the use of natural gas with solar thermal energy and thermal storage. Through a thermodynamic and a levelised lifetime cost analysis we have been able to develop estimates of the power system performance and the cost of energy for this integrated wind-solar-storage system. What we found is that the combination of these components resulted in an efficiency of over 50% for the main power components. We also estimated that the overall system is more expensive per unit of electricity generated than two of the current technologies employed today, namely coal and nuclear, but cheaper than natural gas peaking units. However, this economic analysis, though accurate with regard to the technologies chosen, will not be complete until cost values can be placed on some of the externalities associated with power generation such as fuel cost volatility, national security, and emissions.


Sign in / Sign up

Export Citation Format

Share Document