INTRODUCTION OF NUTRIENTS REMOVAL TECHNOLOGIES AT THE MOSCOW WASTEWATER TREATMENT FACILITIES

2007 ◽  
Vol 2007 (2) ◽  
pp. 1177-1192
Author(s):  
S.V. Khramenkov ◽  
A.N. Pakhomov ◽  
D.A. Danilovich ◽  
M.N. Kozlov ◽  
O.V. Moyzhes
Author(s):  
М.В. Кевбрина ◽  
А.М. Гаврилин ◽  
А.А. Пронин

Рассмотрен опыт внедрения современных технологий очистки сточных вод на очистных сооружениях г. Москвы, описаны технологические схемы для сооружений разной производительности. С конца 1990-х годов Инженерно-технологическим центром АО «Мосводоканал» проводились работы по разработке и внедрению современных технологий очистки сточных вод с удалением биогенных элементов. Поскольку состав сточных вод имеет отличия на разных очистных сооружениях, не удается «перенести» зарубежные технологии без изменения и адаптации, а иногда требуется разработка технологии «с нуля». Более чем за 20-летний период осуществлено поэтапное внедрение современных технологий на московских очистных сооружениях Южного Бутова и Зеленограда, блока удаления биогенных элементов Люберецких очистных сооружений (БУБЭ ЛОС), нового блока Курьяновских очистных сооружений (НКОС). В настоящее время идет реконструкция ЛОС (старый и новый блоки), планируется реконструкция старого блока КОС, в процессе реконструкции находятся очистные сооружения Троицкого и Новомосковского административных округов (ТиНАО) г. Москвы. Опыт АО «Мосводоканал» был использован при разработке справочника наилучших доступных технологий ИТС 10-2015. Разнообразие технологических решений позволяет обеспечить нормативное качество очистки для условий разных сооружений. The experience of introducing advanced technologies for wastewater treatment at the wastewater treatment facilities in Moscow is considered; process flow schemes for the structures of different capacities are described. Since the late 1990s, the Engineering and Technology Center of Mosvodokanal JSC has been working on the development and introduction of advanced wastewater treatment technologies with the removal of nutrients. Since the composition of wastewater differs at different treatment facilities, it is not possible to "transfer" foreign technologies without correction and adaptation; moreover, sometimes the development of technology "from square one" is required. For more than 20 years, a stepwise introduction of advanced technologies has been carried out at the Moscow treatment facilities of South Butovo and Zelenograd, at the nutrients removal block at the Lyuberetskie wastewater treatment facilities, at the new block of the Kurianovskie Wastewater Treatment Facilities. At present, the reconstruction of the Lyuberetskie Wastewater Treatment Facilities (old and new blocks) is underway, the reconstruction of the old part of the Kurianovskie Wastewater Treatment Facilities is planned, the treatment facilities of the Troitsk and Novomoskovsk administrative districts in Moscow have been under upgrade. The experience of Mosvodokanal JSC was used in the development of an ITS 10-2015 reference book of the best available technologies. A variety of process solutions provides for ensuring the standard quality of effluent for the conditions of different facilities.


Author(s):  
G. Variushina

Приводятся сведения об условиях формирования, объемах, химическом составе и свойствах осадков очистных сооружений производственных сточных вод автотранспортных предприятий. Даны примеры технологических решений по обезвоживанию образующихся в процессе очистки шламов. Рассмотрены технологические аспекты процесса интенсификации механического обезвоживания уплотненных осадков с использованием высокомолекулярных полиэлектролитов. Представлены данные лабораторных экспериментов по выбору типа флокулянта, его дозы, технологических параметров процесса, а также результаты определения влажности обезвоженных осадков, полученные на модели барабанного вакуум-фильтра. Приведены примеры эффективных обезвоживающих аппаратов отечественного производства и их технические характеристики, рекомендации и критерии их выбора, а также факторы, оказывающие влияние на эксплуатационные параметры обезвоживающего оборудования. Установлено, что наилучшая обезвоживающая способность барабанных вакуум-фильтров (остаточная влажность шламов от 66 до 83) может быть достигнута при применении катионного флокулянта ВПК-402 для осадков различных производственных цехов автотранспортного предприятия.Information on the conditions of generation, volumes, chemical composition and properties of sludge generated at the industrial wastewater treatment facilities of motor transport enterprises is provided. Examples of process engineering solutions for dewatering sludge generated during the wastewater treatment process are given. The technological aspects of enhancing mechanical dewatering of thickened sludge using high-molecular polyelectrolytes are considered. The data of laboratory experiments on choosing the type of flocculant, its dose, technological parameters of the process, as well as the results of determining the moisture content of dewatered sludge obtained in a model of a drum vacuum filter are presented. Examples of effective domestically produced dewatering apparatus and their technical characteristics, recommendations and criteria for their selection, as well as factors influencing the operational parameters of the dewatering equipment are given. It is found that the highest dewatering capacity of drum vacuum filters (residual sludge moisture content from 66 to 83) can be achieved by using VPK-402 cationic flocculant for processing sludge generated at the workshop premises of a motor transport enterprise.


Author(s):  
G. Variushina

Приводятся сведения о разработанных специалистами АО МосводоканалНИИпроект научных исследованиях и проектных решениях в области очистки поверхностных сточных вод с территории Москвы, причинах загрязнения водоисточников неочищенными поверхностными стоками в 1970х годах. Представлены основные характеристики комплексов глубокой очистки поверхностных стоков, разработанных проектов очистных сооружений для промышленных предприятий с площадью водосбора 0,3 1 5 10 и 15 га. Показано, что эффективность очистки поверхностных сточных вод соответствует требованиям, предъявляемым к водоемам рыбохозяйственного значения. При этом для обезвоживания осадка, образующегося в накопительном резервуаре очистных сооружений, в технологической схеме предусмотрена песковая площадка, а для сбора плавающих нефтепродуктов нефтеразделитель. Новизна разработанной технологии обезвреживания поверхностного стока и обработки осадка была подтверждена пятью патентами РФ, одобрена Госстроем РФ, Центральным управлением по рыбохозяйственной экспертизе и нормативам по сохранению, воспроизводству водных биологических ресурсов и акклиматизации, Городской санитарной службой Москвы и области, службами Москомприроды и Мосгосэкспертизы. Показан вклад специалистов лаборатории обработки природных, промышленнодождевых сточных вод и осадка в решение проблем очистки поверхностного стока. Приведена информация об истории развития и перспективных направлениях научной деятельности лаборатории, ее планах в организационнометодической и воспитательной работе с молодыми специалистами.Information on the research and design solutions developed by the experts of MosvodokanalNIIproject JSC in the field of surface runoff treatment from the territory of Moscow, the causes of water sources pollution with raw surface runoff in the 1970s. The basic characteristics of the complexes for the enhanced treatment of surface runoff, the developed projects of wastewater treatment facilities for industrial enterprises with a catchment area of 0.3 1 5 10 and 15 ha. It is shown that the effectiveness of surface runoff treatment meets the requirements to water bodies of commercial fishing importance. At the same time, for dewatering of sludge generated in the retention basin of wastewater treatment facilities, a grit dewatering bay is included into the process flow scheme, and an oil separator is used to collect floating oil products. The novelty of the developed technology for neutralization of surface runoff and sludge treatment has been acknowledged by five patents of the Russian Federation, approved by Gosstroy of the Russian Federation, the Central Department of Fisheries Examination and Review and Protection and Renewal and Acclimatization Standards, the Moscow City and Moscow Region Sanitary Service, Moskompriroda and Mosgosekspertiza services. The contribution of the research workers of the laboratory for the treatment of natural, industrialstorm wastewater and sludge processing to the solution of problems of surface runoff treatment is demonstrated. The information about the history of development and promising areas of research activity of the laboratory, its plans in the organizational, methodological and educational work with young professionals is given.


1993 ◽  
Vol 27 (12) ◽  
pp. 205-208
Author(s):  
Dirk-Th Kollatsch

For upgrading the urban drainage system (UDS) the reduction of pollution impacts is the priority task concerning the environmental protection of the receiving waters. With simulation models the interactions between surface, sewer systems, overflow structures and treatment facilities within the UDS can be shown. Models to simulate the pollutant impacts, transport and the effects on the receiving waters are available. In a first step a pollutant transport model of sewer systems and a model to simulate the wastewater treatment processes are connected. With these models the efficiency of upgrading measures can be checked in all parts of urban drainage systems.


2017 ◽  
Vol 2017 (6) ◽  
pp. 4930-4947 ◽  
Author(s):  
Steven Hanna ◽  
Bruce Dvorak ◽  
Mohamed Dahab ◽  
Matthew Thompson

Sign in / Sign up

Export Citation Format

Share Document