scholarly journals Comparative Study of Performance and Emission Characteristics between Spark Ignition Engine and Homogeneous Charge Compression Ignition Engine (HCCI)

2017 ◽  
Vol 12 (4) ◽  
pp. 102-110
Author(s):  
Nahedh Mahmood Ali
Keyword(s):  
Homogeneous Charge Compression Ignition ◽  
Spark Ignition ◽  
Spark Ignition Engine ◽  
Compression Ignition ◽  
Si Engine ◽  
Compression Ignition Engine ◽  
Promising Alternative ◽  
Performance And Emission ◽  
Hcci Engine ◽  
Homogeneous Charge

Many researchers consider Homogeneous Charge Compression Ignition (HCCI) engine mode as a promising alternative to combustion in Spark Ignition and Compression Ignition Engines. The HCCI engine runs on lean mixtures of fuel and air, and the combustion is produced from the fuel autoignition instead of ignited by a spark. This combustion mode was investigated in this paper. A variable compression ratio, spark ignition engine type TD110 was used in the experiments. The tested fuel was Iraqi conventional gasoline (ON=82). The results showed that HCCI engine can run in very lean equivalence ratios. The brake specific fuel consumption was reduced about 28% compared with a spark ignition engine. The experimental tests showed that the emissions concentrations were reduced by 91.27% for NOx, 85.99% for CO, 78.91% for CO2, and 83.56% for unburned hydrocarbons compared to the SI engine. HCCI engine produced little noise with about 26.68% less than SI engine.

scholarly journals Influence of gas composition on the combustion and efficiency of a homogeneous charge compression ignition engine system fuelled with methanol reformed gases

2008 ◽  
Vol 9 (5) ◽  
pp. 399-408 ◽  
Author(s):  
T Shudo
Keyword(s):  
Homogeneous Charge Compression Ignition ◽  
Waste Heat ◽  
Compression Ignition ◽  
Compression Ignition Engine ◽  
Temperature Oxidation ◽  
Hcci Engine ◽  
Recovery Capacity ◽  
Exhaust Heat ◽  
Engine System ◽  
Homogeneous Charge

A homogeneous charge compression ignition (HCCI) engine system fuelled with dimethyl ether (DME) and methanol-reformed gas (MRG), both produced from methanol by onboard reformers using exhaust heat, has been proposed in previous research. Adjusting the proportions of DME and MRG with different ignition properties effectively controlled the ignition timing and load in HCCI combustion. The use of the single liquid fuel, methanol, also eliminates the inconvenience of carrying two fuels while maintaining the effective ignition control effect. Because reactions producing DME and MRG from methanol are endothermic, a part of the exhaust gas heat energy can be recovered during the fuel reforming. Methanol can be reformed into various compositions of hydrogen, carbon monoxide, and carbon dioxide. The present paper aims to establish the optimum MRG composition for the system in terms of ignition control and overall efficiency. The results show that an increased hydrogen fraction in MRG retards the onset of high-temperature oxidation and permits operation with higher equivalence ratios. However, the MRG composition affects the engine efficiency only a little, and the MRG produced by the thermal decomposition having the best waste-heat recovery capacity brings the highest overall thermal efficiency in the HCCI engine system fuelled with DME and MRG.

A control-oriented hybrid combustion model of a homogeneous charge compression ignition capable spark ignition engine

2012 ◽  
Vol 226 (10) ◽  
pp. 1380-1395 ◽  
Author(s):  
Xiaojian Yang ◽  
Guoming G Zhu
Keyword(s):  
Homogeneous Charge Compression Ignition ◽  
Spark Ignition ◽  
Spark Ignition Engine ◽  
Combustion Model ◽  
Mode Transition ◽  
Compression Ignition ◽  
Combustion Mode ◽  
Combustion Phase ◽  
Compression Ignition Combustion ◽  
Homogeneous Charge

To implement the homogeneous charge compression ignition combustion mode in a spark ignition engine, it is necessary to have smooth mode transition between the spark ignition and homogeneous charge compression ignition combustions. The spark ignition–homogeneous charge compression ignition hybrid combustion mode modeled in this paper describes the combustion mode that starts with the spark ignition combustion and ends with the homogeneous charge compression ignition combustion. The main motivation of studying the hybrid combustion mode is that the percentage of the homogeneous charge compression ignition combustion is a good parameter for combustion mode transition control when the hybrid combustion mode is used during the transition. This paper presents a control oriented model of the spark ignition–homogeneous charge compression ignition hybrid combustion mode, where the spark ignition combustion phase is modeled under the two-zone assumption and the homogeneous charge compression ignition combustion phase under the one-zone assumption. Note that the spark ignition and homogeneous charge compression ignition combustions are special cases in this combustion model. The developed model is capable of simulating engine combustion over the entire operating range, and it was implemented in a real-time hardware-in-the-loop simulation environment. The simulation results were compared with those of the corresponding GT-Power model, and good correlations were found for both spark ignition and homogeneous charge compression ignition combustions.

Combustion and emission characteristics of a homogeneous charge compression ignition engine

2005 ◽  
Vol 219 (9) ◽  
pp. 1133-1139 ◽  
Author(s):  
Hu Tiegang ◽  
Liu Shenghua ◽  
Zhou Longbao ◽  
Zhu Chi
Keyword(s):  
Heat Release ◽  
Homogeneous Charge Compression Ignition ◽  
Cetane Number ◽  
Pressure Rise ◽  
Operating Conditions ◽  
Emission Characteristics ◽  
Compression Ignition ◽  
Compression Ignition Engine ◽  
Hcci Engine ◽  
Homogeneous Charge

Dimethyl ether (DME) is a kind of fuel with high cetane number and low evaporating temperature, which is suitable for a homogeneous charge compression ignition (HCCI) engine. The combustion and emission characteristics of an HCCI engine fuelled with DME were investigated on a modified single-cylinder engine. The experimental results indicate that the HCCI engine combustion is a two-stage heat release process. The engine load or air-fuel ratio has significant effects on the maximum cylinder pressure and its position, the shape of the pressure rise rate and the heat release rate. The engine speed has little effect. A DME HCCI engine is smoke free, with zero NOx and low hydrocarbon and CO emissions under the operating conditions of 0.25–0.30 MPa brake mean effective pressure.

scholarly journals Characterisation of the combustion process in the spark ignition and homogeneous charge compression ignition engine

2018 ◽  
Vol 22 (5) ◽  
pp. 2025-2037
Author(s):  
Ante Vucetic ◽  
Mladen Bozic ◽  
Darko Kozarac ◽  
Zoran Lulic
Keyword(s):  
Homogeneous Charge Compression Ignition ◽  
Spark Ignition ◽  
Operating Conditions ◽  
Compression Ignition ◽  
Combustion Mode ◽  
Hcci Engine ◽  
Combustion Modes ◽  
Mode Of Operation ◽  
Start Of Combustion ◽  
Homogeneous Charge

Homogeneous charge compression ignition (HCCI) engine is a potential solution for reducing air pollution and for satisfying legal limits regarding the emissions from internal combustion engines. The HCCI engines have advantages of lower emissions of NOx and particulate matter, compared to the standard combustion modes, while on the other hand one of the major disadvantages is the difficulty of control of start of combustion, since the start of combustion is highly sensitive to the intake air temperature. Additional advantage of the HCCI engine is the ability to operate with wide range of fuels. In order to demonstrate this potential in this study the HCCI mode of operation is compared to the spark ignition mode of operation. The study aims to compare and characterise two different combustion modes on the same engine with different CR and different fuels at similar operating conditions. For that purpose the engine tests are performed at the same indicated mean effective pressures for the spark ignition and HCCI combustion mode at the same engine speed, while the tests are performed at three different engine speeds and three different loads. The measurements were performed on the experimental set-up that consists of single cylinder Diesel engine modified to enable operation in spark ignition and HCCI modes. The characterisation includes the comparison of in-cylinder pressure, temperature and rate of heat release obtained by spark ignition and homogeneous charge compression ignition combustion mode and presents comparisons of engine efficiencies and of emissions of HC, CO, and NOx.

scholarly journals Study of the Combustion Process of a Homogeneous Charge Compression Ignition (HCCI) Engine and a Partially Premixed Combustion (PPC) Mode of a Compression Ignition Engine Using Natural Gas as an Alternative Fuel

2021 ◽  
Vol 84 (2) ◽  
pp. 98-115
Author(s):  
Saliha Mohammed Belkebir ◽  
Benyoucef Khelidj ◽  
Miloud Tahar-Abbes
Keyword(s):  
Homogeneous Charge Compression Ignition ◽  
Combustion Process ◽  
Flow Simulation ◽  
Premixed Combustion ◽  
Compression Ignition ◽  
Compression Ignition Engine ◽  
Hcci Engine ◽  
Partially Premixed Combustion ◽  
Partially Premixed ◽  
Homogeneous Charge

In order to investigate a viable approach to achieving high efficiencies and low nitrogen oxide (NOX) emissions, this paper presents the application of a homogeneous charge compression ignition (HCCI) engine and the partially premixed combustion (PPC) mode applied to a heavy diesel engine. The effect of carbon dioxide (CO2) fraction on combustion parameters was analyzed and discussed in detail. For this purpose, on the one hand, ANSYS CHEMKIN-Pro software was used to perform simulations of a closed homogeneous reactor under conditions relevant to HCCI engines, and on the other hand, ANSYS-Fluent software was used by adding a CO2 fraction varying from 20% to 58% to methane fuel to study 2D flow simulation by applying a PPC combustion mode to predict the distribution of various output parameters such as in-cylinder temperature, in-cylinder pressure and emissions. In comparison with the two presented models, it was found that the HCCI engine showed a lower NOX level than the PPC mode and this was due to the lower in-cylinder temperature in the HCCI engine.

scholarly journals Performance and Emission Parameters of Homogeneous Charge Compression Ignition (HCCI) Engine: A Review

Energies ◽  
2019 ◽  
Vol 12 (18) ◽  
pp. 3557 ◽  
Author(s):  
M. Mofijur ◽  
M.M. Hasan ◽  
T.M.I. Mahlia ◽  
S.M. Ashrafur Rahman ◽  
A.S. Silitonga ◽  
...  
Keyword(s):  
Homogeneous Charge Compression Ignition ◽  
Engine Performance ◽  
Spark Ignition ◽  
Emission Characteristics ◽  
Compression Ignition ◽  
Combustion Mode ◽  
Performance And Emission ◽  
Hcci Combustion ◽  
Hcci Engines ◽  
Homogeneous Charge

Strict emission regulations and demand for better fuel economy are driving forces for finding advanced engines that will be able to replace the conventional internal combustion engines in the near future. Homogeneous charge compression ignition (HCCI) engines use a different combustion technique; there are no spark plugs or injectors to assist the combustion. Instead, when the mixtures reach chemical activation energy, combustion auto-ignites in multiple spots. The main objective of this review paper is to study the engine performance and emission characteristics of HCCI engines operating in various conditions. Additionally, the impact of different fuels and additives on HCCI engine performance is also evaluated. The study also introduces a potential guideline to improve engine performance and emission characteristics. Compared to conventional compression ignition and spark ignition combustion methods, the HCCI combustion mode is noticeably faster and also provides better thermal efficiency. Although a wide range of fuels including alternative and renewable fuels can be used in the HCCI mode, there are some limitation/challenges, such as combustion limited operating range, phase control, high level of noise, cold start, preparation of homogeneous charge, etc. In conclusion, the HCCI combustion mode can be achieved in existing spark ignition (SI) engines with minor adjustments, and it results in lower oxides of nitrogen (NOx) and soot emissions, with practically a similar performance as that of SI combustion. Further improvements are required to permit extensive use of the HCCI mode in future.

Schlieren-based temperature measurement inside the cylinder of an optical spark ignition and homogeneous charge compression ignition engine

2015 ◽  
Vol 54 (14) ◽  
pp. 4566 ◽  
Author(s):  
Pavlos Aleiferis ◽  
Alexandros Charalambides ◽  
Yannis Hardalupas ◽  
Nikolaos Soulopoulos ◽  
A. M. K. P. Taylor ◽  
...  
Keyword(s):  
Temperature Measurement ◽  
Homogeneous Charge Compression Ignition ◽  
Spark Ignition ◽  
Compression Ignition ◽  
Compression Ignition Engine ◽  
Homogeneous Charge
Sign in / Sign up

Export Citation Format

Share Document