Characterization of Municipal Solid Waste and Evaluation of Subsurface Water Quality In The Vicinity of Dumping Sites

2017 ◽  
Vol V (X) ◽  
pp. 425-431
Author(s):  
Rakesh Kumar Pandey
Keyword(s):  
Water Quality ◽  
Municipal Solid Waste ◽  
Solid Waste ◽  
Subsurface Water

scholarly journals CHARACTERIZATION OF AN EXPERIMENTAL CELL IN A MUNICIPAL SOLID WASTE LANDFILL USING 2-D ELECTRICAL PROFILING TECHNIQUE

2016 ◽  
Vol 34 (4) ◽  
Author(s):  
Antonio Carlos de Siqueira Neto ◽  
Vagner Roberto Elis
Keyword(s):  
Electrical Resistivity ◽  
Municipal Solid Waste ◽  
Solid Waste ◽  
Municipal Solid Waste Landfill ◽  
Waste Landfill ◽  
Experimental Cell ◽  
Resistivity Method ◽  
Electrical Resistivity Method

ABSTRACT. The electrical resistivity method (ER) with the electrical profiling technique (EP) were applied to landfill Delta A, located next to the highway dos Bandeirantes in Campinas (SP). Within the landfill there is a region of approximately 5,200 m2...Keywords: electrical resistivity, landfill, experimental cell. RESUMO. O método de eletrorresistividade (ER) utilizando a técnica de caminhamento elétrico (CE) foi aplicado no aterro Delta A, localizado ao lado da rodovia dos Bandeirantes nomunicípio de Campinas (SP). Dentro do aterro há uma região de...Palavras-chave: resistividade elétrica, aterro sanitário, célula experimental.

scholarly journals Characterization of Refuse Derived Fuel Production from Municipal Solid Waste: The Case Studies in Latvia and Lithuania

2020 ◽  
Vol 24 (3) ◽  
pp. 112-118
Author(s):  
Dace Âriņa ◽  
Rūta Bendere ◽  
Gintaras Denafas ◽  
Jānis Kalnačs ◽  
Mait Kriipsalu
Keyword(s):  
Municipal Solid Waste ◽  
Solid Waste ◽  
Calorific Value ◽  
Ash Content ◽  
Fuel Production ◽  
Heating Value ◽  
Refuse Derived Fuel ◽  
Morphological Composition ◽  
The Mean

AbstractThe authors determined the morphological composition of refuse derived fuel (RDF) produced in Latvia and Lithuania by manually sorting. The parameters of RDF (moisture, net calorific value, ash content, carbon, nitrogen, hydrogen, sulphur, chlorine, metals) was determined using the EN standards. Comparing obtained results with data from literature, authors have found that the content of plastic is higher but paper and cardboard is lower than typical values. Results also show that the mean parameters for RDF can be classified with the class codes: Net heating value (3); chlorine (3); mercury (1), and responds to limits stated for 3rd class of solid recovered fuel. It is recommended to separate biological waste at source to lower moisture and ash content and increase heating value for potential fuel production from waste.

Sign in / Sign up

Export Citation Format

Share Document