scholarly journals Electron cyclotron converters of microwaves in wireless power transmission systems

2020 ◽  
Vol 21 (4) ◽  
pp. 254-259
Author(s):  
Yury A. Pirogov ◽  
Gohar M. Kazaryan ◽  
Vladimir L. Savvin

A proposal to use special electron cyclotron devices as effective converters of electromagnetic waves into direct current in modern microwave systems for wireless transmission of electrical energy to the Earth via a microwave channel from solar space power plants located on board geostationary satellites is considered. Such converters are a product of domestic development, they can have a conversion efficiency of more than 80%, they are insensitive to overloads and are several orders of magnitude more economical than the well-known semiconductor rectennas (rectifying antennas). Semiconductor rectennas, assembled from a multitude of individual semiconductor diodes with a Schottky barrier, in the process of nonlinear conversion of microwaves, generate parasitic radiation that forms a powerful electromagnetic background, which seriously interferes with the stable operation of information systems of special and general civil communications. In addition, the cost of semiconductor rectennas is several orders of magnitude higher than that of electron-cyclotron converters with the same input microwave power. Due to the high compactness of the electronic converters, they can also be installed on an intermediate satellite platform in the stratosphere, receiving the energy of the Sun through a laser beam from a geostationary orbit and transmitting it to the Earth with practically no loss through the microwave channel. The possibilities of using electron cyclotron converters in ground-based systems for wireless energy transmission are also promising. Already the first electron cyclotron converters, created at the Torii enterprise according to the project of the Lomonosov Moscow State University, had an efficiency of over 60% at an input microwave power of 10 kW.

The article presents information about the composition of the equipment of resonant power transmission systems. The resonant systems of electrical energy transmission by single-wire cable or overhead lines at elevated frequency include frequency conversion devices, power transmission lines, and devices for the reverse transformation of electrical energy to the voltage required by the consumer. In contrast to traditional systems of electrical power transmission, resonant systems are being operated on an elevated frequency of 5-15 kHz, a power transmission line voltage is 1-10 kV. In this case resonant transformers are used. The frequency of the power transmission system is set by the resonant transmitting transformer; the receiving transformer is a wideband step-down one.The main components of the resonant transmitting transformer are a power resonant circuit and a step-up/step-down winding. The maximum output power of the converter depends on the voltage supplied to the circuit, circuit voltage, circuit capacitance, frequency, and other parameters. One can change the transmitted power by changing the transmission frequency, for example, for lighting systems.Due to the fact that resonant power transmission systems operating at elevated frequency are less demanding on the grounding quality, they are more efficient compared to single wire ground return line operating at a constant current and an alternating current of commercial frequency


2015 ◽  
Vol 2 (1) ◽  
pp. 3-14 ◽  
Author(s):  
Satoshi Yoshida ◽  
Naoki Hasegawa ◽  
Shigeo Kawasaki

A novel wireless sensor network system with compatibility of microwave power transmission (MPT) using a Gallium Nitride (GaN) power amplifier has been fabricated and tested. The sensor node operates using electrical power supplied by the MPT system. Time- and frequency-division operations are proposed for the compatibility. Under the frequency-division operation, receiving signal strength indicator of −85 dBm and packet error rate of <1% were measured when the available DC power of a rectifier with 160 mW output power. Under 120-min measurement, sustainable power balance between radio-frequency–DC conversion and power consumption in stable operation of the sensor node was achieved.


ACTA IMEKO ◽  
2016 ◽  
Vol 5 (4) ◽  
pp. 73
Author(s):  
Mohamed Khalil ◽  
Christian Laurano ◽  
Giacomo Leone ◽  
Michele Zanoni

<p>Power transmission lines represent the core of the High Voltage Network since they are responsible for the transport of the electrical energy from the generation power plants to the electrical substations. In this paper, an analysis of the outages occurred to the Italian Overhead Transmission Lines (OHTLs) from 2008 to 2015 is carried out. A new simple and effective reliability index, namely the Severity Factor, is introduced with the aim to drive the prioritization of the failure causes and the enhancement of the maintenance activities. The analysis has been performed focusing on the geographical distribution of the OHTLs. For each analyzed region, the voltage levels more prone to failure have been determined. The proposed methodology, thanks to the introduction of the Severity Factor, is a useful and effective tool for the identification of the transmission network criticalities and the enhancement of the related maintenance activities. Finally, an evaluation of the reliability, availability, safety and maintainability (RAMS) of the Italian OHTL network has been performed from a regional point of view.</p>


Sign in / Sign up

Export Citation Format

Share Document