A Novel Multi-Exponential Function-based Companding Technique for Uniform Signal Compression over Channels with Limited Dynamic Range

2010 ◽  
Vol 56 (2) ◽  
pp. 125-128 ◽  
Author(s):  
Taleb Moazzeni ◽  
Henry Selvaraj ◽  
Yingtao Jiang

A Novel Multi-Exponential Function-based Companding Technique for Uniform Signal Compression over Channels with Limited Dynamic Range Companding, as a variant of audio level compression, can help reduce the dynamic range of an audio signal. In analog (digital) systems, this can increase the signal-to-noise ratio (signal to quantization noise ratio) achieved during transmission. The μ-law algorithm that is primarily used in the digital telecommunication systems of North America and Japan, adapts a companding scheme that can expand small signals and compress large signals especially at the presence of high peak signals. In this paper, we present a novel multi-exponential companding function that can achieve more uniform compression on both large and small signals so that the relative signal strength over the time is preserved. That is, although larger signals may get considerably compressed, unlike μ-law algorithm, it is guaranteed that these signals after companding will definitely not be smaller than expanded signals that were originally small. Performance of the proposed algorithm is compared with μ-law using real audio signal, and results show that the proposed companding algorithm can achieve much smaller quantization errors with a modest increase in computation time.

2012 ◽  
Vol 232 ◽  
pp. 915-918
Author(s):  
Marcio Barbosa Lucks ◽  
Heuller A.C. Procópio

In order to increase the dynamic range and the signal-to-quantization noise ratio (SQNR) of telecommunication systems, companding techniques were developed, such as the μ-law and the A-law. These techniques allow a non-uniform quantization of the signal using a compressor circuit followed by a uniform quantizer in the transmitter and the reconstruction of the original signal on the receiver by means of an expander circuit. Some types of signals monitored during the flight of sounding vehicles and satellite launchers have a very wide dynamic range. In this paper, we propose and analyze the use of companding techniques in order to improve the SQNR of onboard telemetry systems.


2020 ◽  
Vol 2020 (7) ◽  
pp. 143-1-143-6 ◽  
Author(s):  
Yasuyuki Fujihara ◽  
Maasa Murata ◽  
Shota Nakayama ◽  
Rihito Kuroda ◽  
Shigetoshi Sugawa

This paper presents a prototype linear response single exposure CMOS image sensor with two-stage lateral overflow integration trench capacitors (LOFITreCs) exhibiting over 120dB dynamic range with 11.4Me- full well capacity (FWC) and maximum signal-to-noise ratio (SNR) of 70dB. The measured SNR at all switching points were over 35dB thanks to the proposed two-stage LOFITreCs.


2021 ◽  
Vol 11 (20) ◽  
pp. 9409
Author(s):  
Roger Kwao Ahiadormey ◽  
Kwonhue Choi

In this paper, we propose rate-splitting (RS) multiple access to mitigate the effects of quantization noise (QN) inherent in low-resolution analog-to-digital converters (ADCs) and digital-to-analog converters (DACs). We consider the downlink (DL) of a multiuser massive multiple-input multiple-output (MIMO) system where the base station (BS) is equipped with low-resolution ADCs/DACs. The BS employs the RS scheme for data transmission. Under imperfect channel state information (CSI), we characterize the spectral efficiency (SE) and energy efficiency (EE) by deriving the asymptotic signal-to-interference-and-noise ratio (SINR). For 1-bit resolution, the QN is very high, and the RS scheme shows no rate gain over the non-RS scheme. As the ADC/DAC resolution increases (i.e., 2–3 bits), the RS scheme achieves higher SE in the high signal-to-noise ratio (SNR) regime compared to that of the non-RS scheme. For a 3-bit resolution, the number of antennas can be reduced by 27% in the RS scheme to achieve the same SE as the non-RS scheme. Low-resolution DACs degrades the system performance more than low-resolution ADCs. Hence, it is preferable to equip the system with low-resolution ADCs than low-resolution DACs. The system achieves the best SE/EE tradeoff for 4-bit resolution ADCs/DACs.


In recent communication technologies, very high sampling rates are required for rf signals particularly for signals coming under ultra high frequency (UHF), super high frequency (SHF) and extremely high frequency (EHF) ranges. The applications include global positioning system (GPS), satellite communication, radar, radio astronomy, 5G mobile phones etc. Such high sampling rates can be accomplished with time-interleaved analog to digital converters (TIADCs). However, sampling time offsets existing in TIADCs produce non-uniform samples. This poses a drawback in the reconstruction of the signal. The current paper addresses this drawback and offers a solution for improved signal reconstruction by estimation and correction of the offsets. A modified differential evolution (MDE) algorithm, which is an optimization algorithm, is used for estimating the sampling time offsets and the estimated offsets are used for correction. The estimation algorithm is implemented on an FPGA board and correction is implemented using MATLAB. The power consumption of FPGA for implementation is 57mW. IO utilization is 27% for 4-channel TIADCs and 13% for 2-channel TIADCs. The algorithm estimated the sampling time offsets precisely. For estimation the algorithm uses a sinusoidal signal as a test signal. Correction is performed with sinusoidal and speech signals as inputs for TIADCs. Performance metrics used for evaluating the algorithm are SNR (signal to noise ratio), SNDR (signal to noise and distortion ratio), SFDR (spurious-free dynamic range) and PSNR (peak signal to noise ratio). A noteworthy improvement is observed in the above mentioned parameters. Results are compared with the existing state of the art algorithms and superiority of the proposed algorithm is verified.


Sign in / Sign up

Export Citation Format

Share Document