Fish impingement at cooling water intakes in The Netherlands: current developments in effect — evaluation, regulations and technical measures

Author(s):  
M. C. M. Bruijs ◽  
F. T. Vriese ◽  
D. Bijstra
Burns ◽  
2011 ◽  
Vol 37 ◽  
pp. S10 ◽  
Author(s):  
M. Gomez-Tromp ◽  
J. Ben Meftah ◽  
W. Gebhardt ◽  
T. Prinsenberg

2007 ◽  
Vol 5 (S1) ◽  
pp. 119-130 ◽  
Author(s):  
Beate Hambsch ◽  
Karin Böckle ◽  
J. Hein M. van Lieverloo

Data on E. coli incidence in drinking water samples have been evaluated for 4 European countries. Within the EC project MicroRisk, large volume sampling was done in the United Kingdom (with disinfectant residual), the Netherlands (mainly without disinfectant residual) and Germany (without disinfectant residual). No E. coli were found and very low background concentrations (< 10−4 per L) were calculated. Furthermore, data of 280,000 water samples collected in France (with disinfectant residual), the Netherlands and Germany (both with and without disinfectant residual) were evaluated for E. coli incidence. In total, similar results were obtained for Germany and the Netherlands. In France, significantly higher incidences occurred as more small rural supply systems were included. The detailed data evaluation revealed a slight increase of mean E. coli concentrations during distribution in Germany and the Netherlands, for both disinfected and non-disinfected supply zones. This suggests that, if technical measures are taken to avoid contamination during distribution, non-disinfected supply zones can be regarded as being as safe as disinfected supply zones. Furthermore, the indicator principle of E. coli for faecal contaminations is valid in non-disinfected supply zones. In chlorinated systems, on-line-monitoring of chlorine residuals represents a good means to detect ingress of organic material.


Author(s):  
W. C. Bigelow ◽  
F. B. Drogosz ◽  
S. Nitschke

High vacuum systems with oil diffusion pumps usually have a pressure switch to protect against Insufficient cooling water; however, If left unattended for long periods of time, failure of the mechanical fore pump can occur with equally serious results. The device shown schematically in Fig. 1 has been found to give effective protection against both these failures, yet it is inexpensive and relatively simple to build and operate.With this system, pressure in the fore pump line is measured by thermocouple vacuum gage TVG (CVC G.TC-004) whose output is monitored by meter relay MRy (Weston 1092 Sensitrol) which is set to close if the pressure rises above about 0.2 torr. This energizes control relay CRy (Potter & Brumfield KA5Y 120VAC SPDT) cutting off power to solenoid-operated fore line valve Vf (Cenco 94280-4 Norm. Closed) which closes to prevent further leakage of air into the diffusion pump


Sign in / Sign up

Export Citation Format

Share Document