Unsteady surface pressure distributions on a delta wing undergoing large amplitude pitching motions

1990 ◽  
Author(s):  
S. THOMPSON ◽  
S. BATILL ◽  
R. NELSON
Keyword(s):  
Surface Pressure ◽  
Large Amplitude ◽  
Delta Wing ◽  
Pressure Distributions ◽  
Unsteady Surface Pressure

Unsteady Pressure Measurement on Oscillating Blade in Transonic Flow Using Fast-Response Pressure-Sensitive Paint

2017 ◽  
Author(s):  
Toshinori Watanabe ◽  
Toshihiko Azuma ◽  
Seiji Uzawa ◽  
Takehiro Himeno ◽  
Chihiro Inoue
Keyword(s):  
Surface Pressure ◽  
Transonic Flow ◽  
Aerodynamic Force ◽  
Fast Response ◽  
Pressure Sensitive Paint ◽  
Unsteady Pressure ◽  
Pressure Distributions ◽  
Pressure Sensitive ◽  
Unsteady Surface Pressure ◽  
Response Pressure

A fast-response pressure-sensitive paint (PSP) technique was applied to the measurement of unsteady surface pressure of an oscillating cascade blade in a transonic flow. A linear cascade was used, and its central blade was oscillated in a translational manner. The unsteady pressure distributions of the oscillating blade and two stationary neighbors were measured using the fast-response PSP technique, and the unsteady aerodynamic force on the blade was obtained by integrating the data obtained on the pressures. The measurements made with the PSP technique were compared with those obtained by conventional methods for the purpose of validation. From the results, the PSP technique was revealed to be capable of measuring the unsteady surface pressure, which is used for flutter analysis in transonic conditions.

Steady and Unsteady Surface Pressure Distributions Around Rectangular Prisms With Sharp Edges at Reynolds Number Up to 2.5×106

2006 ◽  
Author(s):  
Annick D’Auteuil ◽  
Guy L. Larose
Keyword(s):  
Reynolds Number ◽  
Turbulent Flow ◽  
Surface Pressure ◽  
Angle Of Attack ◽  
Pressure Measurements ◽  
Oncoming Flow ◽  
Pressure Distributions ◽  
Unsteady Surface Pressure ◽  
Sharp Edges ◽  
Flow Reattachment

The commonly-held assumption that the aerodynamics of rectangular prisms with sharp edges are insensitive to Reynolds number is shown to have limitations. Flow reattachment on the top and/or bottom of the prisms can be related to Reynolds number, Re. Steady and unsteady surface pressure measurements were carried out on nine different rectangular prisms for Re from 0.3×106 to 2.5×106 at several angles of attack, in smooth and turbulent flow. It was observed that the reattachment was dependent on parameters such as fineness ratio, edge treatment, angle of attack, turbulence of the oncoming flow and Reynolds number. Permanent reattachment occurred for prisms with fineness ratio of 4 and fluctuating reattachment took place for rectangular prisms with fineness ratio as low as 2.

Unsteady Pressure Measurement on Oscillating Blade in Transonic Flow Using Fast-Response Pressure-Sensitive Paint

2018 ◽  
Vol 140 (6) ◽  
Author(s):  
Toshinori Watanabe ◽  
Toshihiko Azuma ◽  
Seiji Uzawa ◽  
Takehiro Himeno ◽  
Chihiro Inoue
Keyword(s):  
Surface Pressure ◽  
Transonic Flow ◽  
Aerodynamic Force ◽  
Fast Response ◽  
Pressure Sensitive Paint ◽  
Unsteady Pressure ◽  
Pressure Distributions ◽  
Pressure Sensitive ◽  
Unsteady Surface Pressure ◽  
Response Pressure

A fast-response pressure-sensitive paint (PSP) technique was applied to the measurement of unsteady surface pressure of an oscillating cascade blade in a transonic flow. A linear cascade was used, and its central blade was oscillated in a translational manner. The unsteady pressure distributions of the oscillating blade and two stationary neighbors were measured using the fast-response PSP technique, and the unsteady aerodynamic force on the blade was obtained by integrating the data obtained on the pressures. The measurements made with the PSP technique were compared with those obtained by conventional methods for the purpose of validation. From the results, the PSP technique was revealed to be capable of measuring the unsteady surface pressure, which is used for flutter analysis in transonic conditions.

Supersonic Flow Past a Slender Delta Wing. An Experimental Investigation Covering the Incidence Range –5° ≤ α ≤ 50°

1976 ◽  
Vol 27 (2) ◽  
pp. 143-153 ◽  
Author(s):  
I C Richards
Keyword(s):  
Experimental Investigation ◽  
Supersonic Flow ◽  
Surface Pressure ◽  
Shock Layer ◽  
Delta Wing ◽  
Lower Surface ◽  
Flow Visualisation ◽  
Pressure Distributions ◽  
Thin Shock Layer ◽  
Oil Flow

SummaryA detailed survey of a delta wing of 70° sweep has been performed at M = 2.5. The measurements include upper- and lower-surface pressure distributions, schlieren photographs, vapour-screen photographs and surface oil-flow visualisation. The results have been compared with thin-shock-layer theory and various other predictions.

Aeroacoustic analysis of slat tones

2021 ◽  
Vol 263 (1) ◽  
pp. 5650-5663
Author(s):  
Hasan Kamliya Jawahar ◽  
Syamir Alihan Showkat Ali ◽  
Mahdi Azarpeyvand
Keyword(s):  
Wavelet Transform ◽  
Surface Pressure ◽  
Wavelet Coefficient ◽  
Pressure Fluctuations ◽  
Low Frequency ◽  
Stream Velocity ◽  
High Lift ◽  
Unsteady Surface Pressure ◽  
Slat Noise ◽  
Generation Mechanisms

Experimental measurements were carried out to assess the aeroacoustic characteristics of a 30P30N high-lift device, with particular attention to slat tonal noise. Three different types of slat modifications, namely slat cove filler, serrated slat cusp, and slat finlets have been experimentally examined. The results are presented for an angle of attack of α = 18 at a free-stream velocity of U = 30 m/s, which corresponds to a chord-based Reynolds number of Re = 7 x 10. The unsteady surface pressure near the slat region and far-field noise were made simultaneously to gain a deeper understanding of the slat noise generation mechanisms. The nature of the low-frequency broadband hump and the slat tones were investigated using higher-order statistical approaches for the baseline 30P30N and modified slat configurations. Continuous wavelet transform of the unsteady surface pressure fluctuations along with secondary wavelet transform of the broadband hump and tones were carried out to analyze the intermittent events induced by the tone generating resonant mechanisms. Stochastic analysis of the wavelet coefficient modulus of the surface pressure fluctuations was also carried out to demonstrate the inherent differences of different tonal frequencies. An understanding into the nature of the noise generated from the slat will help design the new generation of quite high-lift devices.

Experimental Analysis of a NACA 0021 Airfoil Under Dynamic Angle of Attack Variation and Low Reynolds Numbers

2018 ◽  
Vol 141 (3) ◽  
Author(s):  
D. Holst ◽  
B. Church ◽  
F. Wegner ◽  
G. Pechlivanoglou ◽  
C. N. Nayeri ◽  
...  
Keyword(s):  
Design Process ◽  
Surface Pressure ◽  
Wind Turbines ◽  
Full Range ◽  
Vertical Axis ◽  
Reynolds Numbers ◽  
Time Resolved ◽  
Pressure Distributions ◽  
Pressure Development ◽  
Flow Phenomena

The wind industry needs reliable and accurate airfoil polars to properly predict wind turbine performance, especially during the initial design phase. Medium- and low-fidelity simulations directly depend on the accuracy of the airfoil data and even more so if, e.g., dynamic effects are modeled. This becomes crucial if the blades of a turbine operate under stalled conditions for a significant part of the turbine's lifetime. In addition, the design process of vertical axis wind turbines needs data across the full range of angles of attack between 0 and 180 deg. Lift, drag, and surface pressure distributions of a NACA 0021 airfoil equipped with surface pressure taps were investigated based on time-resolved pressure measurements. The present study discusses full range static polars and several dynamic sinusoidal pitching configurations covering two Reynolds numbers Re = 140k and 180k, and different incidence ranges: near stall, poststall, and deep stall. Various bistable flow phenomena are discussed based on high frequency measurements revealing large lift-fluctuations in the post and deep stall regime that exceed the maximum lift of the static polars and are not captured by averaged measurements. Detailed surface pressure distributions are discussed to provide further insight into the flow conditions and pressure development during dynamic motion. The experimental data provided within the present paper are dedicated to the scientific community for calibration and reference purposes, which in the future may lead to higher accuracy in performance predictions during the design process of wind turbines.

Sign in / Sign up

Export Citation Format

Share Document