Lift Enhancement by a Stationary Leading-Edge Vortex Over a High Aspect Ratio Wing

2019 ◽  
Author(s):  
Hadar Ben-Gida ◽  
Roi Gurka ◽  
Daniel Weihs
2015 ◽  
Vol 10 (5) ◽  
pp. 056020 ◽  
Author(s):  
Nathan Phillips ◽  
Kevin Knowles ◽  
Richard J Bomphrey

2021 ◽  
Vol 11 (6) ◽  
pp. 2450
Author(s):  
Jong-Seob Han ◽  
Christian Breitsamter

A sweptback angle can directly regulate a leading-edge vortex on various aerodynamic devices as well as on the wings of biological flyers, but the effect of a sweptback angle has not yet been sufficiently investigated. Here, we thoroughly investigated the effect of the sweptback angle on aerodynamic characteristics of low-aspect-ratio flat plates at a Reynolds number of 2.85 × 104. Direct force/moment measurements and surface oil-flow visualizations were conducted in the wind-tunnel B at the Technical University of Munich. It was found that while the maximum lift at an aspect ratio of 2.03 remains unchanged, two other aspect ratios of 3.13 and 4.50 show a gradual increment in the maximum lift with an increasing sweptback angle. The largest leading-edge vortex contribution was found at the aspect ratio of 3.13, resulting in a superior lift production at a sufficient sweptback angle. This is similar to that of a revolving/flapping wing, where an aspect ratio around three shows a superior lift production. In the oil-flow patterns, it was observed that while the leading-edge vortices at aspect ratios of 2.03 and 3.13 fully covered the surfaces, the vortex at an aspect ratio of 4.50 only covered up the surface approximately three times the chord, similar to that of a revolving/flapping wing. Based on the pattern at the aspect ratio of 4.50, a critical length of the leading-edge vortex of a sweptback plate was measured as ~3.1 times the chord.


2020 ◽  
Vol 14 (2) ◽  
pp. 6888-6894
Author(s):  
Muhamad Ridzuan Arifin ◽  
A.F.M. Yamin ◽  
A.S. Abdullah ◽  
M.F. Zakaryia ◽  
S. Shuib ◽  
...  

Leading-edge vortex governs the aerodynamic force production of flapping wing flyers. The primary factor for lift enhancement is the leading-edge vortex (LEV) that allows for stall delay that is associated with unsteady fluid flow and thus generating extra lift during flapping flight. To access the effects of LEV to the aerodynamic performance of flapping wing, the three-dimensional numerical analysis of flow solver (FLUENT) are fully applied to simulate the flow pattern. The time-averaged aerodynamic performance (i.e., lift and drag) based on the effect of the advance ratio to the unsteadiness of the flapping wing will result in the flow regime of the flapping wing to be divided into two-state, unsteady state (J<1) and quasi-steady-state(J>1). To access the benefits of aerodynamic to the flapping wing, both set of parameters of velocities 2m/s to 8m/s at a high flapping frequency of 3 to 9 Hz corresponding to three angles of attacks of α = 0o to α = 30o. The result shows that as the advance ratio increases the generated lift and generated decreases until advance ratio, J =3 then the generated lift and drag does not change with increasing advance ratio. It is also found that the change of lift and drag with changing angle of attack changes with increasing advance ratio. At low advance ratio, the lift increase by 61% and the drag increase by 98% between α =100 and α =200. The lift increase by 28% and drag increase by 68% between α = 200 and α = 300. However, at high advance ratio, the lift increase by 59% and the drag increase by 80% between α =100 and α = 200, while between α =200 and α =300 the lift increase by 20% and drag increase by 64%. This suggest that the lift and drag slope decreases with increasing advance ratio. In this research, the results had shown that in the unsteady state flow, the LEV formation can be indicated during both strokes. The LEV is the main factor to the lift enhancement where it generated the lower suction of negative pressure. For unsteady state, the LEV was formed on the upper surface that increases the lift enhancement during downstroke while LEV was formed on the lower surface of the wing that generated the negative lift enhancement. The LEV seem to breakdown at the as the wing flap toward the ends on both strokes.      


2014 ◽  
Vol 751 ◽  
pp. 71-105 ◽  
Author(s):  
R. R. Harbig ◽  
J. Sheridan ◽  
M. C. Thompson

AbstractThe effects of advance ratio and the wing’s aspect ratio on the structure of the leading-edge vortex (LEV) that forms on flapping and rotating wings under insect-like flight conditions are not well understood. However, recent studies have indicated that they could play a role in determining the stable attachment of the LEV. In this study, a numerical model of a flapping wing at insect Reynolds numbers is used to explore the effects of these parameters on the characteristics and stability of the LEV. The word ‘stability’ is used here to describe whether the LEV was attached throughout the stroke or if it was shed. It is demonstrated that increasing the advance ratio enhances vorticity production at the leading edge during the downstroke, and this results in more rapid growth of the LEV for non-zero advance ratios. Increasing the wing aspect ratio was found to have the effect of shortening the wing’s chord length relative to the LEV’s size. These two effects combined determine the stability of the LEV. For high advance ratios and large aspect ratios, the LEV was observed to quickly grow to envelop the entire wing during the early stages of the downstroke. Continued rotation of the wing resulted in the LEV being eventually shed as part of a vortex loop that peels away from the wing’s tip. The shedding of the LEV for high-aspect-ratio wings at non-zero advance ratios leads to reduced aerodynamic performance of these wings, which helps to explain why a number of insect species have evolved to have low-aspect-ratio wings.


AIAA Journal ◽  
2016 ◽  
Vol 54 (9) ◽  
pp. 2755-2767 ◽  
Author(s):  
Kyle Hord ◽  
Yongsheng Lian

2013 ◽  
Vol 717 ◽  
pp. 166-192 ◽  
Author(s):  
R. R. Harbig ◽  
J. Sheridan ◽  
M. C. Thompson

AbstractPrevious studies investigating the effect of aspect ratio ($\mathit{AR}$) for insect-like regimes have reported seemingly different trends in aerodynamic forces, however no detailed flow observations have been made. In this study, the effect of $\mathit{AR}$ and Reynolds number on the flow structures over insect-like wings is explored using a numerical model of an altered fruit fly wing revolving at a constant angular velocity. Increasing the Reynolds number for an $\mathit{AR}$ of 2.91 resulted in the development of a dual leading-edge vortex (LEV) structure, however increasing $\mathit{AR}$ at a fixed Reynolds number generated the same flow structures. This result shows that the effects of Reynolds number and $\mathit{AR}$ are linked. We present an alternative scaling using wing span as the characteristic length to decouple the effects of Reynolds number from those of $\mathit{AR}$. This results in a span-based Reynolds number, which can be used to independently describe the development of the LEV. Indeed, universal behaviour was found for various parameters using this scaling. The effect of $\mathit{AR}$ on the vortex structures and aerodynamic forces was then assessed at different span-based Reynolds numbers. Scaling the flow using the wing span was found to apply when a strong spanwise velocity is present on the leeward side of the wing and therefore may prove to be useful for similar studies involving flapping or rotating wings at high angles of attack.


AIAA Journal ◽  
2020 ◽  
Vol 58 (7) ◽  
pp. 2806-2819 ◽  
Author(s):  
Hadar Ben-Gida ◽  
Roi Gurka ◽  
Daniel Weihs

Sign in / Sign up

Export Citation Format

Share Document