EXERGY ANALYSIS OF THE AIR SOLAR COLLECTOR BASED ON EXPERIMENTAL DATA

2012 ◽  
Vol 11 (8) ◽  
pp. 1367-1374 ◽  
Author(s):  
Nicolina Pop ◽  
Ioan Luminosu ◽  
Laurentiu Fara ◽  
Marius Costache ◽  
Silvian Fara
2021 ◽  
Vol 3 (1) ◽  
Author(s):  
Essaied M Shuia ◽  
Bashir H Arebi ◽  
Ibrahim A abuashe

This paper presents the experimental data that was collected from small pilot solar chimney. The experimental data together with ambient conditions are used to evaluate the performance and study the behavior of the solar chimney; this data will be used for comparison with theoretical models in another paper [part II). The solar chimney prototype was designed and constructed at the Subrata Faculty of Engineering-Libya. The data were collected over several days of June 2011. The solar chimney system contains two main components; the solar collector and the solar chimney. The solar collector root‘ has a circular area of126 m3, the solar chimney is a PVC tube with internal diameter of 0.2 m and the total height of chimney is 9.3 m. The measurements include the intensity of solar radiation inside/outside the collector, temperature and velocity of air at the entrance of the chimney, temperature and speed of wind outside the collector, temperature of the ground inside collector al1d temperature measurements of air at speci?c points at different levels throughout the collector. Solar irradiance was found to affect the chimney temperature and subsequently affects chimney air velocity. The experimental results showed that temperature differences of (30 - 45°C) were recorded between the ambient temperature and that of air inside the chimney in the middle of the day, where the highest air temperature of 73.4°C was recorded at the entrance of the solar chimney. The maximum air velocity of 3.6 m/s was recorded inside the solar chimney at noon on 9 June. Wind speed outside the collector had a small effect on the speed of the air inside the chimney and tends to change slightly, hence, can neglect influence of wind speed on the performance of the system. Also the experimental results indicate that such type of system can trap a suf?cient amount of solar radiation, which elevates the air temperature to a suf?cient value able to generate enough air ?ow to operate a wind turbine to produce electricity; this means the solar chimney system for electricity production can work in the north-western part of Libya in the summer time at least.


2007 ◽  
Vol 6 (2) ◽  
pp. 19
Author(s):  
J. M. S. Lafay ◽  
A. Krenzinger

This work presents the methodology and results of the validation of a computer program for the simulation of water heating systems combining solar energy and gas. Two experimental systems, named series and parallel, were assembled. These systems have the same components, differing on how they are connected. All the components were individually characterized and their parameters determined. Simulations of the behavior of the thermal tank, gas heater and solar collector were performed and confronted to experimental data. The results show that the simulation program “AQUESOLGAS” can accurately describe the behavior of water heating systems with solar energy and gas.


Author(s):  
Ahmad Fudholi ◽  
Mariyam Fazleena Musthafa ◽  
Abrar Ridwan ◽  
Rado Yendra ◽  
Ari Pani Desvina ◽  
...  

<span lang="EN-US">Photovoltaic thermal (PVT) collectors convert solar radiation directly to both electrical and thermal energies. A PVT collector basiccaly combines the functions of a flat plate solar collector and those of a PV panel. This review presents thermodinamics fundamentals, descriptions, and previous works conducted on energy and exergy analysis of air based PVT collector. Studies in 2010 to 2018 of the energy and exergy analysis of air based PVT collectors are summarized. The energy and exergy efficiency of air based PVT collector ranges from 31% to 94% and 8.7% to 18%, respectively. In addition, flat plate solar collector is presented. Studies conducted on air based PVT collectors are reviewed.</span>


A new design of solar still consist of flat plate solar collector, heat exchanger and cooling tower, was built and tested under Iraq weather at March. The still was tested under different mass flow rate of brackish water entering the flate plate solar collector, ranging from 0.01 to 0.015 kg/s. The volume flow rate of air through cooling tower was 0.0195 m3 /s. A full details of overall system as well as for system components exergy analysis were achieved. It was found that the maximum daily exergy efficiency of the still is less than 1%. While the maximum hourly exergy efficiency and maximum productivity for such combination were 3.46 kg/day and 1.6% , respectively, when the mass flow rate of brackish water was 0.013 kg/s.


2018 ◽  
Vol 26 (1/2) ◽  
pp. 107
Author(s):  
Laura Vanoli ◽  
Rafal Damian Figaj ◽  
Francesco Calise

Sign in / Sign up

Export Citation Format

Share Document