scholarly journals Studies on Parboiled Rice Part II. Milling Characteristics of Parboiled Rice and Properties of the Milled Rice.

1991 ◽  
Vol 38 (9) ◽  
pp. 776-783
Author(s):  
Kazuhiko ITOH ◽  
Shuso KAWAMURA
2021 ◽  
Vol 37 (2) ◽  
pp. 359-366
Author(s):  
Deandrae Lynette Smith ◽  
Griffiths G. Atungulu

HighlightsThis research investigated the feasibility of using a microwave (MW) set at 915 MHz frequency to dry high moisture content (MC) parboiled rough rice at 44.3% MC dry basis (d.b.).The research evaluated the impacts of specific power delivered during the drying of parboiled rough rice using a MW on post-drying milling characteristics.The volumetric heating phenomenon provided by MW offered a method to quickly remove 23.1% points of moisture from parboiled rough rice in one-pass to a MC of 21.2% d.b., with minimal impacts on the kernel quality.The findings suggest that increased MW specific powers have a positive effect on rice MC reduction but negatively affects the rice milling characteristics, especially the head rice yield.The study recommended that MW specific powers exceeding 2.92 kW.[kg-DM]-1 should not be exceeded during drying of parboiled rough rice to preserve the rice milling yields.ABSTRACT. The objectives of this research were to study the impacts of specific power of MW generated at 915 MHz frequency to dry high MC parboiled rough rice on moisture removal and milling characteristics of the parboiled rough rice. Long-grain rough rice of the cultivar (cv.) Mermentau at harvest MC of 31.6% dry basis (d.b.) was parboiled by soaking at 73°C for 3 h and then steamed at 67 kPa for 10 minutes. Following the parboiling process the sample was subjected to the MW drying. The drying was accomplished at MW specific powers that ranged from 1.10 to 8.77 kW. [kg-DM] -1 and 0.37 to 2.92 kW. [kg-DM] -1 (power per unit dry matter mass of the grain). These treatment levels of MW specific power were varied by heating parboiled rough rice for 2 and 6 minutes (min) at MW powers that ranged from 1 to 24 kW. The process of parboiling increased the rough rice MC to 44.3% dry basis (d.b.). During the MW drying, as the specific power increased, the general tendency was for rough rice final moisture content (FMC), milled rice yield (MRY) and head rice yield (HRY) to decrease while the drying rate increased. Parboiled rough rice samples treated with a specific power of 8.77 kW.[kg-DM] -1 while maintaining specific energy input at 0.29 kWh.[kg-DM] -1 had least-square means FMC, drying rate, MRY and HRY of 19.7% d.b. (S.D ± 1.1%), 12.3% d.b. [min-1] (S.D ± 0.8%) (2 min drying duration), 68.18% (S.D ± 1.70%) and 67.51% (S.D ± 0.73%) respectively. However, treatment at a lower specific power of 2.92 kW.[kg-DM] -1 while maintaining the same specific energy input of 0.29 kWh.[kg-DM]-1) resulted in least-square means FMC, drying rate, MRY and HRY of 21.2% d.b. (S.D ± 0.5%), 3.9% d.b. [min-1] (S.D ± 0.1%) (2 min drying duration), 73.22% (S.D ± 0.84%) and 73.21% (S.D ± 0.21%) respectively. The increased drying rates for treatments with higher specific power was associated with higher treatment powers and shorter treatment durations. Higher specific powers negatively impacted the observed MRY and HRY. The findings suggest that increased MW specific powers have a positive effect on rice MC reduction but above a certain threshold of specific power (2.92 kW.[kg-DM]-1) may negatively affect the milling characteristics of the parboiled rice. When used to dry high MC parboiled rough rice, rice processors should know that there exists an optimum drying rate that if exceeded the milled rice quality is negatively affected thus generating an economic loss to the parboiled rice industry. The volumetric heating phenomenon provided by microwave (MW) offers a means to quickly dry high MC parboiled rough rice. This can translate to considerable economic savings for the rice processor who often experiences low drying rates because of limited drying capacity, especially at peak rice harvest times. When drying rates are optimized, rice processors can expect minimal impacts on the kernel quality which can also be translated to considerable economic savings for the rice processor. Keywords: 915 MHz microwave, Microwave drying, Milling Quality, Parboiled rice, Specific power.


2019 ◽  
Vol 62 (4) ◽  
pp. 1011-1019
Author(s):  
Bhagwati Prakash ◽  
Terry J. Siebenmorgen ◽  
Kristen E. Gibson ◽  
Shweta Kumari

Abstract. Rough rice in the Mid-South U.S. is typically stored and milled at a moisture content (MC) between 12% and 13% on a wet basis. Drying harvested rice to lesser MCs requires increasingly greater energy and reduces the overall mass of rice, both of which translate into lesser financial return for the crop. Considering these disadvantages of drying and storing rice at lesser MCs, farmers and grain handlers have been interested in exploring storing rice at slightly greater MCs. The current study was undertaken to evaluate the effect of storing rice at five MCs (11%, 12%, 13%, 14%, and 15%) on milling characteristics, particularly surface lipid content (SLC), milled rice yield (MRY), and head rice yield (HRY); additionally, the effects of storing rice at two storage temperatures (25°C and 35°C) and several storage durations (up to one year) on milling characteristics were investigated. Five long-grain rice lots were harvested in 2016 and 2017 from several locations in Arkansas; rice from each lot was gently dried to the target MCs and then stored in sealed glass jars at selected temperatures. With an increase in storage MC, shorter milling durations were needed to achieve a given SLC, which could potentially reduce the cost of the milling operation. However, rice samples stored at greater MCs were observed to have lesser HRYs, which could reduce the economic value of rice. The mean HRYs of the 15% MC samples were 4.8 to 9.1 percentage points less than the mean HRYs of the 12% MC samples. This study quantifies the milling characteristics of rice when stored for various durations at different MCs and temperatures. Overall, these data will allow the rice industry to make informed decisions related to storage conditions of rice, specifically storage MC. Keywords: Head rice yield, Milling, Moisture content, Rice, Storage.


2020 ◽  
Vol 10 (5) ◽  
pp. 613-628
Author(s):  
Asankha Pallegedara

PurposeUnderstanding parboiled rice consumption trends by households is important because parboiled rice provides economic benefits as well as health benefits compared to non-parboiled ordinary milled rice. Thus, the objective of this study is to examine the patterns and determinants of parboiled rice consumption by Sri Lankan households.Design/methodology/approachThis study uses the Household Income and Expenditure Survey (HIES) data compiled by the Department of Census and Statistics (DCS) of Sri Lanka in 2002, 2006/2007 and 2012/2013. This paper analyses the parboiled rice consumption behaviour of households using information from 56,000 households. Specifically, present paper estimates the determinants of parboiled rice consumption within two-part model econometric framework controlling for demand side factors as well as location and time fixed-effects.FindingsDespite its nutritional and health benefits, results show that the likelihood of consuming parboiled rice has decreased over the years. There are significant ethnic and regional differences of consuming parboiled rice supporting the claim of heterogeneous distribution of rice consumption patterns even within the same country.Research limitations/implicationsUse of repeated cross-sectional data due to lack of panel data and missing data on several districts due to security concerns are limitations of the study.Originality/valueTo our knowledge, this is the first study for Sri Lanka that examines parboiled rice consumption behaviour using nationwide data for last 2 decade.


2021 ◽  
Vol 9 (2) ◽  
pp. 683-691
Author(s):  
Tarali Kalita ◽  
Upasana P. Gohain ◽  
Jimpi Hazarika

Rice, the mostly used cereal grain, is composed of three layers-husk, bran and endosperm, each contains various specific components. These layers can be lost or retained depending on the different processing methods used. The objective of the present study was to know the nutritional value of raw and parboiled Ranjit rice obtained by de-husking method using both modern milling and a traditional de-husking method by “Dhenki”. After preparing the rice flour, estimation of carbohydrate, protein, crude lipid, crude fiber, Minerals: Fe, Zn, Ca, vitamins thiamin and niacin were carried out for all the rice samples following standard methods. The milled rice grains showed greater losses in the fat, protein and fiber contents compared to the rice grains de-husked by Dhenki. On the other hand, the parboiling of the paddy prior to de-husking enhanced the nutritional quality of the rice compared to the un parboiled raw rice as parboiling - allows some nutrients like Iron and vitamins to transfer from the hull into the grain. Parboiled rice also showed less carbohydrate content compared to the raw rice. Further study with animal model revealed that parboiled rice de husked by Dhenki showed slow rate of digestion indicating it as a source of good carbohydrate.The findings may be useful in helping the people to choose the right processing methods for rice to obtain maximum yield in nutrition.


2009 ◽  
Vol 34 (6) ◽  
pp. 439-445 ◽  
Author(s):  
Hoon Kim ◽  
Dong-Chul Kim ◽  
Se-Eun Lee ◽  
Oui-Woung Kim

2014 ◽  
Vol 3 (2) ◽  
pp. 177-182
Author(s):  
Bime M.J ◽  
Fon D.E ◽  
Ngalim S.B ◽  
Ongla J

Rice production and processing over the years has been on an increase with more small holders entering the business. This study on profitability of processing and marketing of small scale rice processors had as objective to analyse the profitability levels of rice processing and marketing by small scale processors, determine the value added to the commodity at each stage  and also identify the constraints faced by these processors. The study used primary data collected using well-structured questionnaire from millers only, miller traders for white/parboiled rice through a multistage sampling technique. Results showed that the net processing income (3,151,201), value added (8,147,456) and efficiency (138) for miller-traders of white rice was highest, followed by miller-traders for parboiled rice and lastly millers only. Results further showed that millers only had Benefit/cost ratio of 0.4 indicating that milling only is not profitable due to small quantities milled, and high fixed cost. Miller-traders for parboiled rice had a benefit/cost ratio of 2.3 implying that their venture is most profitable. Based on the results, it was recommended that millers only should purchase large quantities of paddy to enable them reduce the overhead cost. Also the services of parboilers should reflect in the sales price of parboiled rice so that the parboiling services can be paid for.


Sign in / Sign up

Export Citation Format

Share Document