scholarly journals Tool Flank Wear Analysis for MQL Assisted Milling of Strenx 1100 Structural Steel

2021 ◽  
Author(s):  
Mustafa KUNTOĞLU
Keyword(s):  
Structural Steel ◽  
Flank Wear ◽  
Tool Flank Wear ◽  
Wear Analysis

The influence of tool flank wear on residual stresses induced by milling aluminum alloy

2009 ◽  
Vol 209 (9) ◽  
pp. 4502-4508 ◽  
Author(s):  
Z.T. Tang ◽  
Z.Q. Liu ◽  
Y.Z. Pan ◽  
Y. Wan ◽  
X. Ai
Keyword(s):  
Aluminum Alloy ◽  
Residual Stresses ◽  
Flank Wear ◽  
Tool Flank Wear

Tool Life Analysis when Turning Ti-6Al-4V Using Vegetable Oil-Based Cutting Fluid

2017 ◽  
Vol 882 ◽  
pp. 36-40
Author(s):  
Salah Gariani ◽  
Islam Shyha ◽  
Connor Jackson ◽  
Fawad Inam
Keyword(s):  
Tool Wear ◽  
Tool Life ◽  
Vegetable Oil ◽  
Flank Wear ◽  
Cutting Speed ◽  
Fractional Factorial ◽  
Cutting Fluid ◽  
Depth Of Cut ◽  
Tool Flank Wear ◽  
Fluid Concentration

This paper details experimental results when turning Ti-6Al-4V using water-miscible vegetable oil-based cutting fluid. The effects of coolant concentration and working conditions on tool flank wear and tool life were evaluated. L27 fractional factorial Taguchi array was employed. Tool wear (VBB) ranged between 28.8 and 110 µm. The study concluded that a combination of VOs based cutting fluid concentration (10%), low cutting speed (58 m/min), feed rate (0.1mm/rev) and depth of cut (0.75mm) is necessary to minimise VBB. Additionally, it is noted that tool wear was significantly affected by cutting speeds. ANOVA results showed that the cutting fluid concentration is statistically insignificant on tool flank wear. A notable increase in tool life (TL) was recorded when a lower cutting speed was used.

Effect of Tool Flank Wear on the Orthogonal Cutting Process

2007 ◽  
pp. 705-710 ◽  
Author(s):  
X.L. Zhao ◽  
Yong Tang ◽  
Wen Jun Deng ◽  
F.Y. Zhang
Keyword(s):  
Flank Wear ◽  
Orthogonal Cutting ◽  
Cutting Process ◽  
Tool Flank Wear
Sign in / Sign up

Export Citation Format

Share Document