Allowing for tool flank wear in predicting cutting forces for oblique machining

2002 ◽  
Vol 15 (supp) ◽  
pp. 211
Author(s):  
J Wang
Keyword(s):  
Cutting Forces ◽  
Flank Wear ◽  
Tool Flank Wear

Effect of Tool Flank Wear on the Orthogonal Cutting Process

2007 ◽  
Vol 329 ◽  
pp. 705-710 ◽  
Author(s):  
X.L. Zhao ◽  
Yong Tang ◽  
Wen Jun Deng ◽  
F.Y. Zhang
Keyword(s):  
Cutting Forces ◽  
Cutting Tool ◽  
Flank Wear ◽  
Orthogonal Cutting ◽  
Cutting Temperature ◽  
Element Model ◽  
Cutting Process ◽  
Temperature Fields ◽  
Tool Flank Wear ◽  
Chip Separation

A coupled thermoelastic-plastic plane-strain finite element model is developed to study orthogonal cutting process with and without flank wear. The cutting process is simulated from the initial to the steady-state of cutting force and cutting temperature, by incrementally advancing the cutting tool forward. Automatic continuous remeshing is employed to achieve chip separation at the tool tip regime. The effect of the degree of the flank wear on the cutting forces and temperature fields is analyzed. With the flank wear increasing, the maximum cutting temperature values on the workpiece and cutting tool increase rapidly and the distribution of temperature changes greatly. The increase of tool flank wear produced slight increase in cutting forces but significant increase in thrust forces.

The influence of tool flank wear on residual stresses induced by milling aluminum alloy

2009 ◽  
Vol 209 (9) ◽  
pp. 4502-4508 ◽  
Author(s):  
Z.T. Tang ◽  
Z.Q. Liu ◽  
Y.Z. Pan ◽  
Y. Wan ◽  
X. Ai
Keyword(s):  
Aluminum Alloy ◽  
Residual Stresses ◽  
Flank Wear ◽  
Tool Flank Wear

Tool Life Analysis when Turning Ti-6Al-4V Using Vegetable Oil-Based Cutting Fluid

2017 ◽  
Vol 882 ◽  
pp. 36-40
Author(s):  
Salah Gariani ◽  
Islam Shyha ◽  
Connor Jackson ◽  
Fawad Inam
Keyword(s):  
Tool Wear ◽  
Tool Life ◽  
Vegetable Oil ◽  
Flank Wear ◽  
Cutting Speed ◽  
Fractional Factorial ◽  
Cutting Fluid ◽  
Depth Of Cut ◽  
Tool Flank Wear ◽  
Fluid Concentration

This paper details experimental results when turning Ti-6Al-4V using water-miscible vegetable oil-based cutting fluid. The effects of coolant concentration and working conditions on tool flank wear and tool life were evaluated. L27 fractional factorial Taguchi array was employed. Tool wear (VBB) ranged between 28.8 and 110 µm. The study concluded that a combination of VOs based cutting fluid concentration (10%), low cutting speed (58 m/min), feed rate (0.1mm/rev) and depth of cut (0.75mm) is necessary to minimise VBB. Additionally, it is noted that tool wear was significantly affected by cutting speeds. ANOVA results showed that the cutting fluid concentration is statistically insignificant on tool flank wear. A notable increase in tool life (TL) was recorded when a lower cutting speed was used.

Sign in / Sign up

Export Citation Format

Share Document