scholarly journals USE OF BIOCOMPOST TO INCREASE PRODUCTIVITY OF DEGRADED SOD-PODZOLIC SANDY LOAM SOIL

2020 ◽  
Vol 4 (11(80)) ◽  
pp. 37-39
Author(s):  
A. Ilinskiy

The paper presents the results of a lysimetric experiment on sod-podzolic sandy loam soil with the use of effluent from cattle manure, biocompost based on animal husbandry and municipal waste as meliorants. The positive effect of the studied meliorants on the yield of annual grasses was experimentally established. The largest increase in the hay yield of 95.3 % was obtained in the variant with the use of biocompost as a meliorant.

Author(s):  
A. Ilinskiy

The paper evaluates the effectiveness of the aftereffect of the use of biomeliorants (effluent and biocompost) to increase the productivity of soils in degraded reclaimed lands, carried out under the conditions of a lysimetric experiment on a stationary site, when growing annual grasses (vetch-oat mixture). It was experimentally established that effluent and biocompost based on sewage sludge and manure had a positive effect (in the first year of aftereffect) on the productivity and biological activity of soddy-podzolic sandy loam soil of fallow reclaimed agricultural lands.


Author(s):  
Abdirashid Elmi ◽  
You Jiao ◽  
Hicham Benslim ◽  
Ali Mawof ◽  
Shiv Prasher ◽  
...  

Balancing nutrient inputs from manure and supplemental inorganic fertilizers with crop requirements should achieve crop yield goals and agro-environmental targets. We asked if composted dairy cattle manure, alone or in combination with inorganic fertilizers, could sustain the corn and soybean yields, without increasing the residual soil N and soil P saturation of a sandy-loam soil in southern Quebec, Canada. Cropping systems were continuous silage corn and corn-soybean rotation, with each phase of the rotation grown every year, for 5-yr. Cropping systems were amended with compost at rates of 0, 15, 30 and 45 Mg (wet weight) ha-1, and received supplemental inorganic fertilizer to supply 200 kg N ha-1 yr-1 to corn while assuring that corn and soybean received 45 kg P ha-1 yr-1 and 125 kg K ha-1 yr-1 from compost and inorganic fertilizer. Crop yields were similar in composted-amended and inorganically-fertilized plots. Corn yield was limited by N availability, and there was no P or K limitation in corn and soybean. Soil P saturation in the 0–15 cm layer exceeded the agro-environmental limit of 13.1% P/Al for a sandy-loam soil in Quebec, indicating that the P input exceeded crop uptake. Residual soil N concentration was affected more by the crop than the fertilizer source, with greater residual soil N in plots with higher grain production. Crop-induced priming can explain how N fertilizer cycles through the soil microbial community and is gradually mineralized during the growing season, and why crop senescence may trigger residual soil N release after harvest.


Agronomie ◽  
2002 ◽  
Vol 22 (7-8) ◽  
pp. 731-738 ◽  
Author(s):  
Roland Harrison ◽  
Sharon Ellis ◽  
Roy Cross ◽  
James Harrison Hodgson

2020 ◽  
Vol 18 (4) ◽  
pp. 84-87
Author(s):  
Yu.V. Leonova ◽  
◽  
T.A. Spasskaya ◽  

The change in the microbiological activity of sod-podzolic sandy loam soil when using coffee waste and sewage sludge as a fertilizer for oats in comparison with traditional fertilizers is considered. During the study, it was determined that the predominant groups were bacteria and actinomycetes. Bacilli and fungi are few in number. The introduction of sewage sludge and coffee waste into the sod-podzolic sandy loam soil at a dose of 10 t / ha increases the activity of the microflora of the sod-podzolic sandy loam soil, which increases the effective and potential fertility.


2004 ◽  
Vol 3 (1) ◽  
pp. 316
Author(s):  
M. Saleem Akhtar ◽  
Tammo S. Steenhuis ◽  
Brian K. Richards ◽  
Murray B. McBride

2021 ◽  
Vol 11 (12) ◽  
pp. 5499
Author(s):  
Nihal D. Salman ◽  
György Pillinger ◽  
Muammel M. Hanon ◽  
Péter Kiss

The applicability of the typical pressure–sinkage models used to characterize the soil’s bearing properties is limited to homogeneous soils (infinite thickness) that have no hard layer. At a given depth, a hard layer can have a considerable impact on the soil’s load-bearing capacity. It is thus necessary to alter the pressure–sinkage equation by taking this condition into account when assessing the load-bearing capacity. The present paper aims to determine a simple, high-fidelity model, in terms of soil characterization, that can account for the hard layer affection. To assess hard layer affection in this paper, a plate sinkage test (bevameter) was conducted on sandy loam soil. To this end, the soil was prepared by considering three bulk densities and two soil thickness levels at 7–9% moisture content levels. According to the results, this paper put forth a new perspective and related equations for characterizing bearing performance. The sinkage modulus (k) is an intrinsic soil parameter that has a determined unit of N/cm2 and is significant for managing the bearing performance. The results showed that the new modulus sinkage model incorporates the main factor of the rigid layer effect involving high fidelity that the conventional models have failed to account for.


Sign in / Sign up

Export Citation Format

Share Document