An Incremental Formulation of Constitutive Equations for Deposited Snow

1980 ◽  
Vol 25 (92) ◽  
pp. 289-307 ◽  
Author(s):  
J. Desrues ◽  
F. Darve ◽  
E. Flavigny ◽  
J.P. Navarre ◽  
A. Taillefer

AbstractThe behaviour of a snow mass under natural loadings (gravity forces, boundary conditions) can be computed by the finite-element method, in so far as a convenient formulation of the stress–strain relationship for snow is available. This paper deals with such a formulation given in incremental form.Experiments have been performed, which show that deposited snow can be considered as a non-linear visco-elastic material with memory effect. The proposed theoretical formulation takes into account these properties. The elastic part of the deformation is assumed to be isotropic and non-linear; the viscous part is expressed in terms of a creep-rate, which results from a superposition of elementary creep-rates according to Boltzmann’s principle.The values of parameters can be obtained from isotropic creep experiments. The experimental data and the resulting parameters are reported.Since the parameters were determined, the formulation of the rheological law was then tested by integration on “stress–strain paths" corresponding to other experiments of a different type, performed on the same snow. The experiments are triaxial tests at constant axial strain-rate, with a preliminary stage of isotropic compression. Experimental data are compared to theoretical curves obtained by integration of the rheological law. The calculated behaviour is consistent with the experimental results.

1980 ◽  
Vol 25 (92) ◽  
pp. 289-307 ◽  
Author(s):  
J. Desrues ◽  
F. Darve ◽  
E. Flavigny ◽  
J.P. Navarre ◽  
A. Taillefer

Abstract The behaviour of a snow mass under natural loadings (gravity forces, boundary conditions) can be computed by the finite-element method, in so far as a convenient formulation of the stress–strain relationship for snow is available. This paper deals with such a formulation given in incremental form. Experiments have been performed, which show that deposited snow can be considered as a non-linear visco-elastic material with memory effect. The proposed theoretical formulation takes into account these properties. The elastic part of the deformation is assumed to be isotropic and non-linear; the viscous part is expressed in terms of a creep-rate, which results from a superposition of elementary creep-rates according to Boltzmann’s principle. The values of parameters can be obtained from isotropic creep experiments. The experimental data and the resulting parameters are reported. Since the parameters were determined, the formulation of the rheological law was then tested by integration on “stress–strain paths" corresponding to other experiments of a different type, performed on the same snow. The experiments are triaxial tests at constant axial strain-rate, with a preliminary stage of isotropic compression. Experimental data are compared to theoretical curves obtained by integration of the rheological law. The calculated behaviour is consistent with the experimental results.


2010 ◽  
Vol 163-167 ◽  
pp. 3804-3807
Author(s):  
Ping Wu ◽  
Feng Yu

According to the analysis of existing experimental data, it is well known that the behavior of FRP-confined rectangular concrete column were mainly related to the cross section coefficient of concrete, the confinement effect coefficient and the strength of concrete. Based on experimental study and theoretical analysis, the formula for bearing capacity and ultimate axial strain of FRP-confined rectangular concrete column were proposed, and the stress-strain model with strain-hardening components or strain-softening components. The effects of every parameter on the stress-strain relationship were carefully considered. The predictions of the model agree well with test data.


2000 ◽  
Vol 627 ◽  
Author(s):  
Pierre Evesque

ABSTRACTFirst, a non linear incremental modelling is proposed to describe rheological behaviour of granular material under different simple (i.e. triaxial-, oedometric-, undrained-) stress-strain paths. Validity of isotropic-response assumption is demonstrated whatever the stress ratio as far as deformation range remains small (ε1<5%). This contradicts some recent hypothesis made on the evolution of contact distribution during anisotropic loading.


1995 ◽  
Vol 117 (1) ◽  
pp. 136-145 ◽  
Author(s):  
Jiaping Xie ◽  
Jianbo Zhou ◽  
Y. C. Fung

In order to determine the stress-strain relationship of the inner (intima and media) and outer (adventitia) layers of blood vessels in the neighborhood of the zero-stress state, bending experiments were performed on aortic strips of rats. In the experiments, one end of a strip was clamped, and a force was applied on the other end. The deflection curves of the strips were measured. By regarding the aortic strip as a curved beam, the classical beam theory was employed to analyze the strain distribution from the experimental data. A computer program dealing with nonlinear equations and nonlinear least squares optimization was developed. Strains were referred to the zero-stress state. The load-deflection relationship was then used to determine the stress-strain relationship. Certain forms of the stress-strain laws were assumed. The linear laws fit the experimental data accurately, probably because the strains during bending are quite small, although the rotations are large. The Young’s modulus of the inner layer, which consists of endothelial and smooth muscle cells and elastic lamina, was found to be three to four times larger than that of the outer layer which consists of collagen with a small amount of fibroblasts and elastin. The residual stresses and strains at the no-load state were calculated from the deduced stress-strain relationship. It is shown that large errors (up to 50 percent) in the values of the residual strains will occur if the wall material was treated as homogeneous, i.e., if the layered constitution was ignored.


2021 ◽  
Vol 337 ◽  
pp. 01018
Author(s):  
Christian Barahona ◽  
Luis Sandi ◽  
Juan Carlos Rojas ◽  
Di Emidio Gemmina ◽  
Adam Bezuijen ◽  
...  

This paper presents the results of an experimental study on the effects of testing rate on stress-strain behavior and volumetric changes of soil. A series of suction-controlled triaxial tests has been performed on reconstituted specimens of a silty sand (SM), at different stress-rates and strain-rates, respectively. The stress-strain paths were applied by using a modified version of a Bishop and Wesley device (USPv2), capable of applying independently pore-water and air pressure at both ends of the soil sample. During the isotropic compression stages loading rates of 2 and 32 kPa/h have been applied under constant suction values of 15 and 45 kPa. The drained deviator stages were conducted at the same suction levels under strain rates of 0.25 and 2.50 %/h. Results are presented in terms of applied loading rates as a function of the specimens specific volume, preconsolidation pressure, soil compressibility and deviatoric stress against strain rate. A comparison of results was made to a former study, under similar testing conditions of suction and loading rates at University of Napoli Federico II. The effect of loading rate on the soil behavior seems to have an insignificant effect on the specific volume variations, for the imposed values during the testing campaign.


2014 ◽  
Vol 69 (3) ◽  
Author(s):  
Hoong-Pin Lee ◽  
Abdullah Zawawi Awang ◽  
Wahid Omar

An experimental and analytical study on the application of Steel Strapping Tensioning Technique (SSTT) confinement on twelve high-strength concrete cylinder specimens with dimension of 100 mm and 200 mm in diameter and height respectively has been studied and presented throughout this paper. The specimens were volumetric-identically confined with two different confining materials of different mechanical properties and lateral pre-tensioning stresses, namely SSTT(HC) and SSTT(SS). All concrete specimens were tested under uniaxial compression load. The performance of SSTT-type confined specimens were studied through their stress-strain relationship upon the longitudinal and transverse deformation, mode of failure, level of lateral pre-tensioning stress, and dilatancy behaviour. The results show that high-strength concretes confined with SSTT would significantly reduce the brittleness problem and at the same time, enhancing both ultimate compressive strength and ductility up to 65% and 344%, 36% and 269% for both SSTT(HC) and SSTT(SS), respectively. Those specimens confined with higher lateral pre-tensioning stress exhibits smaller radial expansion and higher rate of axial strain, able to slow down the dilation of confined specimens under loading and thus, helps in enhancing the compressive capacity and ductility. In addition, an analytical comparison between SSTT-type confinement and conventional confinement models have been presented and the results show a linear relationship between the compressive strength enhancement and confinement ratio. Current experimental results were also validated by comparing the observed stress-strain relationship proposed by Mander. 


2011 ◽  
Vol 250-253 ◽  
pp. 1366-1370 ◽  
Author(s):  
Kai Fu Liu ◽  
Xiang Ru Yang ◽  
Xin Yu Xie ◽  
Chang Fu Wu ◽  
Yong Hai Liu

Laboratory triaxial tests of the soil reinforced with roots of Manilagrass were carried out in order to understand the stress-strain relationship. The change of shear strength indexes of the soil reinforced with roots of Manilagrass was investigated with the quantity of grassroots planted in the soil specimens. The results of laboratory triaxial tests show that the strength and capacity for resisting the deformation of soil reinforced with roots are better than those of unreinforced soil. And under the certain number of grassroots layers, the strength and capacity for resisting the deformation of soil reinforced with roots increase firstly and then reduce with the increasing of Manilagrass roots quantity. In other words, there is an optimal quantity of Manilagrass roots affecting the strength and capacity for resisting the deformation of soil reinforced with roots. The research results are important for understanding the mechanism and use of vegetation protection for slope.


1999 ◽  
Vol 122 (1) ◽  
pp. 1-9 ◽  
Author(s):  
Takamoto Itoh ◽  
Xu Chen ◽  
Toshimitsu Nakagawa ◽  
Masao Sakane

This paper proposes a simple two-surface model for cyclic incremental plasticity based on combined Mroz and Ziegler kinematic hardening rules under nonproportional loading. The model has only seven material constants and a nonproportional factor which describes the degree of additional hardening. Cyclic loading experiments with fourteen strain paths were conducted using Type 304 stainless steel. The simulation has shown that the model was precise enough to calculate the stable cyclic stress-strain relationship under nonproportional loadings. [S0094-4289(00)00101-8]


2013 ◽  
Vol 275-277 ◽  
pp. 1219-1224 ◽  
Author(s):  
Jin Li Zhang ◽  
Man Yuan ◽  
Zheng Guo Jiang ◽  
Qing Yang

Triaxial compressive tests were performed on laterite clay(LC) reinforced with different fiber contents and lengths. It was observed that the curves of stress-strain have a segmented characteristic at the critical strain. The stress-strain curves of fiber reinforced laterite clay(FRLC) were expressed by the combination of hyperbola and straight lines. The parameters of stress-strain curves were obtained by linear and nonlinear fitting method with experimental results. A three-dimensional calculation model of triaxial tests was developed on the basis of ABAQUS software. To express the stress-strain relationship of hyperbola-straight lines, user’s subroutine was established through secondary development. Based on the test conditions, a large number of calculations were conducted. There is a good agreement between the results of numerical calculations and tests. It shows that the stress-strain relationship of FRLC can be described by the hyperbola-straight line combination model.


Sign in / Sign up

Export Citation Format

Share Document