scholarly journals Effect of LPG Content on the Performance and Emissions of A Diesel-LPG Dual-Fuel Engine

1970 ◽  
Vol 46 (2) ◽  
pp. 195-200 ◽  
Author(s):  
GA Rao ◽  
AVS Raju ◽  
CVM Rao ◽  
KG Rajulu
Keyword(s):  
Diesel Engine ◽  
Diesel Fuel ◽  
Agricultural Sector ◽  
Mechanical Efficiency ◽  
Operating Conditions ◽  
Dual Fuel ◽  
Engine Operation ◽  
Engine Load ◽  
Performance And Emission ◽  
Combustion Performance

In the present work, LPG, a by-product of petroleum refining process is used to replace conventional diesel fuel, partially, for improved combustion efficiency and clean burning. A conventional diesel engine was operated on the dual-fuel mode, using LPG as the primary fuel and diesel as the pilot fuel. A four-stroke, single-cylinder diesel engine, most widely used in agricultural sector, has been considered for the purpose of experimentation. The engine was operated at a constant speed of 1500 rpm at a low engine load of 20% and a high engine load of 80%. Under both these operating conditions, combustion, performance and emission characteristics of the engine have been evaluated and compared with that of baseline diesel fuel operation. At 20 % engine load the brake thermal efficiency of the engine has found to decrease with an increase in the LPG content. On the other hand at 80% engine load, it has increased with an increase in the LPG content. Same trend has been observed with regard to the mechanical efficiency. The volumetric efficiency has decreased with an increase in the LPG content at both the loads. The engine operation is more economical on dual-fuel operation at 80% engine load, whereas at 20% engine load, diesel fuel operation is found to be better. With regard to emissions, smoke density and emissions of NOx were found to reduce with an increase in LPG content at both the loads; however, emissions of HC and CO have shown the reverse trend. Key words: Dual-Fuel; LPG; Diesel; Combustion; Performance; Emissions Load. DOI: http://dx.doi.org/10.3329/bjsir.v46i2.8186 Bangladesh J. Sci. Ind. Res. 46(2), 195-200, 2011

Comparison of Performance and Emission Characteristic of Tamanu, Mahua and Pongamia Biodiesel in a Di Diesel Engine

2013 ◽  
Vol 768 ◽  
pp. 218-225 ◽  
Author(s):  
M. Parthasarathy ◽  
J. Isaac Joshua Ramesh Lalvani ◽  
B. Parthiban ◽  
K. Annamalai
Keyword(s):  
Diesel Engine ◽  
Diesel Fuel ◽  
Alternative Fuels ◽  
Fossil Fuels ◽  
Operating Conditions ◽  
Emission Characteristic ◽  
Performance And Emission ◽  
Di Diesel Engine ◽  
Alternative Sources ◽  
Petroleum Reserves

Random extraction and consumption of fossil fuels have leads to a reduction in petroleum reserves. As for as developing countries like India is connected the need to search for alternative fuels is most urgent as India is heavily dependent upon the import of petroleum to meet its demands for automotive and power sectors. This has inspired curiously in alternative sources for petroleum based fuels. An alternative fuel must be economically competitive and environmentally acceptable. India has great potential for production of biofuels like Biodiesel from vegetable seeds. In the quest to find an alternative to the existing diesel and petrol fuels various Biodiesel and alcohol has been tried and tested in the Internal Compression engine. In this direction, an attempt has been made to investigate the performance and emission characteristic of Biodiesels and compare it with diesel. The Biodiesels considered are Tamanu, Mahua and Pongamia were tested with four stroke diesel engine. A drastic improvement in reduction of Hydrocarbon (HC) and Carbon monoxide (CO) were found for Biodiesels at high engine loads. Smoke and Nitrogen oxides (NOx) were slightly higher for Biodiesels. Biodiesels exposed similar combustion stages to diesel fuel. Therefore use of transesterified vegetable oils can be partially substituted for the diesel fuel at most operating conditions in term of the performance parameters and emissions without any engine modification.

Performance and Emission Characteristics of a Diesel Engine Using Vegetable Oil Blended Fuel

2005 ◽  
Author(s):  
Yaodong Wang ◽  
Neil Hewitt ◽  
Philip Eames ◽  
Shengchuo Zeng ◽  
Jincheng Huang ◽  
...  
Keyword(s):  
Diesel Engine ◽  
Vegetable Oil ◽  
Diesel Fuel ◽  
Emission Characteristics ◽  
Oxides Of Nitrogen ◽  
Fuel Blend ◽  
Engine Load ◽  
Performance And Emission ◽  
Fuel Blends ◽  
Co Emission

Experimental tests have been carried out to evaluate the performance and emissions characteristics of a diesel engine when fuelled by blends of 25% vegetable oil with 75% diesel fuel, 50% vegetable oil with 50% diesel fuel, 75% vegetable oil with 25% diesel fuel, and 100% vegetable oil, compared with the performance, emissions characteristics of 100% diesel fuel. The series of tests were conducted and repeated six times using each of the test fuels. 100% of ordinary diesel fuel was also used for comparison purposes. The engine worked at a fixed speed of 1500 r/min, but at different loads respectively, i.e. 0%, 25%, 50%, 75% and 100% of the engine load. The performance and the emission characteristics of exhaust gases of the engine were compared and analyzed. The experimental results showed that the carbon monoxide (CO) emission from the vegetable oil and vegetable oil/diesel fuel blends were nearly all higher than that from pure diesel fuel at the engine 0% load to 75% load. Only at the 100% engine load point, the CO emission of vegetable oil and vegetable oil/diesel fuel blends was lower than that of diesel fuel. The hydrocarbon (HC) emission of vegetable oil and vegetable/diesel fuel blends were lower than that of diesel fuel, except that 50% of vegetable oil and 50% diesel fuel blend was a little higher than that of diesel fuel. The oxides of nitrogen (NOx) emission of vegetable oil and vegetable oil/diesel fuel blends, at the range of tests, were lower than that of diesel fuel.

scholarly journals Effects Of Fe2O3 and Al2O3 Nanoparticle-Diesel Fuel Blends on the Combustion, Performance and Emission Characteristics of a Diesel Engine

2021 ◽  
Author(s):  
Mohammad Nouri ◽  
Amir Homayoon Meghdadi Isfahani ◽  
Alireza Shirneshan
Keyword(s):  
Diesel Engine ◽  
Heat Release ◽  
Heat Release Rate ◽  
Diesel Fuel ◽  
Release Rate ◽  
Emission Characteristics ◽  
Performance And Emission ◽  
Combustion Performance ◽  
Fuel Blends ◽  
Nanoparticle Additives

Abstract This research investigates the effects of the addition of Fe2O3 and Al2O3 nanoparticles (30, 60, and 90 ppm) and Fe2O3-Al2O3 hybrid nanoparticles to pure diesel fuel on the combustion, performance and emission characteristics of a diesel engine. The results indicated that fuel blends improved the combustion (in-cylinder pressure and heat release rate), performance (power, fuel consumption, and thermal and exergy efficiency), and emission characteristics of the engine. The results showed that the peak combustion pressure increased by 4% and the heat release rate was improved by 15% in comparison with pure diesel with the addition of the nanoparticles. Moreover, the rate of pressure rise increased by 18% compared to pure diesel with nanoparticle additives. Based on the results, the effects of Fe2O3 fuel blends on brake power, BTE, and CO emission were more than Al2O3 fuel blends, such that it increased power and thermal efficiency by 7.40 and 14%, respectively, and reduced CO emissions by 21.2%; moreover, the blends with Al2O3 nanoparticle additives in comparison with Fe2O3 nanoparticle blends showed a better performance in reducing BSFC (9%), NOx (23.9%), and SO2 (23.4%) emissions. Overall, the Fe2O3-Al2O3 hybrid fuel blend is the best alternative if the performance and emission characteristics of the engine are both considered.

Biodiesel/butanol blends as a pure biofuel excluding fossil fuels: Effects on diesel engine combustion, performance, and emission characteristics

2020 ◽  
Vol 234 (13) ◽  
pp. 2988-3000
Author(s):  
Yongcheng Huang ◽  
Yaoting Li ◽  
Kun Luo ◽  
Jiyuan Wang
Keyword(s):  
Diesel Engine ◽  
Diesel Fuel ◽  
Fossil Fuels ◽  
Pressure Rise ◽  
Emission Characteristics ◽  
Performance And Emission ◽  
Combustion Performance ◽  
Combustion Duration ◽  
Rise Rate ◽  
Ignition Characteristics

Although both biodiesel and n-butanol are excellent renewable biofuels, most of the existing research works merely use them as the additives for petroleum diesel. As the main fuel properties of biodiesel and n-butanol are complementary, the biodiesel/ n-butanol blends are promising to be a pure biomass-based substitute for diesel fuel. In this paper, the application of the biodiesel/ n-butanol blends on an agricultural diesel engine was comprehensively investigated, in terms of the combustion, performance, and emission characteristics. First, the biodiesel/ n-butanol blends with 10%, 20%, and 30% n-butanol by weight were prepared and noted as BBu10 (10 wt% n-butanol + 90 wt% biodiesel), BBu20 (20 wt% n-butanol + 80 wt% biodiesel), and BBu30 (30 wt% n-butanol + 70 wt% biodiesel). It was found that adding 30 wt% n-butanol to biodiesel can reduce the viscosity by 39.3% and increase the latent heat of vaporization by 57.3%. Then the engine test results showed that with the addition of n-butanol to biodiesel, the peak values of the cylinder pressure and temperature of the biodiesel/ n-butanol blends were slightly decreased, the peak values of the pressure rise rate and heat release rate of the blends were increased, the fuel ignition was delayed, and the combustion duration was shortened. BBu20 has the approximate ignition characteristics with diesel fuel. Both the brake thermal efficiency and the brake-specific fuel consumption of BBu30 were increased by the average percentages of 2.7% and 14.9%, while NO x, soot, and CO emissions of BBu30 were reduced by the average percentages of 17.6%, 34.1%, and 15.4%, compared to biodiesel. The above variations became more evident as the n-butanol proportion increased.

Coal–Water Slurry Operation in an EMD Diesel Engine

1988 ◽  
Vol 110 (3) ◽  
pp. 437-443 ◽  
Author(s):  
C. M. Urban ◽  
H. E. Mecredy ◽  
T. W. Ryan ◽  
M. N. Ingalls ◽  
B. T. Jett
Keyword(s):  
Diesel Engine ◽  
Diesel Fuel ◽  
Diesel Engines ◽  
Operating Conditions ◽  
Department Of Energy ◽  
Coal Slurry ◽  
Particulate Emissions ◽  
Development Effort ◽  
Engine Operation ◽  
Coal Burning

The U.S. Department of Energy, Morgantown Energy Technology Center has assumed a leadership role in the development of coal-burning diesel engines. The motivation for this work is obvious when one considers the magnitude of the domestic reserves of coal and the widespread use of diesel engines. The work reported in this paper represents the preliminary engine experiments leading to the development of a coal-burning, medium-speed diesel engine. The basis of this development effort is a two-stroke, 900 rpm, 216-mm (8.5-in.) bore engine manufactured by Electro-Motive Division of General Motors Corporation. The engine, in a minimally modified form, has been operated for several hours on a slurry of 50 percent (by mass) coal in water. Engine operation was achieved in this configuration using a pilot injection of diesel fuel to ignite the main charge of slurry. A standard unit injector, slightly modified by increasing diametric clearances in the injector pump and nozzle tip, was used to inject the slurry. Under the engine operating conditions evaluated, the combustion efficiency of the coal and the NOx emissions were lower than, and the particulate emissions were higher than, corresponding diesel fuel results. These initial results, achieved without optimizing the system on the coal slurry, demonstrate the potential for utilizing coal slurry fuels.

Sign in / Sign up

Export Citation Format

Share Document