scholarly journals The Potential Application of MnZn Ferrite Nanofluids for Wettability Alteration and Oil-Water Interfacial Tension Reduction

Crystals ◽  
2019 ◽  
Vol 9 (12) ◽  
pp. 626
Author(s):  
Nurul Afiqah Mohd Mokhtar ◽  
Hoe Guan Beh ◽  
Kean Chuan Lee
Keyword(s):  
Magnetic Properties ◽  
Interfacial Tension ◽  
Enhanced Oil Recovery ◽  
Oil Recovery ◽  
Potential Application ◽  
Combustion Process ◽  
Wettability Alteration ◽  
Mnzn Ferrite ◽  
Auto Combustion ◽  
Oil Water

Recently, a non-invasive method of injecting magnetic/dielectric nanofluids into the oil reservoir was used for oil recovery application. The use of magnetic nanofluids in Enhanced Oil Recovery (EOR) has been reported to improve oil recovery. It is believed that the magnetic properties of nanoparticles (NPs) have a direct influence on the viscosity and wettability of nanofluid, and on oil-water interfacial tension (IFT). Thus, Mn0.5Zn0.5Fe2O4 (MnZn) ferrites may be a good candidate to be used in nanofluids for wettability alteration and oil-water IFT reduction due to their excellent magnetic properties, such as a high initial permeability and low magnetic losses. Therefore, this work investigated the potential of MnZn ferrite NPs to alter viscosity, wettability, and oil-water IFT. MnZn Ferrite NPs have been synthesized by a sol-gel auto-combustion process. The effects of calcination temperature varying from 300 °C to 700 °C on the phase formation, microstructures such as surface morphology, and magnetic characterizations were studied. MnZn ferrite nanofluids were prepared using synthesized MnZn NPs that dispersed into brine along with sodium dodecylbenzenesulfonate (SDBS) as a dispersant, and their effects on the wettability and oil-water IFT were studied. X-ray diffraction (XRD) measurements revealed that MnZn ferrite calcined at 300 °C and 400 °C were single phase. The average crystallite size calculated through Scherrer’s equation differed from 32.0 to 87.96 nm. The results showed that the nanofluid with MnZn particles calcined at 300 °C is the best nanofluid in terms of IFT reduction and base nanofluid’s wettability alteration. Moreover, the overall results proved that nanofluid with MnZn ferrite NPs can alter the wettability of base nanofluid, oil-nanofluid IFT, and nanofluid viscosity. This study provides insights towards a better understanding of the potential application of MnZn Ferrite nanofluids to Wettability Alteration and IFT Reduction in Enhanced Oil Recovery.

scholarly journals Mechanism of active silica nanofluids based on interface-regulated effect during spontaneous imbibition

2021 ◽  
Author(s):  
Xu-Guang Song ◽  
Ming-Wei Zhao ◽  
Cai-Li Dai ◽  
Xin-Ke Wang ◽  
Wen-Jiao Lv
Keyword(s):  
Contact Angle ◽  
Interfacial Tension ◽  
Oil Recovery ◽  
Dynamic Contact Angle ◽  
Liquid Interface ◽  
Spontaneous Imbibition ◽  
Wettability Alteration ◽  
Low Permeability ◽  
Oil Water ◽  
Solid Liquid

AbstractThe ultra-low permeability reservoir is regarded as an important energy source for oil and gas resource development and is attracting more and more attention. In this work, the active silica nanofluids were prepared by modified active silica nanoparticles and surfactant BSSB-12. The dispersion stability tests showed that the hydraulic radius of nanofluids was 58.59 nm and the zeta potential was − 48.39 mV. The active nanofluids can simultaneously regulate liquid–liquid interface and solid–liquid interface. The nanofluids can reduce the oil/water interfacial tension (IFT) from 23.5 to 6.7 mN/m, and the oil/water/solid contact angle was altered from 42° to 145°. The spontaneous imbibition tests showed that the oil recovery of 0.1 wt% active nanofluids was 20.5% and 8.5% higher than that of 3 wt% NaCl solution and 0.1 wt% BSSB-12 solution. Finally, the effects of nanofluids on dynamic contact angle, dynamic interfacial tension and moduli were studied from the adsorption behavior of nanofluids at solid–liquid and liquid–liquid interface. The oil detaching and transporting are completed by synergistic effect of wettability alteration and interfacial tension reduction. The findings of this study can help in better understanding of active nanofluids for EOR in ultra-low permeability reservoirs.

Synthesis of ZnO nanoparticles for oil–water interfacial tension reduction in enhanced oil recovery

2018 ◽  
Vol 124 (2) ◽  
Author(s):  
Hassan Soleimani ◽  
Mirza Khurram Baig ◽  
Noorhana Yahya ◽  
Leila Khodapanah ◽  
Maziyar Sabet ◽  
...  
Keyword(s):  
Interfacial Tension ◽  
Enhanced Oil Recovery ◽  
Oil Recovery ◽  
Zno Nanoparticles ◽  
Tension Reduction ◽  
Oil Water

scholarly journals Nanotechnology in Enhanced Oil Recovery

Processes ◽  
2020 ◽  
Vol 8 (9) ◽  
pp. 1073 ◽  
Author(s):  
Goshtasp Cheraghian ◽  
Sara Rostami ◽  
Masoud Afrand
Keyword(s):  
Mechanical Properties ◽  
Interfacial Tension ◽  
Enhanced Oil Recovery ◽  
Oil Recovery ◽  
Physical And Mechanical Properties ◽  
Physical Characteristics ◽  
Oil Water ◽  
Very High

Nanoparticles (NPs) are known as important nanomaterials for a broad range of commercial and research applications owing to their physical characteristics and properties. Currently, the demand for NPs for use in enhanced oil recovery (EOR) is very high. The use of NPs can drastically benefit EOR by changing the wettability of the rock, improving the mobility of the oil drop and decreasing the interfacial tension (IFT) between oil/water. This paper focuses on a review of the application of NPs in the flooding process, the effect of NPs on wettability and the IFT. The study also presents a review of several investigations about the most common NPs, their physical and mechanical properties and benefits in EOR.

THE APPLICATION OF MICROBIOLOGICALLY ENHANCED OIL RECOVERY TO THE ALTON FIELD, QUEENSLAND, AUSTRALIA

1987 ◽  
Vol 27 (1) ◽  
pp. 378
Author(s):  
B.F. Towler ◽  
B. Bubela
Keyword(s):  
Interfacial Tension ◽  
Enhanced Oil Recovery ◽  
Oil Recovery ◽  
Laboratory Experiments ◽  
Stock Tank ◽  
Remaining Oil ◽  
Oil Water

The Alton Field has produced 1.875 million stock tank barrels of oil and is nearing the end of its primary life. It is proposed to enhance the recovery from the field microbiologically. Surfactant producing bacteria will be injected into the reservoir in order to lower the oil/water interfacial tension and mobilise the remaining oil. Laboratory experiments on artifical cores have demonstrated the viability of this process. This MEOR project will initially be done in a one-well cyclic Huff and Puff program.

scholarly journals Synthesis and Characterization of Polymeric Surfactant from Palm Oil Methyl Ester and Vinyl Acetate for Chemical Flooding

REAKTOR ◽  
2021 ◽  
Vol 21 (2) ◽  
pp. 65-73
Author(s):  
Agam Duma Kalista Wibowo ◽  
Pina Tiani ◽  
Lisa Aditya ◽  
Aniek Sri Handayani ◽  
Marcelinus Christwardana
Keyword(s):  
Methyl Ester ◽  
Interfacial Tension ◽  
Vinyl Acetate ◽  
Enhanced Oil Recovery ◽  
Oil Recovery ◽  
Mobility Control ◽  
Wettability Alteration ◽  
Polymeric Surfactant ◽  
Chemical Flooding

Surfactants for enhanced oil recovery are generally made from non-renewable petroleum sulfonates and their prices are relatively expensive, so it is necessary to synthesis the bio-based surfactants that are renewable and ecofriendly. The surfactant solution can reduce the interfacial tension (IFT) between oil and water while vinyl acetate monomer has an ability to increase the viscosity as a mobility control. Therefore, polymeric surfactant has both combination properties in reducing the oil/water IFT and increasing the viscosity of the aqueous solution simultaneously. Based on the study, the Critical Micelle Concentration (CMC) of Polymeric Surfactant was at 0.5% concentration with an IFT of 7.72x10-2 mN/m. The best mole ratio of methyl ester sulfonate to vinyl acetate for polymeric surfactant synthesis was 1:0.5 with an IFT of 6.7x10-3 mN/m. Characterization of the product using FTIR and HNMR has proven the creation of polymeric surfactant. Based on the wettability alteration study, it confirmed that the product has an ability to alter from the initial oil-wet to water-wet quartz surface. In conclusion, the polymeric surfactant has ultralow IFT and could be an alternative surfactant for chemical flooding because the IFT value met with the required standard for chemical flooding ranges from 10-2 to 10-3 mN/m.Keywords: Enhanced Oil recovery, Interfacial Tension, Methyl Ester Sulfonate, Polymeric surfactant, vinyl acetate

Wettability alteration and interfacial tension (IFT) reduction in enhanced oil recovery (EOR) process by ionic liquid flooding

2017 ◽  
Vol 248 ◽  
pp. 153-162 ◽  
Author(s):  
Abbas Khaksar Manshad ◽  
Mansooreh Rezaei ◽  
Siamak Moradi ◽  
Iman Nowrouzi ◽  
Amir H. Mohammadi
Keyword(s):  
Ionic Liquid ◽  
Interfacial Tension ◽  
Enhanced Oil Recovery ◽  
Oil Recovery ◽  
Wettability Alteration
Sign in / Sign up

Export Citation Format

Share Document