scholarly journals An Active Power Coordination Control Strategy for AC/DC Transmission Systems to Mitigate Subsequent Commutation Failures in HVDC Systems

Electronics ◽  
2021 ◽  
Vol 10 (23) ◽  
pp. 3044
Author(s):  
Xia Zhou ◽  
Cangbi Ding ◽  
Jianfeng Dai ◽  
Zhaowei Li ◽  
Yang Hu ◽  
...  
Keyword(s):  
Wind Power ◽  
Control Strategy ◽  
Large Scale ◽  
Power Transmission ◽  
Hvac Systems ◽  
Transmission System ◽  
Active Power ◽  
Coordination Control ◽  
Transmission Characteristics ◽  
Transmission Systems

Subsequent commutation failures (CFs) in HVDC systems will cause large-scale power flow transfer in AC/DC transmission systems and lead to overload risk in HVAC systems. In order to cope with these effects, a power coordination control strategy for the AC/DC transmission system with high-proportion wind power is proposed. Firstly, a model of the AC/DC transmission system considering the large-scale wind farms access is established by analyzing the power transmission characteristics of the AC/DC transmission system with high-proportion wind power, and the power transmission characteristics are analyzed after subsequent CFs. Secondly, the HVDC subsequent CFs can be mitigated by adjusting DC power transmission, while the active power output of the sending-end AC system is reduced by active control of wind turbine generators (WTGs) to reduce the overload risk of the HVAC system. Finally, the proposed power coordination control strategy is simulated and verified based on the established simulation model and actual power grid, and the results show that this strategy can effectively mitigate HVDC’s subsequent CFs and reduce the overload risk in HVAC systems.

scholarly journals Research on Zero-Voltage Ride Through Control Strategy of Doubly Fed Wind Turbine

Energies ◽  
2021 ◽  
Vol 14 (8) ◽  
pp. 2287
Author(s):  
Kaina Qin ◽  
Shanshan Wang ◽  
Zhongjian Kang
Keyword(s):  
Wind Turbine ◽  
Wind Power ◽  
Control Strategy ◽  
Large Scale ◽  
Sliding Mode ◽  
Stable Operation ◽  
Wide Range ◽  
Dc Bus ◽  
Doubly Fed ◽  
Zero Voltage

With the rapid increase in the proportion of the installed wind power capacity in the total grid capacity, the state has put forward higher and higher requirements for wind power integration into the grid, among which the most difficult requirement is the zero-voltage ride through (ZVRT) capability of the wind turbine. When the voltage drops deeply, a series of transient processes, such as serious overvoltage, overcurrent, or speed rise, will occur in the motor, which will seriously endanger the safe operation of the wind turbine itself and its control system, and cause large-scale off-grid accident of wind generator. Therefore, it is of great significance to improve the uninterrupted operation ability of the wind turbine. Doubly fed induction generator (DFIG) can achieve the best wind energy tracking control in a wide range of wind speed and has the advantage of flexible power regulation. It is widely used at present, but it is sensitive to the grid voltage. In the current study, the DFIG is taken as the research object. The transient process of the DFIG during a fault is analyzed in detail. The mechanism of the rotor overcurrent and DC bus overvoltage of the DFIG during fault is studied. Additionally, the simulation model is built in DIgSILENT. The active crowbar hardware protection circuit is put into the rotor side of the wind turbine, and the extended state observer and terminal sliding mode control are added to the grid side converter control. Through the cooperative control technology, the rotor overcurrent and DC bus overvoltage can be suppressed to realize the zero-voltage ride-through of the doubly fed wind turbine, and ensure the safe and stable operation of the wind farm. Finally, the simulation results are presented to verify the theoretical analysis and the proposed control strategy.

scholarly journals Instantaneous Power Control Strategy for Voltage Improvement in Power Network Equipped by Wind Generator

2021 ◽  
Vol 54 (1) ◽  
pp. 147-154
Author(s):  
Issam Griche ◽  
Sabir Messalti ◽  
Kamel Saoudi
Keyword(s):  
Power Systems ◽  
Power Control ◽  
Wind Power ◽  
Control Strategy ◽  
Large Scale ◽  
Transient Stability ◽  
Short Circuit ◽  
Dynamical Response ◽  
Instantaneous Power ◽  
Wide Range

The uncertainty of wind power brings great challenges to large-scale wind power integration. The conventional integration of wind power is difficult to adapt the demand of power grid planning and operation. This paper proposes an instantaneous power control strategy for voltage improvement in power networks using wind turbine improving the dynamical response of power systems performances (voltage and transient stability) after fault. In which the proposed control algorithm based on a new advanced control strategy to control the injected wind power into power system. The efficiency of developed control strategy has been tested using IEEE 9 Bus. Simulation results have showed that the proposed method perform better to preserve optimal performances over wide range of disturbances for both considered scenarios studied short circuit and variable loads.

scholarly journals STUDY ON EFFECT OF UPFC DEVICE IN ELECTRICAL TRANSMISSION SYSTEM: POWER FLOW ASSESSMENT

2013 ◽  
pp. 70-74
Author(s):  
CH. CHENGAIAH ◽  
R.V.S. SATYANARAYANA ◽  
G.V. MARUTHESWAR MARUTHESWAR
Keyword(s):  
Transmission Lines ◽  
Power Flow ◽  
Reactive Power ◽  
Power Transmission ◽  
Stability Limit ◽  
Transmission System ◽  
Real Time Control ◽  
Electrical Transmission ◽  
Transmission Systems ◽  
Time Control

The power transfer capability of electric transmission lines are usually limited by large signals ability. Economic factors such as the high cost of long lines and revenue from the delivery of additional power gives strong intensive to explore all economically and technically feasible means of raising the stability limit. On the other hand, the development of effective ways to use transmission systems at their maximum thermal capability. Fast progression in the field of power electronics has already started to influence the power industry. This is one direct out come of the concept of FACTS aspects, which has become feasible due to the improvement realized in power electronic devices in principle the FACTS devices should provide fast control of active and reactive power through a transmission line. The UPFC is a member of the FACTS family with very attractive features. This device can independently control many parameters. This device offers an alternative mean to mitigate transmission system oscillations. It is an important question is the selection of the input signals and the adopted control strategy for this device in order to damp power oscillations in an effective and robust manner. The UPFC parameters can be controlled in order to achieve the maximal desire effect in solving first swing stability problem. This problem appears for bulky power transmission systems with long transmission lines. In this paper a MATLAB Simulink Model is considered with UPFC device to evaluate the performance of Electrical Transmission System of 22 kV and 33kV lines. In the simulation study, the UPFC facilitates the real time control and dynamic compensation of AC transmission system. The dynamic simulation is carried out in conjunction with the N-R power flow solution sequence. The updated voltages at each N-R iterative step are interpreted as dynamic variables. The relevant variables are input to the UPFC controllers.

Improving Active Output Capacity of Large-Scale Wind Farm by Installation STATCOM

2012 ◽  
Vol 588-589 ◽  
pp. 574-577 ◽  
Author(s):  
Yan Juan Wu ◽  
Lin Chuan Li
Keyword(s):  
Control Strategy ◽  
Large Scale ◽  
Wind Farm ◽  
Transient Stability ◽  
Reactive Power ◽  
Feedforward Control ◽  
Wind Farms ◽  
Active Power ◽  
Utilization Efficiency ◽  
Grid Voltage

Some faults will result wind turbine generators off-grid due to low grid voltage , furthermore, large-scale wind farms tripping can result in severe system oscillation and aggravate system transient instability . In view of this, static compensator (STATCOM) is installed in the grid containing large-scale wind farm. A voltage feedforward control strategy is proposed to adjust the reactive power of STATCOM compensation and ensure that the grid voltage is quickly restored to a safe range. The mathematical model of the doubly-fed induction wind generator (DFIG) is proposed. The control strategy of DFIG uses PI control for rotor angular velocity and active power. 4-machine system simulation results show that the STATCOM reactive power compensation significantly improve output active power of large-scale wind farm satisfying transient stability, reduce the probability of the tripping, and improve the utilization efficiency of wind farms.

Sign in / Sign up

Export Citation Format

Share Document