scholarly journals Formation Kinetics of the Mixed Cyclopentane—Carbon Dioxide Hydrates in Aqueous Sodium Chloride Solutions

Energies ◽  
2020 ◽  
Vol 13 (17) ◽  
pp. 4388
Author(s):  
Xuebing Zhou ◽  
Ye Zhang ◽  
Xiaoya Zang ◽  
Deqing Liang

Hydrate formation from cyclopentane (CP) and carbon dioxide was measured at 281 K by powder X-ray diffraction (PXRD) and macroscopic methods. The effect of initial pressure and CP mass fraction in liquid phase was analyzed. The results showed that hydrate formation was assumed to start with the nucleation of the mixed CP-CO2 hydrate with small fraction of CO2 followed by a large continuous CO2 adsorption. Initial pressure was found to have a positive correlation with the total CO2 consumptions when the initial pressure was below 2.5 MPa. However, the total CO2 consumptions dropped by over a half as the initial pressure was 3.0 MPa. PXRD revealed that all the hydrate samples formed at different initial pressures were structure II. The CO2 consumptions were assumed to be inhibited by the competitive occupation of 51264 cages between CP and CO2 molecules when the initial pressure was above 2.5 MPa. The CO2 consumptions were also found to be reduced as the CP mass fraction was above 0.25. An excess of CP molecules was not assumed to strengthen the formation of the mixed CP-CO2 hydrates at the initial stage, but increased the thickness of liquid CP film at aqueous brine and hydrate particles, which increased the diffusion resistance of CO2 molecules. Therefore, the suitable initial pressure and the CP mass fraction for the mixed CP-CO2 hydrate formation should be around 2.5 MPa and 0.2, respectively.

2009 ◽  
Vol 23 (7) ◽  
pp. 3711-3715 ◽  
Author(s):  
Seong-Pil Kang ◽  
Yutaek Seo ◽  
Wonho Jang

2018 ◽  
Vol 49 ◽  
pp. 385-392 ◽  
Author(s):  
Shidong Zhou ◽  
Hongyu Yan ◽  
Di Su ◽  
Seetharaman Navaneethakannan ◽  
Yuandao Chi

2021 ◽  
Vol 4 (10(112)) ◽  
pp. 38-44
Author(s):  
Mykola Porokhnia ◽  
Musii Tseitlin ◽  
Svitlana Bukhkalo ◽  
Vladimir Panasenko ◽  
Tetiana Novozhylova

This paper reports a study into the influence of temperature and gas consumption on the carbonization kinetics (saturation with carbon dioxide) of sodium carbonate-bicarbonate solution. The study also examined the quality and speed of crystal formation in this process. This research is predetermined by the environmental problems faced by modern enterprises that produce purified sodium bicarbonate – an insufficient degree of carbonization and, as a result, excessive air pollution with carbon dioxide, which did not participate in the reaction during the process. This study addresses these particular issues. As a result of using specialized laboratory equipment, it was found that an increase in the absorbent temperature from 79 to 85 °C leads to a decrease in the maximum degree of carbonization of the solution from 64 to 59 %. In contrast, the quality of the resulting sodium bicarbonate crystals improves but only in the range from 79 to 82 °C. With a further increase in temperature, the quality stabilizes. It is shown that the carbonization rate increases with increasing specific consumption of the absorbent (carbon dioxide) and is characterized by a negative correlation with the value of oversaturation of the absorbent in terms of NaНCO3. The quality of sodium bicarbonate crystals decreases with increasing gas velocity. Thus, it was reasonable to assume that the established dependence of the kinetics of carbonization of Na2CO3 and NaНCO3 solution on the gas velocity in the apparatus is explained by the inhibition of СО2 absorption, which is caused by the diffusion resistance of sodium bicarbonate crystallization. To improve the quality of crystals and the productivity of carbonization by reducing the supersaturation in terms of NaНCO3, it is recommended to introduce a seed crystal in the zone of binding of crystals in the carbonization columns.


Author(s):  
E. Busillo ◽  
V. I. Savchenko ◽  
V. S. Arutyunov

Abstract A detailed kinetic modeling of the noncatalytic processes of thermal pyrolysis and steam and carbon dioxide reforming of methane revealed almost completely identical kinetics of the methane conversion in these processes. This suggests that, in the temperature range 1400–1800 K, the initial stage of conversion of methane in all these processes is its thermal pyrolysis. The modeling results agree well with the experimental data on methane pyrolysis. For the temperature range examined, the Arrhenius expressions (pre-exponential factors and activation energy) were obtained in the first-order kinetics approximation for the rate of methane conversion in the processes studied. The expressions derived may be useful for making preliminary estimates and carrying out engineering calculations.


2015 ◽  
Vol 3 (6) ◽  
pp. 1205-1214 ◽  
Author(s):  
Gaurav Bhattacharjee ◽  
Asheesh Kumar ◽  
Tushar Sakpal ◽  
Rajnish Kumar

2011 ◽  
Vol 306-307 ◽  
pp. 966-969
Author(s):  
Chun Fang Wang ◽  
Zong Hui Zhou ◽  
Cai Xia Liu ◽  
Xin Cheng

Through testing the amount of the free lime and the Loss ignition, the clinker formation rate, the reaction-rate constant (K) and the activation energy (Ea) were calculated according to the Gentling equation and Arrhenius equation. The effects of CaF2on the formation kinetics of Portland cement clinker were investigated by analyzing theKandEa. X-ray diffraction (XRD) and scanning electron Microscope (SEM) were used to characterize the phase composition and the morphology of the resulting samples. The results show that the silicate minerals formation is promoted when a proper amount of CaF2is doped into the raw meal. TheKincreased from 0.7450 ×10-5s-1to 7.1588 ×10-5s-1and theEadecreased from 386 kJ/mol to 122 kJ/mol when the amount of CaF2increased from 0.0% to 2.0% in mass. However, the results were reversed at the amount of CaF2exceeding 2%.


1995 ◽  
Vol 398 ◽  
Author(s):  
A. Tomasi ◽  
E. Galvanetto ◽  
F.C. Matacotta ◽  
P. Nozar ◽  
P. Scardi ◽  
...  

ABSTRACTA systematic study on phase formation and stabilisation in the Ba-Cu-C-O system in the temperature range 20-500°C, under various atmospheres, by traditional thermal analysis techniques, high temperature X-ray diffraction and high resolution electron microscopy, has permitted to identify and characterise the formation kinetics of a new copper containing phase isomorphic to γ-BaCO3.


2016 ◽  
Vol 55 (29) ◽  
pp. 7964-7972 ◽  
Author(s):  
Asheesh Kumar ◽  
Tushar Sakpal ◽  
Gaurav Bhattacharjee ◽  
Anupam Kumar ◽  
Rajnish Kumar

1994 ◽  
Vol 9 (2) ◽  
pp. 275-285 ◽  
Author(s):  
V. Milonopoulou ◽  
K.M. Forster ◽  
J.P. Formica ◽  
J. Kulik ◽  
J.T. Richardson ◽  
...  

The YBa2Cu3O7−x formation kinetics from a spray-roasted precursor powder containing Y2O3, BaCO3, and CuO was followed via in situ, time-resolved x-ray diffraction as a function of gas atmosphere and temperature. In inert atmospheres, BaCO3 and CuO form BaCu2O2 which subsequently reacts with Y2O3 to form YBa2Cu3O6. However, YBa2Cu3O6 decomposes at temperatures exceeding 725 °C with Y2BaCuO5 being one of the decomposition products. In oxidizing atmospheres, YBa2Cu3O7−x formation involves the BaCuO2. At high temperatures (800–840 °C), oxygen increases the yield of YBa2Cu3O6. A nuclei growth model assuming two-dimensional, diffusion-controlled growth with second-order nucleation rate fits the experimental data.


Sign in / Sign up

Export Citation Format

Share Document