scholarly journals Approximation of Hysteresis Changes in Electrical Steel Sheets

Energies ◽  
2021 ◽  
Vol 14 (14) ◽  
pp. 4110
Author(s):  
Witold Mazgaj ◽  
Michal Sierzega ◽  
Zbigniew Szular

This paper describes a simple method of approximating hysteresis changes in electrical steel sheets. This method is based on assumptions that flux density or field strength changes are a sum or a difference of functions that describe one curve of the limiting hysteresis loop and a certain ‘transient’ component. Appropriate formulas that present the flux density as functions of the field strength and those that present inverse dependencies are proposed. An application of this approximation requires knowledge of the measured limiting hysteresis loop and a few minor loops. Algorithms for determining changes in the flux density or field strength are proposed and discussed. The correctness of the proposed approximation of hysteresis changes was verified through a comparison of measured hysteresis loops with the loops calculated for several different excitations of the magnetic field occurring in dynamo and transformer steel sheets. Additionally, an example of the application of the proposed approximation of hysteresis changes is discussed in the paper. The proposed approximation of hysteresis changes is recommended for numerical calculations of the magnetic field distribution in dynamo and transformer steel sheets.

2016 ◽  
Vol 63 (0) ◽  
pp. 71-82
Author(s):  
Dominika GAWORSKA-KONIAREK ◽  
Jerzy BAJOREK ◽  
Wiesław WILCZYŃSKI

The paper presents, based on a review of relevant literature, the existing problems of magnetic field strength measurements of electrical steel sheets by means of the indirect and direct methods. It also describes some attempts to solve these problems. The magnetic field strength sensors most widely used for testing electrical steel sheets are also discussed.


2006 ◽  
Vol 126 (3) ◽  
pp. 127-134 ◽  
Author(s):  
Shinya Urata ◽  
Takashi Todaka ◽  
Masato Enokizono ◽  
Hiroyasu Shimoji

2019 ◽  
Vol 632 ◽  
pp. A13 ◽  
Author(s):  
Y. Stein ◽  
R.-J. Dettmar ◽  
M. Weżgowiec ◽  
J. Irwin ◽  
R. Beck ◽  
...  

Context. The radio continuum halos of edge-on spiral galaxies have diverse morphologies, with different magnetic field properties and cosmic ray (CR) transport processes into the halo. Aims. Using the Continuum HAloes in Nearby Galaxies – an EVLA Survey (CHANG-ES) radio continuum data from the Karl G. Jansky Very Large Array (VLA) in two frequency bands, 6 GHz (C-band) and 1.5 GHz (L-band), we analyzed the radio properties, including polarization and the transport processes of the CR electrons (CREs), in the edge-on spiral galaxy NGC 4013. Supplementary LOw-Frequency ARray (LOFAR) data at 150 MHz are used to study the low-frequency properties of this galaxy and X-ray data are used to investigate the central region. Methods. We determined the total radio flux densities (central source, disk, halo and total) as well as the radio scale heights of the radio continuum emission at both CHANG-ES frequencies and at the LOFAR frequency. We derived the magnetic field orientation from CHANG-ES polarization data and rotation measure synthesis (RM synthesis). Furthermore, we used the revised equipartition formula to calculate the magnetic field strength. Lastly, we modeled the processes of CR transport into the halo with the 1D SPINNAKER model. Results. The central point source dominates the radio continuum emission with a mean of ∼35% of the total flux density emerging from the central source in both CHANG-ES bands. Complementary X-ray data from Chandra show one dominant point source in the central part. The XMM-Newton spectrum shows hard X-rays, but no clear AGN classification is possible at this time. The radio continuum halo of NGC 4013 in C-band is rather small, while the low-frequency LOFAR data reveal a large halo. The scale height analysis shows that Gaussian fits, with halo scale heights of 1.2 kpc in C-band, 2.0 kpc in L-band, and 3.1 kpc at 150 MHz, better represent the intensity profiles than do exponential fits. The frequency dependence gives clear preference to diffusive CRE transport. The radio halo of NGC 4013 is relatively faint and contributes only 40% and 56% of the total flux density in C-band and L-band, respectively. This is less than in galaxies with wind-driven halos. While the SPINNAKER models of the radio profiles show that advection with a launching velocity of ∼20 km s−1 (increasing to ∼50 km s−1 at 4 kpc height) fits the data equally well or slightly better, diffusion is the dominating transport process up to heights of 1–2 kpc. The polarization data reveal plane-parallel, regular magnetic fields within the entire disk and vertical halo components indicating the presence of an axisymmetric field having a radial component pointing outwards. The mean magnetic field strength of the disk of NGC 4013 of 6.6 μG is rather small. Large-scale vertical fields are observed in the halo out to heights of about 6 kpc. Conclusions. The interaction and the low star formation rate (SFR) across the disk of NGC 4013 probably influence the appearance of its radio continuum halo and are correlated with the low total magnetic field strength. Several observable quantities give consistent evidence that the CR transport in the halo of NGC 4013 is diffusive: the frequency dependence of the synchrotron scale height, the disk/halo flux density ratio, the vertical profile of the synchrotron spectral index, the small propagation speed measured modeled with SPINNAKER, and the low temperature of the X-ray emitting hot gas.


2013 ◽  
Vol 543 ◽  
pp. 472-475
Author(s):  
Vasiliki Roussi ◽  
Clio G. Vossou

The purpose of this paper is to calibrate the magnetic field coming out of an excitation coil of certain specifications, fabricated for non-destructing testing of electrical steel sheets. Thus, a comparison between experimental and numerical analysis is discussed. For the experimental estimation of the magnetic field, a sensitive Hall sensor is used to measure the dc field at a vertical array of three selected points inside the coil. These are the lower, the middle and the upper point of the coil cross section, respectively. The magnetic field is then computed theoretically using the finite element method and the BiotSavart law. Measured results are in agreement with the calculated results of the excitation field very well, within the limits of our experimental set-up.


1968 ◽  
Vol 35 ◽  
pp. 600-600
Author(s):  
S. J. Gopasyuk ◽  
N. N. Erushev ◽  
Y. I. Neshpor

We consider the variation of the synchrotron-flux density of relativistic electrons with the power law spectrum when the region of generation of this emission initially experiences a homogeneous compression and then an expansion. Ionization losses have been taken into account. The velocities of compression and expansion have been taken as constant. It is shown that in the cases of compression or expansion the flux density at a given frequency changes asS(t) ~ S0Kγ(t)where S0 = flux density before the compression, γ = index of the power law spectrum, K(t) = (H(t))/(H0 (t = 0)), and H is the magnetic-field strength. In the case of compression K(t) > 1·0 and in the case of expansion K(t)< 1·0.The results obtained are applied to an explanation of the increasing and decreasing parts of impulsive bursts of the centimeter range. Such a description of the impulsive bursts has allowed us to estimate both the parameters of the radiating region and the parameters of the differential energetic spectrum of relativistic electrons.


Sign in / Sign up

Export Citation Format

Share Document