scholarly journals Investigation of Graphene Derivatives on Electrical Properties of Alkali Activated Slag Composites

Materials ◽  
2021 ◽  
Vol 14 (16) ◽  
pp. 4374
Author(s):  
Wu-Jian Long ◽  
Xuanhan Zhang ◽  
Biqin Dong ◽  
Yuan Fang ◽  
Tao-Hua Ye ◽  
...  

Reduced graphene oxide (rGO) has been widely used to modify the mechanical performance of alkali activated slag composites (AASC); however, the mechanism is still unclear and the electrical properties of rGO reinforced AASC are unknown. Here, the rheological, mechanical, and electrical properties of the AASC containing rGO nanosheets (0, 0.1, 0.2, and 0.3 wt.%) are investigated. Results showed that rGO nanosheets addition can significantly improve the yield stress, plastic viscosity, thixotropy, and compressive strength of the AASC. The addition of 0.3 wt.% rGO nanosheets increased the stress, viscosity, thixotropy, and strength by 186.77 times, 3.68 times, 15.15 times, and 21.02%, respectively. As for electrical properties, the impedance of the AASC increased when the rGO content was less than 0.2 wt.% but decreased with the increasing dosage. In contrast, the dielectric constant and electrical conductivity of the AASC containing rGO nanosheets decreased and then increased, which can be attributed to the abundant interlayer water and the increasing structural defects as the storage sites for charge carriers, respectively. In addition, the effect of graphene oxide (GO) on the AASC is also studied and the results indicated that the agglomeration of GO nanosheets largely inhibited the application of it in the AASC, even with a small dosage.

2018 ◽  
Vol 760 ◽  
pp. 55-60 ◽  
Author(s):  
Pavel Rovnaník ◽  
Ivo Kusák

Alkali-activated slag is an alternative binder to the ordinary Portland cement. In order to improve its tensile properties steel fibres as dispersed reinforcement can be used. Since steel is very good conductor it changes the electrical properties of alkali-activated slag composite that can have a potential to be used as self-sensing material then. In this study up to 20% of steel fibres by mass of the slag was added to alkali-activated slag mortar and the mechanical properties, electrical resistance, capacitance and microstructure of the composites were investigated. The results showed that the best improvement of both the mechanical and electrical properties can be observed for the composite with 15% of steel fibres.


2018 ◽  
Vol 276 ◽  
pp. 15-20 ◽  
Author(s):  
Pavel Rovnaník ◽  
Maria Míková ◽  
Ivo Kusák ◽  
Patrik Bayer

Alkali-activated slag is known as a building material for more than sixty years and is considered an alternative to Portland cement based binders. Compared to Portland cement it exhibits some superior properties such as higher resistance against chemical attack and exposure to elevated temperatures. Aluminosilicate binders are generally electrical insulators; however, electrical properties of building materials gain the importance in the new field of applications such as self-sensing or self-heating materials. This paper brings a comparison of the electrical properties, especially resistance and capacitance, between Portland cement and alkali-activated slag mortars. The measurements revealed that alkali-activated slag shows enhanced conducting properties due to the presence of mobile hydrated sodium ions and metallic iron microparticles.


Sign in / Sign up

Export Citation Format

Share Document