scholarly journals The Surface Photogalvanic and Photon Drag Effects in Ag/Pd Metal-Semiconductor Nanocomposite

Nanomaterials ◽  
2021 ◽  
Vol 11 (11) ◽  
pp. 2827
Author(s):  
Aleksandr S. Saushin ◽  
Gennady M. Mikheev ◽  
Viatcheslav V. Vanyukov ◽  
Yuri P. Svirko

We performed the investigation of the polarization-sensitive photocurrent generated in silver-palladium metal-semiconductor nanocomposite films under irradiation with nanosecond laser pulses at the wavelength of 2600 nm. It is shown that in both the transverse and the longitudinal configuration, the surface photogalvanic (SPGE) and photon drag effects (PDE) contribute to the observed photocurrent. However, the temporal profile of the transverse photocurrent pulse is monopolar at any polarization and angle of incidence, while the temporal profile of the longitudinal photocurrent pulse depends on the polarization of the excitation beam. Specifically, the irradiation of the film with the s-polarized excitation beam produces a monopolar photoresponse, while at p-polarized excitation, the photoresponse is bipolar, having a short front and long tail. Obtained experimental results are in agreement with the developed phenomenological theory, which describes transverse and longitudinal photocurrents due to SPGE and PDE in terms of relevant second-order nonlinear susceptibilities and allows us to obtain their dependences on the angle of incidence and polarization of the excitation laser beam. The pronounced dependence of the photocurrent on the angle of incidence and polarization of the excitation beam opens avenues toward the development of polarization- and position-sensitive detectors for industrial and space applications.

2010 ◽  
Vol 97-101 ◽  
pp. 3803-3806
Author(s):  
Yong Xiang Hu ◽  
Heng Zhang ◽  
Zheng Qiang Yao

Laser interference micro-structuring is a relatively efficient and cost-effective technique for fabricating periodical micro-nano-structuring surfaces. The direct fabrication of sub-micron sized dot array on silicon was performed by four interfering nanosecond laser beams with a diffractive beam splitter. The mechanism to form the dot array was analyzed and it was found that the obtained conical dot array had a negative shape of the interference pattern of four laser beams. A second-order peak between two first-order peaks also occurred due to the liquid-solid expansion.


Materials ◽  
2018 ◽  
Vol 11 (12) ◽  
pp. 2547 ◽  
Author(s):  
Cristian Lavieja ◽  
Luis Oriol ◽  
José-Ignacio Peña

A nanosecond green laser was employed to obtain both superhydrophobic and superhydrophilic surfaces on a white commercial acrylonitrile-butadiene-styrene copolymer (ABS). These wetting behaviors were directly related to a laser-induced superficial modification. A predefined pattern was not produced by the laser, rather, the entire surface was covered with laser pulses at 1200 DPI by placing the sample at different positions along the focal axis. The changes were related to the laser fluence used in each case. The highest fluence, on the focal position, induced a drastic heating of the material surface, and this enabled the melted material to flow, thus leading to an almost flat superhydrophilic surface. By contrast, the use of a lower fluence by placing the sample 0.8 µm out of the focal position led to a poor material flow and a fast cooling that froze in a rugged superhydrophobic surface. Contact angles higher than 150° and roll angles of less than 10° were obtained. These wetting behaviors were stable over time.


2020 ◽  
Vol 21 (2) ◽  
pp. 215-218
Author(s):  
I. A. Mohylyak ◽  
O. Yu. Bonchyk ◽  
S. A. Korniy ◽  
S. G. Kiyak ◽  
D. I. Popovych

Experimental studies of the features of the formation of laser-induced periodic nanostructures on the surface of silicon wafers in the zones of action of second, millisecond and nanosecond laser pulses are conducted in the work. The results of microscopic investigations by optical and electron microscopes of periodic structures formed on surfaces with crystallographic orientation (111), (100) are presented. The obtained results can be used to optimize the laser pulse mode for controlled micro- nanostructuring of the semiconductor surface.


Sign in / Sign up

Export Citation Format

Share Document