scholarly journals Crystallization in Zirconia Film Nano-Layered with Silica

Nanomaterials ◽  
2021 ◽  
Vol 11 (12) ◽  
pp. 3444
Author(s):  
Brecken Larsen ◽  
Christopher Ausbeck ◽  
Timothy F. Bennet ◽  
Gilberto DeSalvo ◽  
Riccardo DeSalvo ◽  
...  
Keyword(s):  
Crystal Growth ◽  
Optical Cavity ◽  
Amorphous Material ◽  
Crystal Formation ◽  
X Ray Diffraction ◽  
Noise Sources ◽  
X Ray ◽  
Reflective Coating ◽  
Zirconia Film ◽  
Limit Sensitivity

Gravitational waves are detected using resonant optical cavity interferometers. The mirror coatings’ inherent thermal noise and photon scattering limit sensitivity. Crystals within the reflective coating may be responsible for either or both noise sources. In this study, we explored crystallization reduction in zirconia through nano-layering with silica. We used X-ray diffraction (XRD) to monitor crystal growth between successive annealing cycles. We observed crystal formation at higher temperatures in thinner zirconia layers, indicating that silica is a successful inhibitor of crystal growth. However, the thinnest barriers break down at high temperatures, thus allowing crystal growth beyond each nano-layer. In addition, in samples with thicker zirconia layers, we observe that crystallization saturates with a significant portion of amorphous material remaining.

scholarly journals Synthesis of magnesium carbonate hydrate from natural talc

2020 ◽  
Vol 18 (1) ◽  
pp. 951-961
Author(s):  
Qiuju Chen ◽  
Tao Hui ◽  
Hongjuan Sun ◽  
Tongjiang Peng ◽  
Wenjin Ding
Keyword(s):  
Crystal Structure ◽  
Particle Size ◽  
Crystal Growth ◽  
Crystal Morphology ◽  
Magnesium Carbonate ◽  
Organic Additives ◽  
X Ray Diffraction ◽  
Morphological Transformation ◽  
X Ray ◽  
Carbonation Process

AbstractVarious morphologies of magnesium carbonate hydrate had been synthesized without using any organic additives by carefully adjusting the reaction temperature and time during the talc carbonation process. At lower temperatures, magnesium carbonate hydrate was prone to display needle-like morphology. With the further increase of the carbonation temperature, the sheet-like crystallites became the preferred morphology, and at higher aging temperatures, these crystallites tended to assemble into layer-like structures with diverse morphologies, such as rose-like particles and nest-like structure. The reaction time had no effect on the crystal morphology, but it affected the particle size and situation of the crystal growth. X-Ray diffraction results showed that these various morphologies were closely related to their crystal structure and compositions. The needle-like magnesium carbonate hydrate had a formula of MgCO3·3H2O, whereas with the morphological transformation from needle-like to sheet-like, rose-like, and nest-like structure, their corresponding compositions also changed from MgCO3·3H2O to 4MgCO3·Mg(OH)2·8H2O, 4MgCO3·Mg(OH)2·5H2O, and 4MgCO3·Mg(OH)2·4H2O.

scholarly journals Perbaikan Kelarutan Albendazol Melalui Pembentukan Kristal Multikomponen dengan Asam Malat

2020 ◽  
Vol 6 (1) ◽  
pp. 114-123
Author(s):  
Fikri Alatas ◽  
Fahmi Abdul Azizsidiq ◽  
Titta Hartyana Sutarna ◽  
Hestyari Ratih ◽  
Sundani Nurono Soewandhi
Keyword(s):  
Phase Solubility ◽  
Crystal Formation ◽  
Solubility Curve ◽  
X Ray Diffraction ◽  
Ethanol Mixture ◽  
X Ray ◽  
Grinding Method ◽  
Diffraction Patterns ◽  
Phase Solubility Curve

An effort to improve the solubility of albendazole (ABZ), an anthelmintic drug has been successfully carried out through the formation of multicomponent crystal with dl-malic acid (MAL). Construction of phase solubility curve of ABZ in MAL solution and crystal morphological observations after recrystallization in the acetone-ethanol (9:1) mixture were performed for initial prediction of multicomponent crystal formation. ABZ-MAL multicomponent crystal was prepared by wet grinding or also known as solvent-drop grinding (SDG) with acetone-ethanol (9:1) mixture as a solvent followed by characterization of the multicomponent crystal formation by powder X-ray diffraction and Fourier transform infrared (FTIR) methods. The solubility of ABZ-MAL multicomponent crystal was tested in water at ambient temperature and in pH 1.2, 4.5 and 6.8 of buffered solutions at 37°C. The phase solubility curve of the ABZ in the MAL solution showed type Bs. The ABZ-MAL mixture has a different crystalline morphology than pure ABZ and MAL after recrystallization in the acetone-ethanol mixture (9:1). The powder X-ray diffraction pattern and the FTIR spectrum of ABZ-MAL from SDG different from intact ABZ and MAL powder X-ray diffraction patterns and these results can indicate the ABZ-MAL multicomponent crystal formation. The ABZ-MAL multicomponent crystal has better solubility than pure ABZ in all media used. These results can be concluded that ABZ-MAL multicomponent crystal can be prepared by solvent-drop grinding method with acetone-ethanol (9:1) mixture as a solvent and can increase the solubility of albendazole.

scholarly journals In situ X-ray Diffraction Investigation of the Crystallisation of Perfluorinated Ce(IV)-based Metal-Organic Frameworks with UiO-66 and MIL-140 architectures

2020 ◽  
Author(s):  
Stephen Shearan ◽  
Jannick Jacobsen ◽  
Ferdinando Costantino ◽  
Roberto D’Amato ◽  
Dmitri Novikov ◽  
...  
Keyword(s):  
Crystal Growth ◽  
Metal Organic Frameworks ◽  
Building Blocks ◽  
Nucleation And Growth ◽  
X Ray Diffraction ◽  
X Ray ◽  
Rate Determining Step ◽  
Wide Range ◽  
Metal Organic

We report on the results of a thorough <i>in situ</i> synchrotron powder X-ray diffraction study of the crystallisation in aqueous medium of two recently discovered perfluorinated Ce(IV)-based metal-organic frameworks (MOFs), analogues of the already well investigated Zr(IV)-based UiO-66 and MIL-140A, namely, F4_UiO-66(Ce) and F4_MIL-140A(Ce). The two MOFs were originally obtained in pure form in similar conditions, using ammonium cerium nitrate and tetrafluoroterephthalic acid as building blocks, and small variations of the reaction parameters were found to yield mixed phases. Here, we investigate the crystallisation of these compounds <i>in situ</i> in a wide range of conditions, varying parameters such as temperature, amount of the protonation modulator nitric acid (HNO<sub>3</sub>) and amount of the coordination modulator acetic acid (AcOH). When only HNO<sub>3</sub> is present in the reaction environment, F4_MIL-140A(Ce) is obtained as a pure phase. Heating preferentially accelerates nucleation, which becomes rate determining below 57 °C, whereas the modulator influences nucleation and crystal growth to a similar extent. Upon addition of AcOH to the system, alongside HNO<sub>3</sub>, mixed-phased products, consisting of F4_MIL-140A(Ce) and F4_UiO-66(Ce), are obtained. In these conditions, F4_UiO-66(Ce) is always formed faster and no interconversion between the two phases occurs. In the case of F4_UiO-66(Ce), crystal growth is always the rate determining step. An increase in the amount of HNO<sub>3</sub> slows down both nucleation and growth rates for F4_MIL-140A(Ce), whereas nucleation is mainly affected for F4_UiO-66(Ce). In addition, a higher amount HNO<sub>3</sub> favours the formation of F4_MIL-140A(Ce). Similarly, increasing the amount of AcOH leads to slowing down of the nucleation and growth rate, but favours the formation of F4_UiO-66(Ce). The pure F4_UiO-66(Ce) phase could also be obtained when using larger amounts of AcOH in the presence of minimal HNO<sub>3</sub>. Based on these <i>in situ</i> results, a new optimised route to achieving a pure, high quality F4_MIL-140A(Ce) phase in mild conditions (60 °C, 1 h) is also identified.

Determination of Amorphous Material in Peat Ash by X-ray Diffraction

2005 ◽  
pp. 217-224 ◽  
Author(s):  
Minna S. Tiainen ◽  
Juha S. Ryynänen ◽  
Juha T. Rantala ◽  
H. Tapio Patrikainen ◽  
Risto S. Laitinen
Keyword(s):  
Amorphous Material ◽  
X Ray Diffraction ◽  
X Ray

Co-crystal formation between 2-amino-4,6-dimethylpyrimidine and new p-xylylene-bis(thioacetic) acid

CrystEngComm ◽  
2014 ◽  
Vol 16 (44) ◽  
pp. 10262-10272 ◽  
Author(s):  
A. Ostasz ◽  
R. Łyszczek ◽  
L. Mazur ◽  
B. Tarasiuk
Keyword(s):  
Thermal Analysis ◽  
Infrared Spectroscopy ◽  
Single Crystal ◽  
Crystal Formation ◽  
Thioacetic Acid ◽  
X Ray Diffraction ◽  
X Ray ◽  
Analysis Methods

Novelp-xylylene-bis(thioacetic) acid (p-XBTA) and its co-crystals with 2-amino-4,6-dimethylpyrimidine (DMP) have been synthesized and characterized by single-crystal X-ray diffraction, infrared spectroscopy and thermal analysis methods (TG/DSC).

Sign in / Sign up

Export Citation Format

Share Document