scholarly journals Conformity of the NASADEM_HGT and ALOS AW3D30 DEM with the Altitude from the Brazilian Geodetic Reference Stations: A Case Study from Brazilian Cerrado

Sensors ◽  
2021 ◽  
Vol 21 (9) ◽  
pp. 2935
Author(s):  
Giovana Maranhão Bettiol ◽  
Manuel Eduardo Ferreira ◽  
Luiz Pacheco Motta ◽  
Édipo Henrique Cremon ◽  
Edson Eyji Sano
Keyword(s):  
Decision Makers ◽  
Surface Model ◽  
Brazilian Cerrado ◽  
Digital Elevation ◽  
Class B ◽  
Crucial Information ◽  
Error Standard Deviation ◽  
Elevation Model ◽  
Main Region

The Brazilian Cerrado (tropical savanna) is the second largest biome in South America and the main region in the country for agricultural production. Altitude is crucial information for decision-makers and planners since it is directly related to temperature that conditions, for example, the climatic risk of rainfed crop plantations. This study analyzes the conformity of two freely available digital elevation models (DEMs), the NASADEM Merged Digital Elevation Model Global 1 arc second (NASADEM_HGT) version 1 and the Advanced Land Observing Satellite Global Digital Surface Model (ALOS AW3D30), version 3.1, with the altitudes provided by 1695 reference stations of the Brazilian Geodetic System. Both models were evaluated based on the parameters recommended in the Brazilian Cartographic Accuracy Standard for Digital Cartographic Products (PEC-PCD), which defines error tolerances according to eight different scales (from 1:1000 to 1:250,000) and classes A (most strict tolerance, for example, 0.17 m for 1:1000 scale), B, C, and D (least strict tolerance, for example, 50 m for 1:250,000 scale). Considering the class A, the NASADEM_HGT meets 1:250,000 and lower scales, while AW3D30 meets 1:100,000 and lower scales; for class B, NASADEM_HGT meets 1:100,000 scale and AW3D30 meets 1:50,000. AW3D30 presented lower values of root mean square error, standard deviation, and bias, indicating that it presents higher accuracy in relation to the NASADEM_HGT. Within eight of Cerrado’s municipalities with the highest grain production, the differences between average altitudes, measured by the Cohen’s effect size, were statistically insignificant. The results obtained by the PEC-PCD for the Cerrado biome indicate that both models can be employed in different DEM-dependent applications over this biome.

Boots on the Ground at Yaxnohcah

2016 ◽  
Vol 4 (3) ◽  
pp. 314-338 ◽  
Author(s):  
Kathryn Reese-Taylor ◽  
Armando Anaya Hernández ◽  
F. C. Atasta Flores Esquivel ◽  
Kelly Monteleone ◽  
Alejandro Uriarte ◽  
...  
Keyword(s):  
Surface Model ◽  
Large Area ◽  
Vegetation Zones ◽  
Digital Elevation ◽  
Major Species ◽  
Ground Truthing ◽  
Elevation Model ◽  
Accuracy Of Results ◽  
Type 2 Errors

AbstractThis study proposes a sampling method for ground-truthing LiDAR-derived data that will allow researchers to verify or predict the accuracy of results over a large area. Our case study is focused on a 24 km2area centered on the site of Yaxnohcah in the Yucatan Peninsula. This area is characterized by a variety of dense tropical rainforest and wetland vegetation zones with limited road and trail access. Twenty-one 100 x 100 m blocks were selected for study, which included examples of several different vegetation zones. A pedestrian survey of transects through the blocks was conducted, recording two types of errors. Type 1 errors consist of cultural features that are identified in the field, but are not seen in the digital elevation model (DEM) or digital surface model (DSM). Type 2 errors consist of features that appear to be cultural when viewed on the DEM or DSM, but are caused by different vegetative features. Concurrently, we conducted an extensive vegetation survey of each block, identifying major species present and heights of stories. The results demonstrate that the lidar survey data are extremely reliable and a sample can be used to assess data accuracy, fidelity, and confidence over a larger area.

scholarly journals Morphometric analysis and prioritization of upper Benue River watershed, Northern Nigeria

2021 ◽  
Vol 11 (2) ◽  
Author(s):  
Caleb Akoji Odiji ◽  
Olaide Monsor Aderoju ◽  
Joseph Bisong Eta ◽  
Idris Shehu ◽  
Adama Mai-Bukar ◽  
...  
Keyword(s):  
Management Strategies ◽  
Decision Makers ◽  
Order System ◽  
Hydrological Process ◽  
Drainage Pattern ◽  
River Watershed ◽  
Digital Elevation ◽  
Hypsometric Integral ◽  
Cumulative Length ◽  
Elevation Model

AbstractThe upper Benue River watershed is undergoing remarkable modifications due to man-made and natural phenomena. Hence, an evaluation is required to understand the hydrological process of the watershed for planning and management strategies. This study aimed to assess the morphometric characteristics and prioritize the upper Benue River watershed. The boundary of the watershed and sub-watersheds, as well as stream networks, was extracted from the digital elevation model (DEM) coupled with hydrological and topographic maps. Twenty-eight morphometric parameters under three categories, i.e. linear, areal, and relief aspects were computed and mapped. Findings from the study revealed that the watershed is a seventh stream order system characterized by a dendritic drainage pattern. The result also showed that 4821 streams were extracted with a cumulative length of 30,232.84 km. The hypsometric integral of the watershed was estimated to be 0.22, indicating that it is in the old stage. In the prioritization of the watershed, the morphometric variables were utilized to calculate and classify the compound factor. The result showed that sub-watersheds 12, 16, 18, 24, 26, and 27 were ranked as very high priority for which conservation measures are required to mitigate the risk of flood and erosion. The outcome of this study can be used by decision-makers for sustainable watershed management and planning.

scholarly journals APPLICATION OF DSM IN OBSTACLE CLEARANCE SURVEYING OF AERODROME

2016 ◽  
Vol XLI-B2 ◽  
pp. 227-233 ◽  
Author(s):  
X. Qiao ◽  
S. H. Lv ◽  
L. L. Li ◽  
X. J. Zhou ◽  
H. Y. Wang ◽  
...  
Keyword(s):  
Digital Elevation Model ◽  
Satellite Imagery ◽  
Primary Objective ◽  
Considerable Improvement ◽  
Surface Model ◽  
Digital Surface Model ◽  
Horizontal Position ◽  
Obstacle Clearance ◽  
Digital Elevation ◽  
Elevation Model

Compared to the wide use of digital elevation model (DEM), digital surface model (DSM) receives less attention because that it is composed by not only terrain surface, but also vegetations and man-made objects which are usually regarded as useless information. Nevertheless, these objects are useful for the identification of obstacles around an aerodrome. The primary objective of the study was to determine the applicability of DSM in obstacle clearance surveying of aerodrome. According to the requirements of obstacle clearance surveying at QT airport, aerial and satellite imagery were used to generate DSM, by means of photogrammetry, which was spatially analyzed with the hypothetical 3D obstacle limitation surfaces (OLS) to identify the potential obstacles. Field surveying was then carried out to retrieve the accurate horizontal position and height of the obstacles. The results proved that the application of DSM could make considerable improvement in the efficiency of obstacle clearance surveying of aerodrome.

scholarly journals Environmental monitoring of soil pollution in urban areas (a case study from Heraklion city, Central Crete, Greece)

2017 ◽  
Vol 47 (2) ◽  
pp. 963
Author(s):  
E. Kokinou ◽  
C. Belonaki ◽  
D. Sakadakis ◽  
K. Sakadaki
Keyword(s):  
Magnetic Susceptibility ◽  
Urban Areas ◽  
Magnetic Measurements ◽  
Topographic Map ◽  
Near Surface ◽  
Thermomagnetic Analysis ◽  
Geological Features ◽  
Digital Elevation ◽  
Elevation Model

Main scope of the present study is to combine topographic and geological data, magnetic susceptibility and thermomagnetic analysis in order to investigate the magnetic properties of the near surface soils in possible polluted urban areas. For this purpose, a power plant with a dense traffic net around it, located in the NW section of Heraklion city in Crete was selected to be the study area. Surface soil samples have been collected from the area under investigation and they were analyzed in order to estimate the spatial distribution of the magnetic susceptibility. Loci of high values of the magnetic susceptibility within the study area gave rise to further proceed to thermomagnetic analysis of the selected samples. GIS techniques were used for mapping the magnetic measurements on the various topographic and geological features of the area. The digital elevation model was created by the digitization of the topographic map contours (1:5000 scale maps). The combination of the above techniques indicate high values of the magnetic susceptibility especially in the northeastern part of the investigated area, possibly related to pollution due to the presence of heavy metals.

scholarly journals Geodetic work at the archaeological site Tell el-Retaba

2018 ◽  
Vol 17 (2) ◽  
pp. 65-80
Author(s):  
Eva Stopková
Keyword(s):  
Spatial Data ◽  
Statistical Modelling ◽  
Archaeological Site ◽  
The North ◽  
Digital Elevation ◽  
North Eastern ◽  
Elevation Model ◽  
Modern Technologies

The paper summarizes the geodetic contribution for the Slovak team within the joint Polish-Slovak archaeological mission at Tell el-Retaba in Egypt. Surveying work at archaeological excavations is usually influenced by somewhat specific subject of study and extreme conditions, especially at the missions in the developing countries. The case study describes spatial data development according to the archaeological conventions in order to document spatial relationships between the objects in excavated trenches. The long-term sustainability of surveying work at the site has been ensured by detailed metadata recording. Except the trench mapping, Digital Elevation Model has been calculated for the study area and for the north-eastern part of the site, with promising preliminary results for further detection and modelling of archaeological structures. In general, topographic mapping together with modern technologies like Photogrammetry, Satellite Imagery, and Remote Sensing provide valuable data sources for spatial and statistical modelling of the sites; and the results offer a different perspective for the archaeological research.

scholarly journals Improving estimation of glacier volume change: a GLIMS case study of Bering Glacier System, Alaska

2008 ◽  
Vol 2 (1) ◽  
pp. 33-51 ◽  
Author(s):  
M. J. Beedle ◽  
M. Dyurgerov ◽  
W. Tangborn ◽  
S. J. S. Khalsa ◽  
C. Helm ◽  
...  
Keyword(s):  
Volume Change ◽  
Balance Model ◽  
Drainage Basins ◽  
Landsat Images ◽  
Glacier System ◽  
Digital Elevation ◽  
Bering Glacier ◽  
Elevation Model ◽  
Dependent Mass

Abstract. The Global Land Ice Measurements from Space (GLIMS) project has developed tools and methods that can be employed by analysts to create accurate glacier outlines. To illustrate the importance of accurate glacier outlines and the effectiveness of GLIMS standards we conducted a case study on Bering Glacier System (BGS), Alaska. BGS is a complex glacier system aggregated from multiple drainage basins, numerous tributaries, and many accumulation areas. Published measurements of BGS surface area vary from 1740 to 6200 km2, depending on how the boundaries of this system have been defined. Utilizing GLIMS tools and standards we have completed a new outline (3630 km2) and analysis of the area-altitude distribution (hypsometry) of BGS using Landsat images from 2000 and 2001 and a US Geological Survey 15-min digital elevation model. We compared this new hypsometry with three different hypsometries to illustrate the errors that result from the widely varying estimates of BGS extent. The use of different BGS hypsometries results in highly variable measures of volume change and net balance (bn). Applying a simple hypsometry-dependent mass-balance model to different hypsometries results in a bn rate range of −1.0 to −3.1 m a−1 water equivalent (W.E.), a volume change range of −3.8 to −6.7 km3 a−1 W.E., and a near doubling in contributions to sea level equivalent, 0.011 mm a−1 to 0.019 mm a−1. Current inaccuracies in glacier outlines hinder our ability to correctly quantify glacier change. Understanding of glacier extents can become comprehensive and accurate. Such accuracy is possible with the increasing volume of satellite imagery of glacierized regions, recent advances in tools and standards, and dedication to this important task.

Sign in / Sign up

Export Citation Format

Share Document