A Parametric Study on a Diesel Engine Fuelled Using Waste Cooking Oil Blended with Al2O3 Nanoparticle—Performance, Emission, and Combustion Characteristics

As the environment is humiliated at a disturbing rate, most governments have persistent calls following global energy policies for the utilization of biofuels. This paper essentially examines the portrayal investigations of fatty acid methyl esters and fatty acid pentyl esters obtained from palm oil. The characterization studies such as gas chromatogram, mass spectrometry, and Fourier transformed infrared spectrometry have been performed to study biodiesel’s chemical composition. This article likewise shows biodiesel’s physiochemical properties and concentrates on biodiesel blends’ hypothetical combustion properties with Al2O3 nanoparticles. The spectroscopic investigations demonstrate the contiguity of eight methyl esters and five pentyl esters prevalently of palmitic acid, oleic acid, octanoic acid, and stearic acid. The esters’ nearness was additionally affirmed by the FTIR range, where the peaks in the scope of 1700 cm−1 to 1600 cm−1 can be observed. Looking at the thermophysical properties of the mixes with that of the base diesel fuel yielded the compromising results by giving the comparative density to that of the diesel fuel. The palm oil biodiesel’s calorific value is, by all accounts, diminished by 10% when contrasted with diesel fuel. The addition of the nanoparticles up to 1 g has raised the calorific value most closely to the diesel’s value. Correspondingly, the theoretical burning examinations have demonstrated the limit of biodiesel to go about as an option compared to consistent diesel in the conventional DI–CI engine. This article talks about the combustion attributes of the blend containing 60% diesel, 20% fatty acid methyl ester (FAME), and 20% fatty acid pentyl ester (FAPE) with aluminium oxide (Al2O3) nanoparticles at two distinctive concentrations. This article primarily concerns the inquiry of combustion criterion, such as in-chamber pressure variation, rate of heat release, start of combustion, end of combustion, and ignition delay for considered fuel blends when contrasted with neat diesel fuel in a four-stroke, direct-injection, single-cylinder diesel engine. The results showed a decrease in in-cylinder pressure at all loads of engine operation for biodiesel blends when compared with neat diesel, irrespective of the nanoparticle concentration. Biodiesel blends at all nanoparticle concentrations showed an increase in ignition delay compared with diesel fuels at all engine operation loads. The performance results show a slight deterioration in the engine’s thermal efficiency using biodiesel blends, irrespective of the nanoparticle concentration. Additionally, the emissions show a considerable fall in trends for all loads in contrast with diesel fuel.