scholarly journals Persulfate Process Activated by Homogeneous and Heterogeneous Catalysts for Synthetic Olive Mill Wastewater Treatment

Water ◽  
2021 ◽  
Vol 13 (21) ◽  
pp. 3010
Author(s):  
Eva Domingues ◽  
Maria João Silva ◽  
Telma Vaz ◽  
João Gomes ◽  
Rui C. Martins

Wastewaters from the olive oil industry are a regional environmental problem. Their phenolic content provides inherent toxicity, which reduces the treatment potential of conventional biological systems. In this study, Sulfate Radical based Advanced Oxidation Processes (SRbAOPs) are compared with advanced oxidation processes (namely Fenton’s peroxidation) as a depuration alternative. Synthetic olive mill wastewaters were submitted to homogeneous and heterogeneous SRbAOPs using iron sulfate and solid catalysts (red mud and Fe-Ce-O) as the source of iron (II). The homogenous process was optimized by testing different pH values, as well as iron and persulfate loads. At the best conditions (pH 5, 300 mg/L of iron and 600 mg/L of persulfate), it was possible to achieve 39%, 63% and 37% COD, phenolic compounds and TOC removal, respectively. The catalytic potential of a waste (red mud) and a laboratory material (Fe-Ce-O) was tested using heterogenous SRbAOPs. The best performance was achieved by Fe-Ce-O, with an optimal load of 1600 mg/L. At these conditions, 27%, 55% and 5% COD, phenolic compounds and TOC removal were obtained, respectively. Toxicity tests on A. fischeri and L. sativum showed no improvements in toxicity from the treated solutions when compared with the original one. Thus, SRbAOPs use a suitable technology for synthetic OMW.

2020 ◽  
Vol 700 ◽  
pp. 134576 ◽  
Author(s):  
Abeer Al-Bsoul ◽  
Mohammad Al-Shannag ◽  
Muhammad Tawalbeh ◽  
Ahmed A. Al-Taani ◽  
Walid K. Lafi ◽  
...  

Water ◽  
2020 ◽  
Vol 12 (10) ◽  
pp. 2811
Author(s):  
Dheaya Alrousan ◽  
Arsalan Afkhami ◽  
Khalid Bani-Melhem ◽  
Patrick Dunlop

In keeping with the circular economy approach, reclaiming greywater (GW) is considered a sustainable approach to local reuse of wastewater and a viable option to reduce household demand for freshwater. This study investigated the mineralization of total organic carbon (TOC) in GW using TiO2-based advanced oxidation processes (AOPs) in a custom-built stirred tank reactor. The combinations of H2O2, O3, and immobilized TiO2 under either dark or UVA irradiation conditions were systematically evaluated—namely TiO2/dark, O3/dark (ozonation), H2O2/dark (peroxidation), TiO2/UVA (photocatalysis), O3/UVA (Ozone photolysis), H2O2/UVA (photo-peroxidation), O3/TiO2/dark (catalytic ozonation), O3/TiO2/UVA (photocatalytic ozonation), H2O2/TiO2/dark, H2O2/TiO2/UVA, H2O2/O3/dark (peroxonation), H2O2/O3/UVA (photo-peroxonation), H2O2/O3/TiO2/dark (catalytic peroxonation), and H2O2/O3/TiO2/UVA (photocatalytic peroxonation). It was found that combining different treatment methods with UVA irradiation dramatically enhanced the organic mineralization efficiency. The optimum TiO2 loading in this study was observed to be 0.96 mg/cm2 with the highest TOC removal (54%) achieved using photocatalytic peroxonation under optimal conditions (0.96 mg TiO2/cm2, 25 mg O3/min, and 0.7 H2O2/O3 molar ratio). In peroxonation and photo-peroxonation, the optimal H2O2/O3 molar ratio was identified to be a critical efficiency parameter maximizing the production of reactive radical species. Increasing ozone flow rate or H2O2 dosage was observed to cause an efficiency inhibition effect. This lab-based study demonstrates the potential for combined TiO2-AOP treatments to significantly reduce the organic fraction of real GW, offering potential for the development of low-cost systems permitting safe GW reuse.


Author(s):  
Blanka Galbičková ◽  
Maroš Soldán ◽  
Michal Belčík ◽  
Karol Balog

Abstract Utilization of AOPs (Advanced oxidation processes) as an emerging technology for removing of pollutants from wastewater is developed. In this paper, UV photodegradation was used for removing of phenol from wastewater. As a source of UV radiation medium pressure mercury lamp with output 400W was used. The influence of low-cost catalysts on this process was also monitored. Wastes from metal production, red mud and black nickel mud, were used as catalysts.


2021 ◽  
Author(s):  
Durkhani Kakar

The oxidation of benzene, toluene, ethylbenzene, and xylenes (BTEX) by advanced oxidation processes in water was investigated. The degradation of BTEX by UV-185 and UV-254 nm in conjunction with H₂O₂ was studied. It was observed that the recommended H₂0₂ concentration to degrade 100 mgTOC/L of BTEX was 250 mg/L and 300 mg/L for UV-185 and UV-254 nm, respectively. In addition, it was observed that using the lamps in series did not have any advantages in the TOC removal of BTEX. Under acidic condition, pH 3, UV-185/H₂O₂ removed 10% more than UV-254/H₂O₂. At the recommended H₂O₂ concentration, 90% of BTEX mineralization was occurred with UV-185 nm/HO₂ under acidic condition of pH 3. It was observed that 21-32% BOD/TOC ratio of BTEX was decreased with an increase in residence time (within 140 min) in the photoreactor.


Sign in / Sign up

Export Citation Format

Share Document