scholarly journals Feasibility of Recycled Concrete in Pavements with Demolished Building Waste in UAE

2019 ◽  
Vol 8 (3) ◽  
pp. 5773-5778

The growing population has increased the demand for residential and commercial buildings. As a result of demolition of these buildings, lot of construction waste is generated. Most of these waste are non-biodegradable. When put into landfills, these waste pollute the land and harm the environment. Therefore, need of recycling these materials and using them is necessary. Concrete aggregates from demolished buildings can be reused to make concrete. However, its strength is immensely affected due to cement paste and mortar attached to it. Experimental research was carried out to determine how strengths of concrete made of natural aggregate, rejected concrete batch aggregate, aggregate from 8 years and 16 years old demolished buildings vary and also the feasibility of each. Different ratios of each type of recycled aggregates were taken along with the natural aggregates to determine how strength varies with change in ratio.

Materials ◽  
2020 ◽  
Vol 13 (19) ◽  
pp. 4378
Author(s):  
Ana Elisabete Paganelli Guimarães de Avila Jacintho ◽  
Ivanny Soares Gomes Cavaliere ◽  
Lia Lorena Pimentel ◽  
Nádia Cazarim Silva Forti

This paper presents a study with concretes produced with natural aggregates, recycled concrete aggregates (RCA) and waste porcelain aggregates (WPA). The study analyzed the influence of recycled aggregates in the mechanical properties of conventional concretes and evaluated the difference between measured and predicted values of elasticity modulus. The incorporation of WPA in concrete showed better mechanical results compared to the concretes produced with RCA. Measured elasticity moduli were lower than moduli predicted by NBR 6118:2014 and fib Model Code 2010, while measured results were greater than values predicted by Eurocode 2:2004 and ACI 318:2014, as expected, which indicated the safety of the latter two standards.


Materials ◽  
2021 ◽  
Vol 14 (24) ◽  
pp. 7499
Author(s):  
Miren Etxeberria

The fabrication of conventional concrete, as well as remains from demolition, has a high environmental impact. This paper assessed the eco-efficiency of concrete made with uncarbonated recycled concrete aggregates (RCA) and fly ash (FA). Two concrete series were produced with an effective water/cement ratio of 0.50 (Series 1) and 0.40 (Series 2). In both series, concretes were produced using 0% and 50% of RCA with 0%, 25% and 50% FA. After analysing the compressive strength, and carbonation and chloride resistance of those concretes, their eco-efficiency based on the binder intensity and CO2-eq intensity was assessed. We found that the use of 50% uncarbonated RCA improved the properties of concretes produced with FA with respect to using natural aggregates. The concrete made of 25% FA plus RCA was considered the most eco-efficient based on the tests of compressive, carbonation and chloride properties with the values of 4.1 kg CO2 m−3 MPa−1, 76.3 kg CO2 m−3 mm−1 year0.5 and 0.079 kg CO2 m−3 C−1, respectively. The uncarbonated RCA improved carbonation resistance, and FA improved chloride resistance. It can be concluded that the use of 50% un-carbonated RCA combined with FA considerably enhanced the properties of hardened concrete and their eco-efficiency with respect to concretes produced with natural aggregates.


2015 ◽  
Vol 10 (1) ◽  
pp. 83-90
Author(s):  
Jozef Junak ◽  
Nadezda Stevulova

Abstract This paper presents the results obtained from the research focused on the utilization of crushed concrete waste aggregates as a partial or full replacement of 4/8 and 8/16 mm natural aggregates fraction in concrete strength class C 16/20. Main concrete characteristics such as workability, density and compressive strength were studied. Compressive strength testing intervals for samples with recycled concrete aggregates were 2, 7, 14 and 28 days. The amount of water in the mixtures was indicative. For mixture resulting consistency required slump grade S3 was followed. Average density of all samples is in the range of 2250 kg/m3 to 2350 kg/m3. The highest compressive strength after 28 days of curing, 34.68 MPa, reached sample, which contained 100% of recycled material in 4/8 mm fraction and 60% of recycled aggregates in 8/16 mm fraction. This achieved value was only slightly different from the compressive strength 34.41 MPa of the reference sample.


Crystals ◽  
2021 ◽  
Vol 11 (6) ◽  
pp. 695
Author(s):  
Natt Makul ◽  
Roman Fediuk ◽  
Mugahed Amran ◽  
Abdullah M. Zeyad ◽  
Sergey Klyuev ◽  
...  

Currently, a number of disadvantages hampers the use of recycled concrete aggregates (RCA). The current review proves that concretes made with complete replacement of natural aggregate with RCA allow the production of high-quality concrete. One of the possibilities for improving concrete properties with RCA is the use of extended curing and pozzolanic materials with varying cement ratios. The potential use of RCA concretes is in the production of high-value materials that increase environmental and financial benefits. RCA have strong potential in the development of a new generation of concrete and stimulate economic activity in many countries in addition to optimizing natural resources. Economic benefits include minimal travel costs; cheaper sources of concrete than newly mined aggregates; reduction of the landfill area required for the placement of concrete waste; the use of RCA minimizes the need for gravel extraction, etc. The proposed strategy could be to sequentially separate demolition waste such as roof finishes, waterproof materials, interior and exterior materials, etc. Closing life cycles is the main approach used for efficient structures for the recycling and reuse of construction and demolition waste in the production and recovery of materials, especially when recycling and reusing materials. In the life cycle, the recycling of recovered materials allows them to be used for new construction purposes, avoiding the use of natural concrete aggregates. Government, design institutes, construction departments and project managers should be involved in the creation and use of RCA. In demolition and construction, the main players are the project owners. Their obligations, expectations and responsibilities must be properly aligned. For the past 20 years, recycled concrete aggregate from demolition and construction waste has been considered as an alternative to pure concrete in structural concrete to minimize the environmental impact of construction waste and demolition waste and the conversion of natural aggregate resources. It is now recognized that the use of RCA for the generations of concrete is a promising and very attractive technology for reducing the environmental impact of the construction sector and conserving natural resources. In the market, the selling price is not an obstacle for market applications of RCA, as there are scenarios in which their cost is lower than the cost of products made from conventional building materials. This is more of an acceptance factor in the market for recycled concrete aggregates. In this sector, the lack of identification, accreditation and uniform quality certification systems and their narrow application cause some marketing problems. With proper RCA preparation, concrete with standard physical and mechanical properties and performance characteristics can be obtained.


2021 ◽  
Author(s):  
Talina Zeidan ◽  
Xavier Farina

<p>In Belgium, the presence of numerous quarries in the Walloon region makes recycled concrete aggregates (RCA) less attractive for structural concrete applications: since the natural aggregates are at reach, it is unprofitable from both a financial and an environmental aspect to use RCA. In addition, the supply of recycled aggregates on the Belgian market is lacking. Only a few recyclers produce type A+ RCA, which could be used in ready-mix concrete, but tend to keep them for their own productions. Furthermore, although the revised Belgian national concrete standard (NBN B 15- 001) allows cast-in-situ concrete to contain higher fractions of recycled aggregates, there is presently no concrete supplier yet certified to produce concrete with recycled aggregates. One should finally note the lack of stimulation or even mandatory incentives by the Authorities to promote the use of RCA. The aim of this paper is to identify the various reasons behind RCA limitations in Belgium and to suggest solutions to overcome them.</p>


2021 ◽  
Vol 11 (20) ◽  
pp. 9525
Author(s):  
Enrique F. Ledesma ◽  
Angélica Lozano-Lunar ◽  
Ruan L. S. Ferreira ◽  
José María Fernández-Rodríguez ◽  
José Ramón Jiménez

This article shows the preliminary results of a study carried out to determine the technical feasibility of encapsulating a high percentage of EAFD in cement-based mortars manufactured with the fine fraction of recycled concrete aggregates (RCA). Two families of mortars, with natural aggregate as a reference and with RCA, were studied. An incorporation rate by weight of two parts mortar to one part EAFD was tested. The mechanical strengths (compressive strength and tensile strength) before and after immersion in water, the rate of delitescence and the leaching behavior were studied. Mortars made with RCA showed similar mechanical strengths to the reference mortars made with natural aggregates; however, the incorporation of EAFD decreased the mechanical strengths. Encapsulation considerably reduced the leaching of heavy metals, although the Pb concentration remained above the hazardous waste limit. With this preliminary study, two wastes are managed together, and the results have shown that the use of RCA instead of natural aggregate is a viable alternative since it does not significantly impair the mechanical or leaching properties of the cement-based matrices used to encapsulate EAFD.


2019 ◽  
Vol 11 (13) ◽  
pp. 3730 ◽  
Author(s):  
Juan J. Galan ◽  
Luís M. Silva ◽  
Ignacio Pérez ◽  
Ana R. Pasandín

The present work is a re-evaluation of previous research on the durability of hot-mix asphalt made with recycled concrete aggregates from construction and demolition waste (CDW) with a different approach. Response surface methodology (RSM) was used to conduct this study. The kind of natural aggregates (schist and calcite-dolomite), the recycled concrete aggregates percentage (0%, 20%, 40% and 60%) and the water saturation (0% and 100%) were the pertinent factors for this methodology. Indirect tensile stress (ITS) was determined in mixtures fabricated with 0%, 20%, 40% and 60% recycled concrete aggregates. According to the results, the ITS of the bituminous mixtures increases as the percentage of recycled concrete aggregate increases. This behavior is more significant when calcite-dolomite is used as a natural aggregate. Water saturation has the same influence in both natural aggregates. The indirect tensile strength ratio (ITSR) was calculated to evaluate the stripping potential. According to the Spanish specifications, the results suggest that the percentage of CDW that can be used for hot mixes is 17% when schist is used as natural aggregate and 14% for calcite-dolomite.


2014 ◽  
Vol 600 ◽  
pp. 256-263 ◽  
Author(s):  
Said Kenai ◽  
Belkacem Menadi ◽  
Amina Debbih ◽  
El Hadj Kadri

Self-compacting concrete (SCC) is a very fluid concrete in which its compaction can take place under the effect of its own weight, without vibration. SCC is characterized by its high volume of paste, and the use of superplasticizers. Very little work is reported in the literature on the use of recycled aggregates in SCC. The main objective of this paper is to study the effect of coarse and fine recycled concrete aggregates on the fresh properties of SCC, by substitution of either 100% or 50% of natural aggregates by recycled aggregates. The effect of substitution of 15% by weight of cement of natural pozzolana on the fresh properties of SCC is also studied. The results have shown that the substitution of 50% or 100% of natural aggregates by recycled concrete aggregates gives SCC with very comparable rheological properties to that of the reference SCC. However, SCC with recycled aggregates are less stable against bleeding. The addition of natural pozzolana decreases workability for both SCC with natural aggregates or with recycled aggregates.


2020 ◽  
Vol 39 (3) ◽  
pp. 640-646
Author(s):  
A.W. Otunyo ◽  
B.G. Jephter

The paper tried to investigate the structural characteristics of concrete produced by partially replacing natural aggregates with recycled aggregates at varying water/cement ratios. The study is basically a laboratory experimental study. Water/cement ratio component of the concrete were varied at 0.40, 0.45, 0.50, 0.55, 0.60; while the natural aggregate was partially replaced with RCA of 0%, 15%, 30%, 45%, 60%, 75% and 90% for concrete productions for 7, 14 and 28 days structural characteristics. The densities, water absorption capacity and Compressive Strength of these concretes were determined. The results were presented in graphs and Tables. Results of the study indicate an increased compressive strength at low percentage of RCA and water /cement ratio values. There is a marginal difference between compressive strength of normal concrete and concrete produced by partial RCA of 15% replacement at 0.4 w/c ratio. Keywords: recycled concrete aggregate, natural aggregate, compressive strength, water/ cement ratio and natural aggregate concrete.


2016 ◽  
Vol 12 (1) ◽  
pp. 1-12 ◽  
Author(s):  
Ion Robu ◽  
Claudiu Mazilu ◽  
Radu Deju

Abstract Using recycled concrete aggregates (RCA) is a matter of high priority in the construction industry worldwide. In countries like the Netherlands, Denmark, Germany, USA, Japan, France recycled concrete aggregates obtained from demolition are valorized up to 90%, mainly for road construction and less in the manufacture of new concrete. Recycled concrete aggregates (RCA) generally result from a two-stage crushing of the concrete obtained from demolition followed by the screening and removal of contaminants (wood, plastic, metal, ceramics etc.). The literature review showed that the recycled aggregates concrete (RAC) are less resistant, with 15 to 40% versus concrete obtained using natural aggregates. The factors that play a role in the reducing of mechanical resistance are presented and analyzed in this study. This paper presents a study on the use of recycled aggregates, from a concrete of specified class, to acquire new cement concrete with different percentages of recycled aggregates. In order to evaluate the influence upon the properties of the new concrete obtained, recycled aggregates have been characterized in terms of the granulosity, the granule shape, the absorption of water, behavior to the Los Angeles test, the content of attached mortar etc.


Sign in / Sign up

Export Citation Format

Share Document