scholarly journals Effect of nanostructured carbon coatings on the electrochemical performance of Li1.4Ni0.5Mn0.5O2+ x -based cathode materials

2016 ◽  
Vol 7 ◽  
pp. 1960-1970 ◽  
Author(s):  
Konstantin A Kurilenko ◽  
Oleg A Shlyakhtin ◽  
Oleg A Brylev ◽  
Dmitry I Petukhov ◽  
Alexey V Garshev
Keyword(s):  
Diffusion Coefficient ◽  
Charge Transfer ◽  
Specific Capacity ◽  
Charge Transfer Resistance ◽  
Poly Vinyl Alcohol ◽  
Nanostructured Carbon ◽  
Transfer Resistance ◽  
Carbon Coatings ◽  
Lithium Diffusion Coefficient ◽  
Electrochemical Cycling

Nanocomposites of Li1.4Ni0.5Mn0.5O2+ x and amorphous carbon were obtained by the pyrolysis of linear and cross-linked poly(vinyl alcohol) (PVA) in presence of Li1.4Ni0.5Mn0.5O2+ x . In the case of linear PVA, the formation of nanostructured carbon coatings on Li1.4Ni0.5Mn0.5O2+ x particles is observed, while for cross-linked PVA islands of mesoporous carbon are located on the boundaries of Li1.4Ni0.5Mn0.5O2+ x particles. The presence of the carbon framework leads to a decrease of the polarization upon cycling and of the charge transfer resistance and to an increase in the apparent Li+ diffusion coefficient from 10−16 cm2·s−1 (pure Li1.4Ni0.5Mn0.5O2+ x ) to 10−13 cm2·s−1. The nanosized carbon coatings also reduce the deep electrochemical degradation of Li1.4Ni0.5Mn0.5O2+ x during electrochemical cycling. The nanocomposite obtained by the pyrolysis of linear PVA demonstrates higher values of the apparent lithium diffusion coefficient, a higher specific capacity and lower values of charge transfer resistance, which can be related to the more uniform carbon coatings and to the significant content of sp2-hybridized carbon detected by XPS and by Raman spectroscopy.

scholarly journals Electrochemical Impedance Spectroscopy on the Performance Degradation of LiFePO4/Graphite Lithium-Ion Battery Due to Charge-Discharge Cycling under Different C-Rates

Energies ◽  
2019 ◽  
Vol 12 (23) ◽  
pp. 4507 ◽  
Author(s):  
Yusuke Abe ◽  
Natsuki Hori ◽  
Seiji Kumagai
Keyword(s):  
Charge Transfer ◽  
Electrochemical Impedance Spectroscopy ◽  
Impedance Spectroscopy ◽  
Electrochemical Impedance ◽  
Specific Capacity ◽  
Lithium Ion ◽  
Performance Degradation ◽  
Charge Transfer Resistance ◽  
Transfer Resistance ◽  
Charge Discharge

Lithium-ion batteries (LIBs) using a LiFePO4 cathode and graphite anode were assembled in coin cell form and subjected to 1000 charge-discharge cycles at 1, 2, and 5 C at 25 °C. The performance degradation of the LIB cells under different C-rates was analyzed by electrochemical impedance spectroscopy (EIS) and scanning electron microscopy. The most severe degradation occurred at 2 C while degradation was mitigated at the highest C-rate of 5 C. EIS data of the equivalent circuit model provided information on the changes in the internal resistance. The charge-transfer resistance within all the cells increased after the cycle test, with the cell cycled at 2 C presenting the greatest increment in the charge-transfer resistance. Agglomerates were observed on the graphite anodes of the cells cycled at 2 and 5 C; these were more abundantly produced in the former cell. The lower degradation of the cell cycled at 5 C was attributed to the lowered capacity utilization of the anode. The larger cell voltage drop caused by the increased C-rate reduced the electrode potential variation allocated to the net electrochemical reactions, contributing to the charge-discharge specific capacity of the cells.

scholarly journals The Effect of Plasticizers on the Polypyrrole-Poly(vinyl alcohol)-Based Conducting Polymer Electrolyte and Its Application in Semi-Transparent Dye-Sensitized Solar Cells

Membranes ◽  
2021 ◽  
Vol 11 (10) ◽  
pp. 791
Author(s):  
KM Manikandan ◽  
Arunagiri Yelilarasi ◽  
SS Saravanakumar ◽  
Raed H. Althomali ◽  
Anish Khan ◽  
...  
Keyword(s):  
Charge Transfer ◽  
Polymer Electrolyte ◽  
Vinyl Alcohol ◽  
Ethylene Carbonate ◽  
Dye Sensitized Solar Cells ◽  
Charge Transfer Resistance ◽  
Poly Vinyl Alcohol ◽  
Average Roughness ◽  
Transfer Resistance ◽  
Doped Polymer

In this work, the quasi-solid-state polymer electrolyte containing poly(vinyl alcohol)-polypyrrole as a polymer host, potassium iodide (KI), iodine (I2), and different plasticizers (EC, PC, GBL, and DBP) was successfully prepared via the solution casting technique. Fourier transform infrared spectroscopy (FTIR) was used to analyze the interaction between the polymer and the plasticizer. X-ray diffraction confirmed the reduction of crystallinity in the polymer electrolyte by plasticizer doping. The ethylene carbonate-based polymer electrolyte showed maximum electrical conductivity of 0.496 S cm−1. The lowest activation energy of 0.863 kJ mol−1 was obtained for the EC-doped polymer electrolyte. The lowest charge transfer resistance Rct1 was due to a faster charge transfer at the counter electrode/electrolyte interface. The polymer electrolyte containing the EC plasticizer exhibited an average roughness of 23.918 nm. A photo-conversion efficiency of 4.19% was recorded in the DSSC with the EC-doped polymer electrolyte under the illumination of 100 mWcm−2.

scholarly journals Effect of Electrolyte Anion on Electrochemical Behavior of Nickel Hexacyanoferrate Electrode in Aqueous Sodium-Ion Batteries

2020 ◽  
Vol 58 (12) ◽  
pp. 896-906
Author(s):  
Sungjun Park ◽  
Sang-Eun Chun
Keyword(s):  
Charge Transfer ◽  
Specific Capacity ◽  
Charge Transfer Resistance ◽  
Sodium Ion ◽  
Sodium Ion Batteries ◽  
Atomic Composition ◽  
Rate Performance ◽  
Transfer Resistance ◽  
Nickel Hexacyanoferrate ◽  
Aqueous Sodium

Nickel hexacyanoferrate (NiHCF) has a three-dimensional open framework structure, excellent long-cycling stability and rate performance as a cathode for aqueous sodium-ion batteries. However, the specific capacity of NiHCF is lower than that of present cathodes for aqueous batteries. A sodium-ion electrolyte was explored to achieve optimum capacity with NiHCF. Powder-type NiHCF was fabricated by coprecipitation with the atomic composition K0.065Ni1.44Fe(CN)6·4.4H2O. The presence of Fe vacancies in the atomic composition is attributable to the inclusion of coordinating and zeolitic water during coprecipitation. Two sodium-ion electrolytes, 1 M Na2SO4 and 1 M NaNO3, were employed to analyze the electrochemical behavior of the NiHCF electrode. Identical redox potentials to 0.58 V (vs. NHE) were measured in both electrolytes. However, a lower overpotential was observed in NaNO3 compared to Na2SO4 as a result of the smaller interfacial charge transfer resistance. The lower charge transfer resistance in the NaNO3 solution produced a higher specific capacity of 57 mAh g<sup>-1</sup> (1 C-rate) and the superior capacity retention of 46.6% at 20 C-rate. The anion in the aqueous electrolyte changed the charge transfer resistance at the electrode/electrolyte interface, confirming the electrolyte anion has a crucial effect on the charge capacity and rate performance of NiHCF.

Electrochemical and spectroscopic insights of interactions between alizarin red S and arsenite ions

RSC Advances ◽  
2016 ◽  
Vol 6 (95) ◽  
pp. 93162-93168 ◽  
Author(s):  
Nahida Tanjila ◽  
Asif Rayhan ◽  
Md. Saiful Alam ◽  
Iqbal A. Siddiquey ◽  
Mohammad A. Hasnat
Keyword(s):  
Diffusion Coefficient ◽  
Charge Transfer ◽  
Charge Transfer Resistance ◽  
Alizarin Red S ◽  
Deprotonated Form ◽  
Alizarin Red ◽  
Transfer Resistance

ARS molecules are deprotonated in the presence of arsenite ions. The deprotonated form of ARS molecules show increase of charge transfer resistance and decrease of diffusion coefficient.

scholarly journals FEC Additive for Improved SEI Film and Electrochemical Performance of the Lithium Primary Battery

Energies ◽  
2021 ◽  
Vol 14 (22) ◽  
pp. 7467
Author(s):  
Xuan Zhou ◽  
Ping Li ◽  
Zhihao Tang ◽  
Jialu Liu ◽  
Shaowei Zhang ◽  
...  
Keyword(s):  
Charge Transfer ◽  
Electrochemical Performance ◽  
Solid Electrolyte Interphase ◽  
Specific Capacity ◽  
Charge Transfer Resistance ◽  
Anode Surface ◽  
Transfer Resistance ◽  
Metal Anode ◽  
Primary Battery ◽  
Sei Film

The solid electrolyte interphase (SEI) film plays a significant role in the capacity and storage performance of lithium primary batteries. The electrolyte additives are essential in controlling the morphology, composition and structure of the SEI film. Herein, fluoroethylene carbonate (FEC) is chosen as the additive, its effects on the lithium primary battery performance are investigated, and the relevant formation mechanism of SEI film is analyzed. By comparing the electrochemical performance of the Li/AlF3 primary batteries and the microstructure of the Li anode surface under different conditions, the evolution model of the SEI film is established. The FEC additive can decrease the electrolyte decomposition and protect the lithium metal anode effectively. When an optimal 5% FEC is added, the discharge specific capacity of the Li/AlF3 primary battery is 212.8 mAh g−1, and the discharge specific capacities are respectively 205.7 and 122.3 mAh g−1 after storage for 7 days at room temperature and 55 °C. Compared to primary electrolytes, the charge transfer resistance of the Li/AlF3 batteries with FEC additive decreases, indicating that FEC is a promising electrolyte additive to effectively improve the SEI film, increase discharge-specific capacities and promote charge transfer of the lithium primary batteries.

Sign in / Sign up

Export Citation Format

Share Document