Detection of Cadmium in Navel Orange by Laser Induced Breakdown Spectroscopy Combined with Moving Window Partial Least Square

2017 ◽  
Vol 54 (8) ◽  
pp. 083002 ◽  
Author(s):  
杨晖 Yang Hui ◽  
黄林 Huang Lin ◽  
刘木华 Liu Muhua ◽  
陈添兵 Chen Tianbing ◽  
饶刚福 Rao Gangfu ◽  
...  
2020 ◽  
Vol 10 (7) ◽  
pp. 2617 ◽  
Author(s):  
Shan Lu ◽  
Xinwei Wang ◽  
Tianzheng Wang ◽  
Xinran Qin ◽  
Xilin Wang ◽  
...  

The composition of contamination deposited on transmission line insulators can affect their surface flashover voltage. Currently, there is no rapid on-line method to detect this contamination composition in power grids. In this paper, we applied laser-induced breakdown spectroscopy (LIBS) to analyze contamination on insulator surfaces. Usually, Na and Ca salts are found in contamination along with various sulfate, carbonate, and chloride compounds. As an element’s detection method, LIBS can only measure a certain element content, for example, Ca. The mixture of various compounds with the same cations can influence the LIBS signal. The influence of mixing ratios on the calibration curves and relative spectral intensity was studied via LIBS. Na2CO3, NaHCO3, CaSO4, and CaCO3 samples containing different proportions of Na and Ca were prepared. The linear correlation coefficients (R2) for the Na and Ca calibration curves generated using various mixing ratios were analyzed. The results showed that the mixture ratio did not dramatically affect the linear calibration curves for mixtures containing the same cations. This finding may significantly reduce the difficulty of applying LIBS analysis for complex contamination on insulators. The laser energy density had effects on the spectral characteristics of the measured elements. The partial least-square regression (PLSR) model can improve the accuracy of Na and Ca prediction.


Sensors ◽  
2019 ◽  
Vol 19 (19) ◽  
pp. 4225 ◽  
Author(s):  
Hao Zhang ◽  
Shun Wang ◽  
Dongxian Li ◽  
Yanyan Zhang ◽  
Jiandong Hu ◽  
...  

Edible gelatin has been widely used as a food additive in the food industry, and illegal adulteration with industrial gelatin will cause serious harm to human health. The present work used laser-induced breakdown spectroscopy (LIBS) coupled with the partial least square–support vector machine (PLS-SVM) method for the fast and accurate estimation of edible gelatin adulteration. Gelatin samples with 11 different adulteration ratios were prepared by mixing pure edible gelatin with industrial gelatin, and the LIBS spectra were recorded to analyze their elemental composition differences. The PLS, SVM, and PLS-SVM models were separately built for the prediction of gelatin adulteration ratios, and the hybrid PLS-SVM model yielded a better performance than only the PLS and SVM models. Besides, four different variable selection methods, including competitive adaptive reweighted sampling (CARS), Monte Carlo uninformative variable elimination (MC-UVE), random frog (RF), and principal component analysis (PCA), were adopted to combine with the SVM model for comparative study; the results further demonstrated that the PLS-SVM model was superior to the other SVM models. This study reveals that the hybrid PLS-SVM model, with the advantages of low computational time and high prediction accuracy, can be employed as a preferred method for the accurate estimation of edible gelatin adulteration.


Author(s):  
Gonca Bilge ◽  
Kemal Efe Eseller ◽  
Halil Berberoglu ◽  
Banu Sezer ◽  
Ugur Tamer ◽  
...  

AbstractLaser induced breakdown spectroscopy (LIBS) is a rapid optical spectroscopy technique for elemental determination, which has been used for quantitative analysis in many fields. However, the calibration involving atomic emission intensity and sample concentration, is still a challenge due to physical-chemical matrix effect of samples and fluctuations of experimental parameters. To overcome these problems, various chemometric data analysis techniques have been combined with LIBS technique. In this study, LIBS was used to show its potential as a routine analysis for Na measurements in bakery products. A series of standard bread samples containing various concentrations of NaCl (0.025%–3.5%) was prepared to compare different calibration techniques. Standard calibration curve (SCC), artificial neural network (ANN) and partial least square (PLS) techniques were used as calibration strategies. Among them, PLS was found to be more efficient for predicting the Na concentrations in bakery products with an increase in coefficient of determination value from 0.961 to 0.999 for standard bread samples and from 0.788 to 0.943 for commercial products.


2018 ◽  
Vol 72 (7) ◽  
pp. 1047-1056 ◽  
Author(s):  
Jun-Ho Yang ◽  
Jack J Yoh

A novel technique is reported for separating overlapping latent fingerprints using chemometric approaches that combine laser-induced breakdown spectroscopy (LIBS) and multivariate analysis. The LIBS technique provides the capability of real time analysis and high frequency scanning as well as the data regarding the chemical composition of overlapping latent fingerprints. These spectra offer valuable information for the classification and reconstruction of overlapping latent fingerprints by implementing appropriate statistical multivariate analysis. The current study employs principal component analysis and partial least square methods for the classification of latent fingerprints from the LIBS spectra. This technique was successfully demonstrated through a classification study of four distinct latent fingerprints using classification methods such as soft independent modeling of class analogy (SIMCA) and partial least squares discriminant analysis (PLS-DA). The novel method yielded an accuracy of more than 85% and was proven to be sufficiently robust. Furthermore, through laser scanning analysis at a spatial interval of 125 µm, the overlapping fingerprints were reconstructed as separate two-dimensional forms.


Sign in / Sign up

Export Citation Format

Share Document