Amplitude Versus Offset for Refracted Waves

Author(s):  
P. Borejko ◽  
E. Brückl ◽  
W. Chwatal
Geophysics ◽  
1992 ◽  
Vol 57 (4) ◽  
pp. 543-553 ◽  
Author(s):  
Christopher P. Ross

Amplitude versus offset (AVO) measurements for deep hydrocarbon‐bearing sands can be compromised when made in close proximity to a shallow salt piercement structure. Anomalous responses are observed, particularly on low acoustic impedance bright spots. CMP data from key seismic profiles traversing the bright spots do not show the expected Class 3 offset responses. On these CMPs, significant decrease of far trace energy is observed. CMP data from other seismic profiles off‐structure do exhibit the Class 3 offset responses, implying that structural complications may be interfering with the offset response. A synthetic AVO gather was generated using well log data, which supports the off‐structure Class 3 responses, further reinforcing the concept of structurally‐biased AVO responses. Acoustic, pseudo‐spectral modeling of the structure substantiates the misleading AVO response. Pseudo‐spectral modeling results suggest that signal degradation observed on the far offsets is caused by wavefield refraction—a shadow zone, where the known hydrocarbon‐bearing sands are not completely illuminated. Such shadow zones obscure the correct AVO response, which may have bearing on exploration and development.


2008 ◽  
Author(s):  
Wayne Pennington ◽  
Mohamed Ibrahim ◽  
Roger Turpening ◽  
Sean Trisch ◽  
Josh Richardson ◽  
...  

2018 ◽  
Vol 2018 ◽  
pp. 1-11
Author(s):  
Vladimir Sabinin

Some new computational techniques are suggested for estimating symmetry axis azimuth of fractures in the viscoelastic anisotropic target layer in the framework of QVOA analysis (Quality factor Versus Offset and Azimuth). The different QVOA techniques are compared using synthetic viscoelastic surface reflected data with and without noise. I calculated errors for these techniques which depend on different sets of azimuths and intervals of offsets. Superiority of the high-order “enhanced general” and “cubic” techniques is shown. The high-quality QVOA techniques are compared with one of the high-quality AVOA techniques (Amplitude Versus Offset and Azimuth) in the synthetic data with noise and attenuation. Results are comparable.


Geophysics ◽  
2021 ◽  
pp. 1-35
Author(s):  
M. Javad Khoshnavaz

Building an accurate velocity model plays a vital role in routine seismic imaging workflows. Normal-moveout-based seismic velocity analysis is a popular method to make the velocity models. However, traditional velocity analysis methodologies are not generally capable of handling amplitude variations across moveout curves, specifically polarity reversals caused by amplitude-versus-offset anomalies. I present a normal-moveout-based velocity analysis approach that circumvents this shortcoming by modifying the conventional semblance function to include polarity and amplitude correction terms computed using correlation coefficients of seismic traces in the velocity analysis scanning window with a reference trace. Thus, the proposed workflow is suitable for any class of amplitude-versus-offset effects. The approach is demonstrated to four synthetic data examples of different conditions and a field data consisting a common-midpoint gather. Lateral resolution enhancement using the proposed workflow is evaluated by comparison between the results from the workflow and the results obtained by the application of conventional semblance and three semblance-based velocity analysis algorithms developed to circumvent the challenges associated with amplitude variations across moveout curves, caused by seismic attenuation and class II amplitude-versus-offset anomalies. According to the obtained results, the proposed workflow is superior to all the presented workflows in handling such anomalies.


2017 ◽  
Author(s):  
Xin Zhan ◽  
Dez Chu ◽  
Brent Wheelock ◽  
David Johnston ◽  
Kaushik Bandyopadhyay ◽  
...  

Geophysics ◽  
2000 ◽  
Vol 65 (2) ◽  
pp. 377-389 ◽  
Author(s):  
Paul J. Hatchell

Transmission distortions are observed on prestack seismic data at two locations in the Gulf of Mexico. These distortions produce anomalous amplitude versus offset (AVO) signatures. The locations of the distortion zones are determined using acquisition geometry and ray tracing. No obvious reflection events, such as shallow gas zones, are observed at the predicted locations of the distortion zones. Instead, the distortion zones correlate with buried faults and unconformities. It is postulated that the distortions are produced by velocity changes across buried faults and unconformities. The distortions result from an interference pattern resulting from seismic waves arriving from different sides of the faults. A simple model is developed to explain many of the characteristics of the distortion pattern.


2007 ◽  
Vol 47 (1) ◽  
pp. 163 ◽  
Author(s):  
P. E. Williamson ◽  
F. Kroh

Amplitude versus offset (AVO) technology has proved itself useful in petroleum exploration in various parts of the world, particularly for gas exploration. To determine if modern AVO compliant processing could identify potential anomalies for exploration of open acreage offshore Australia, Geoscience Australia reprocessed parts of four publicly available long cable lines. These lines cover two 2006 acreage release areas on the Exmouth Plateau and in the Browse Basin on the North West Shelf. An earlier study has also been done on two publicly available long cable lines from Geoscience Australia’s Bremer Basin study and cover areas from the 2005 frontier acreage release on the southern margin. The preliminary results from these three reprocessing efforts produced AVO anomalies and were made publicly available to assist companies interested in assessing the acreage. The results of the studies and associated data are available from Geoscience Australia at the cost of transfer.The AVO data from the Exmouth Plateau show AVO anomalies including one that appears to be at the Jurassic level of the reservoir in the Jansz/Io supergiant gas field in adjacent acreage to the north. The AVO data from the Caswell Sub-basin of the Browse Basin show an AVO anomaly at or near the stratigraphic zone of the Brecknock South–1 gas discovery to the north. The geological settings of strata possibly relating to two AVO anomalies in the undrilled Bremer Basin are in the Early Cretaceous section, where lacustrine sandstones are known to occur. The AVO anomalies from the three studies are kilometres in length along the seismic lines.These preliminary results from Geoscience Australiaand other AVO work that has been carried out by industry show promise that AVO compliant processing has value—particularly for gas exploration offshore Australia—and that publicly available long-cable data can be suitable for AVO analysis.


Sign in / Sign up

Export Citation Format

Share Document