Wind Field Numerical Simulation of Long-Span Bridge

2013 ◽  
Vol 361-363 ◽  
pp. 1094-1100
Author(s):  
Jian Guo ◽  
Wei Chang Gan ◽  
Ding Yu Jiang ◽  
Bing Nan Sun ◽  
Wei Peng
Keyword(s):  
Numerical Simulation ◽  
Wind Field ◽  
Simulation Method ◽  
Filter Method ◽  
Linear Filter ◽  
Wind Field Simulation ◽  
Long Span ◽  
Long Span Bridge ◽  
Target Spectrum ◽  
Main Girder

In the research on calculation of interaction of wind and structure, the key to the question is wind field numerical simulation. This paper introduces a practical wind field simulation method of long-span Bridge. The main bridge of Jintang Bridge was analyzed as engineering example, which is a cross-sea cable stayed bridge in Zhoushan of Zhejiang Province , and the linear filter method was applied to calculate along-wind and vertical wind field on main girder, MATLAB program also was adopted to simulate wind field of long-span Bridge. The results show that simulated spectrum is in better agreement with the target spectrum, which verifies validity of the method and correctness of the program.

scholarly journals Numerical Simulation of Characteristics of Wind Field at Bridge Sites in Flat and Gorge Terrains under the Thunderstorm Downburst

2021 ◽  
Vol 2021 ◽  
pp. 1-15
Author(s):  
Peng Hu ◽  
Yilin Chen ◽  
Yan Han ◽  
Fei Zhang ◽  
Yongjian Tang
Keyword(s):  
Numerical Simulation ◽  
Wind Field ◽  
Wind Fields ◽  
Monitoring Point ◽  
Wind Speeds ◽  
Flat Terrain ◽  
Long Span ◽  
Long Span Bridge ◽  
Bridge Girder ◽  
Large Wind

To investigate the effects of thunderstorm downburst on the characteristics of wind field at bridge sites in flat and gorge terrains, firstly, numerical simulation of wind fields in the flat terrain under the thunderstorm downburst was conducted through the SST k-ω turbulence model, combined with the impinging jet technology. After verification of the reliability of the numerical model, settings, and methods, the characteristics of wind field over a long-span bridge site in a gorge terrain under the thunderstorm downburst were investigated and the distributions of wind speed and wind attack angle in the flat and gorge terrains were compared. The results show that, under the effects of the thunderstorm downburst, the wind speeds are relatively maximum at the midspan point of the girder in the flat terrain. Besides, the farther away from the midspan point, the smaller the wind speeds, which is opposite to the case in the gorge terrain. The wind speeds at each typical monitoring point are basically the same in the two terrains, before the thunderstorm downburst hits the bridge girder. Later the wind speeds at each point in the gorge terrain are much higher than those in the flat terrain. Most wind attack angles are negative at the monitoring points in the flat terrain, but the farther away they are from the midspan point, the greater the wind attack angles will be. However, the wind attack angles at the monitoring points in the gorge terrain are generally larger than those in the flat terrain, and they gradually turn to be positive farther away from the midspan point. In the flat terrain, both wind speeds and wind attack angles (or their absolute values) at the girder are large within about t = 75∼130 s, indicating that the thunderstorm downburst may exert significant effects on the bridge. However, in the gorge terrain, due to the large wind speeds and wind attack angles (or their absolute values) at the girder after t = 75 s, full attention needs to be paid to the effects of the thunderstorm downburst during this period.

scholarly journals The Icing Distribution Characteristics Research of Tower Cross Beam of Long-Span Bridge by Numerical Simulation

Energies ◽  
2021 ◽  
Vol 14 (17) ◽  
pp. 5584
Author(s):  
Zhi-Yong Yang ◽  
Xiang Zhan ◽  
Xin-Long Zhou ◽  
Heng-Lin Xiao ◽  
Yao-Yao Pei
Keyword(s):  
Numerical Simulation ◽  
Simulation Method ◽  
Distribution Characteristics ◽  
Ice Melting ◽  
Long Span ◽  
Numerical Simulation Method ◽  
Long Span Bridge ◽  
Ice Accretions ◽  
The Cross ◽  
Windward Surface

The cross beam of a long-span bridge will freeze in low temperature. When the temperature rises, the ice on the cross beam will thaw and fall off. If the ice is too heavy, it may cause vehicle damage and casualty. In order to reduce the risk of falling ice, a scale model of the cross beam was taken as an example, and a kind of numerical simulation method is presented to study the icing distribution characteristics on surface of the cross beam. This paper simulates the ice accretions process of the cross beam by Fluent module and FENSAP-ICE module of ANSYS and investigates the influence of wind and temperature in the process. This is a new numerical simulation method for studying ice accretions of buildings. The results indicate that water freezes mainly on the windward surface, and the thicker ice is near the top and bottom edge of windward surface. According to the results of numerical simulation, a measure of ice melting based on electric heating method is proposed in this paper, and the feasibility and effectiveness of this method are verified by numerical simulation. The results show that the icing distribution characteristics are accord with the fact and the ice-melting measure is feasible and effective.

Three-Dimensional Wind Field Simulation on the Two Typical Roofs of the Building

2014 ◽  
Vol 986-987 ◽  
pp. 685-688
Author(s):  
Shu Qin Liu ◽  
Zhong Guo Bian ◽  
Yuan Bo Cai ◽  
Fang Zhao
Keyword(s):  
Numerical Simulation ◽  
Theoretical Analysis ◽  
Wind Energy ◽  
Wind Field ◽  
Three Dimensional ◽  
Simulation Method ◽  
Energy Utilization ◽  
Wind Field Simulation ◽  
Field Simulation ◽  
Important Significance

Wind energy utilization in the building environment has the advantage that it can avoid transporting effectively, especially it has important significance for residents without electricity. This paper mainly analyzed the basic situation of three-dimensional wind field around the buildings with the theoretical analysis and CFD numerical simulation method. By simulating the wind with different directions and different speeds, the characteristics of the wind field around single flat and pitched roof building are analyzed.

Multiscale simulation of wind field on a long-span bridge site in mountainous area

2018 ◽  
Vol 177 ◽  
pp. 260-274 ◽  
Author(s):  
Yan Han ◽  
Lian Shen ◽  
Guoji Xu ◽  
C.S. Cai ◽  
Peng Hu ◽  
...  
Keyword(s):  
Wind Field ◽  
Multiscale Simulation ◽  
Mountainous Area ◽  
Bridge Site ◽  
Long Span ◽  
Long Span Bridge

Numerical Simulation of Wind-Driven Rain on a Long-Span Bridge

2019 ◽  
Vol 19 (12) ◽  
pp. 1950149
Author(s):  
Shenghong Huang ◽  
Qiusheng Li ◽  
Man Liu ◽  
Fubin Chen ◽  
Shun Liu
Keyword(s):  
Numerical Simulation ◽  
Wind Engineering ◽  
Multiphase Model ◽  
Rain Intensity ◽  
Long Span Bridges ◽  
Long Span ◽  
Long Span Bridge ◽  
Extreme Rain ◽  
Section Model ◽  
Bridge Spans

Wind-driven rain (WDR) and its interactions with structures is an important research subject in wind engineering. As bridge spans are becoming longer and longer, the effects of WDR on long-span bridges should be well understood. Therefore, this paper presents a comprehensive numerical simulation study of WDR on a full-scale long-span bridge under extreme conditions. A validation study shows that the predictions of WDR on a bridge section model agree with experimental results, validating the applicability of the WDR simulation approach based on the Eulerian multiphase model. Furthermore, a detailed numerical simulation of WDR on a long-span bridge, North Bridge of Xiazhang Cross-sea Bridge is conducted. The simulation results indicate that although the loads induced by raindrops on the bridge surfaces are very small as compared to the wind loads, extreme rain intensity may occur on some windward surfaces of the bridge. The adopted numerical methods and rain loading models are validated to be an effective tool for WDR simulation for bridges and the results presented in this paper provide useful information for the water-erosion proof design of future long-span bridges.

Simulation Method for 3-D Wind Field over Complex Terrain with Asymmetrical Mountains

2013 ◽  
Vol 444-445 ◽  
pp. 549-554
Author(s):  
Huan Ran Hu ◽  
Guan Xin Hong
Keyword(s):  
Fluid Dynamics ◽  
Numerical Simulation ◽  
Turbulence Intensity ◽  
Potential Flow ◽  
Wind Field ◽  
Complex Terrain ◽  
Simulation Method ◽  
Engineering Practice ◽  
Characteristics Analysis ◽  
Flow Theories

It is important for the research of flight characteristics to master the distribution of wind field and the character of turbulence intensity in a complex-terrain mountain. Based on the potential flow theories in fluid dynamics, a numerical simulation method of complex terrain including asymmetrical and symmetrical mountains has been developed in this paper. In particular, asymmetrical mountains are simulated by the combination of two transformed quarter-semiellipsoids. Furthermore, mountain-induced airflow is calculated based on potential flow theory, which could reflect the characteristic of wind field. As an example, the wind field near Dingling airport in Beijing has been simulated and analyzed by this method. The results demonstrate that this method is suitable and accurate for engineering practice, and also applicable for flight dynamics characteristics analysis of aircrafts.

Transient Simulation of a Three-Dimensional Moving Downburst

2012 ◽  
Vol 446-449 ◽  
pp. 3875-3878
Author(s):  
Bai Feng Ji ◽  
Wei Lian Qu
Keyword(s):  
Fluid Dynamics ◽  
Numerical Simulation ◽  
Computational Fluid Dynamics ◽  
Wind Field ◽  
Three Dimensional ◽  
Simulation Method ◽  
Transient Simulation ◽  
Dynamics Simulation ◽  
Transmission Tower ◽  
Transient Wind

Thunderstorm microbursts, which are sources of extreme wind loadings in nature, have caused numerous structural failures, especially collapses of transmission tower around the world. Numerical simulation using computational fluid dynamics (CFD) has recently made significant progress in simulating downbursts. In this paper, transient simulation of a three-dimensional moving downburst was studied using computational fluid dynamics simulation method. Transient simulation of a three-dimensional moving downburst was conducted using time-filtered Reynolds Averaged Navier-Stokes (RANS) numerical simulation method. The three-dimensional transient wind field characteristics in a moving downburst were studied in detail. The results indicate that transient wind field characteristics in a moving downburst present quite different characteristics compared with stationary downburst at different heights and radial positions.

Sign in / Sign up

Export Citation Format

Share Document