Design and Properties of Fire-Proof Coating for Tunnels

2007 ◽  
Vol 336-338 ◽  
pp. 1753-1755
Author(s):  
Ya Dong Yao ◽  
Guang Fu Yin ◽  
Xiao Wei Cheng ◽  
Xiang Li Gou

Silicate fireproof coatings for tunnels (FCT) have many eminent properties. But low adhesion strength and poor water/fire-resistance of this kind of materials largely limit its applications. Here we reported a new kind of FCT based on high alumina cement as principle adhesive, redispersible powder as assisting adhesive, ammonium polyphosphate as fire-retardant material, vermiculite as adiabatic padding, and magnesium hydroxide as assisting reagents. The influence of various experimental conditions on fire resistance, adhesion strength and water resistance were carefully studied. Results showed that dispersible emulsoid powder was a key component affecting adhesion strength and water resistance of FCT, whereas fire-retardant material posed significant effects on the fire resistance.

2021 ◽  
Vol 3 (6 (111)) ◽  
pp. 59-70
Author(s):  
Liubov Vakhitova ◽  
Kostyantyn Kalafat ◽  
Viktoriia Plavan ◽  
Volodymyr Bessarabov ◽  
Nadezhda Тaran ◽  
...  

This paper reports a study into the effect of nanoclays on the water-resistance of the intumescent system ammonium polyphosphate/melamine/pentaerythritol/titanium dioxide/polymer (ethylene vinyl acetate (EVA) or styrene acrylate (SA). It has been established that adding nanoclay to a coating based on ethylene vinyl acetate increases the fire resistance limit of a metal plate by 30 %, and to a coating based on styrene acrylate – by 50 %. At the same time, coatings that include the EVA polymer are characterized by greater fire-retardant efficiency and less water resistance than coatings containing the SA polymer. It has been shown that intumescent coatings, regardless of the nature of the polymer, under the conditions of 80 % humidity over 800 days their reduce fire-protective properties by an average of 10 %. The loss of coating fire resistance occurs due to the leaching of pentaerythritol, ammonium polyphosphate, and polymer degradation by hydrolysis. The admixtures of nanoclays with a high degree of exfoliation to the studied system create a barrier effect and maximize the chemical formulation of the intumescent coating. The fireproof properties of coatings with organically-modified montmorillonite admixtures are maintained or reduced to 5 % under the conditions of 80 % humidity over 800 days. It has been determined that the direct effect of water on the coating over a period of more than 2 days leads to a significant decrease in the swelling coefficient of intumescent coatings, regardless of the content of a nanoclay admixture in their composition. At the same time, the half-decay period of coatings without nanoclay, calculated on the basis of solubility constant in water, is 0.5 days. For coatings, which include the admixtures of organically-modified nanoclays, the half-decay period increases to 2 days. The results reported in this paper could be recommended for designing water-proof fire-resistant reactive-type nano-coatings with prolonged service life.


1975 ◽  
Vol 27 (91) ◽  
pp. 59-77 ◽  
Author(s):  
H. G. Midgley ◽  
Ann Midgley

Refractories ◽  
1984 ◽  
Vol 25 (5-6) ◽  
pp. 293-296 ◽  
Author(s):  
I. N. Sorokin ◽  
T. M. Golovina ◽  
D. S. Rutman ◽  
A. D. Popov ◽  
V. M. Ust'yantsev ◽  
...  

2021 ◽  
Author(s):  
Dana Koňáková ◽  
Eva Vejmelková ◽  
Vojtěch Pommer ◽  
Martin Keppert ◽  
Anton Trník ◽  
...  

Clay Minerals ◽  
1984 ◽  
Vol 19 (5) ◽  
pp. 857-864 ◽  
Author(s):  
H. G. Midgley

AbstractHydrating high-alumina cement will react with calcium carbonate to form the complex mineral calcium carboaluminate hydrate, 3CaO.Al2O3.CaCO3.12H2O. This mineral is reported to be capable of providing strength in concrete and so may provide an alternative to the minerals normally found in the hydration of high-alumina cement, which may under certain conditions convert to other minerals with a loss in strength. Some doubt has been cast on the stability of calcium carboaluminate hydrate and it has been found that in hydrated high-alumina cement, calcium carboaluminate hydrate decomposes at temperatures in excess of 60°C. Cube compressive strength tests on high-alumina cement and high-alumina cement-calcium carbonate pastes have shown that the latter have a lower strength than pastes made with high-alumina cement alone. When cured at 50°C the high-alumina cement-calcium carbonate pastes show a loss in strength with curing time. Cements made with the high-alumina cement-calcium carbonate mixture always have a lower strength than those made with high-alumina cement alone and so no advantage is gained from their use.


Refractories ◽  
1985 ◽  
Vol 26 (1-2) ◽  
pp. 92-93
Author(s):  
A. N. Sokolov ◽  
R. M. Shumeiko ◽  
L. M. Myznikova ◽  
P. D. Orekhov ◽  
L. A. Krasnitskaya

Sign in / Sign up

Export Citation Format

Share Document