SiC vs. Si - Evaluation of Potentials for Performance Improvement of Power Electronics Converter Systems by SiC Power Semiconductors

2010 ◽  
Vol 645-648 ◽  
pp. 1101-1106 ◽  
Author(s):  
Jürgen Biela ◽  
Mario Schweizer ◽  
Stefan Waffler ◽  
Benjamin Wrzecionko ◽  
Johann Walter Kolar

Switching devices based on wide band gap materials as SiC oer a signicant perfor- mance improvement on the switch level compared to Si devices. A well known example are SiC diodes employed e.g. in PFC converters. In this paper, the impact on the system level perfor- mance, i.e. eciency/power density, of a PFC and of a DC-DC converter resulting with the new SiC devices is evaluated based on analytical optimisation procedures and prototype systems. There, normally-on JFETs by SiCED and normally-off JFETs by SemiSouth are considered.

2020 ◽  
Vol 10 (1) ◽  
pp. 213-218
Author(s):  
Daniel W. Cunningham ◽  
Eric P. Carlson ◽  
Joseph S. Manser ◽  
Isik C. Kizilyalli

Automatika ◽  
2012 ◽  
Vol 53 (2) ◽  
pp. 107-116 ◽  
Author(s):  
José Millán ◽  
Philippe Godignon ◽  
Amador Pérez-Tomás

2018 ◽  
Vol 29 (17) ◽  
pp. 15223-15232 ◽  
Author(s):  
Seungjun Noh ◽  
Chanyang Choe ◽  
Chuantong Chen ◽  
Hao Zhang ◽  
Katsuaki Suganuma

Machines ◽  
2021 ◽  
Vol 9 (12) ◽  
pp. 350
Author(s):  
Niklas Langmaack ◽  
Florian Lippold ◽  
Daiyi Hu ◽  
Regine Mallwitz

Within the project ‘ARIEL’ an electrical turbo compressor unit for fuel cell applications is deeply investigated. The necessary drive inverter is especially designed for high fundamental frequency and high switching frequency to cope with the requirements of the implemented electrical machine. This paper presents investigations on the inverter’s efficiency and its prospective lifetime at different stages of the development. In the design process different wide band gap power semiconductor devices in discrete packages are evaluated in terms of the achievable power density and efficiency, both by simulations and measurements. Finally, an optimised design using surface mount silicon carbide MOSFETs is developed. Compared to a former inverter design using silicon devices in a three-level topology, the power density of the inverter is significantly increased. The lifetime of power electronic systems is often limited by the lifetime of the power semiconductor devices. Based on loss calculations and the resulting temperature swing of the virtual junction the lifetime of the inverter is estimated for the most frequent operating points and for different mission profiles.


Sign in / Sign up

Export Citation Format

Share Document